Question is ⇒ The advantages of high density IC are, Options are ⇒ (A) more circuits on chip, (B) high operating speed, (C) low power consumption, (D) both (a) and (b), (E) , Leave your comments or Download question paper.

Question is ⇒ The advantages of high density IC are, Options are ⇒ (A) more circuits on chip, (B) high operating speed, (C) low power consumption, (D) both (a) and (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The advantages of high density IC are
A.	more circuits on chip [Wrong Answer]
B.	high operating speed [Wrong Answer]
C.	low power consumption [Wrong Answer]
D.	both (a) and (b) [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The maximum concentration of the element which can be dissolved in solid silicon at a given temperature is termed as
Solid solubility
Dissolution coefficient
Solidification index
Concentration index

⇒ While using Maxwell bridge, the Q factor of a coil is obtained as
1/ωCR
ωCR
ωC/R
R/ωC

⇒ Which one of the following can be used for amplification of microwave energy?
TWT
Magnetron
Reflex klystron
Gunn diode

⇒ The log magnitude curve for a constant gain K is a horizontal straight line at a magnitude 20 log K dB.
TRUE
FALSE

⇒ On modulating a carrier of frequency f_c by an audio signal f_s, the following components has result
Amplitude modulation (DSB)
Single sideband modulation
Frequency modulation only
Amplitude modulation or frequency modulation

⇒ M = (μ_r - 1)H.
TRUE
FALSE

⇒

Assertion (A): Silicon is the most favoured semiconductor material.

Reason (R): PIV for silicon diode is more than that for germanium diode.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ A single turn loop is situated in air, with a uniform magnetic field normal to its plane. The area of the loop is 5 m² and the rate of change of flux density is 2 Wb/m²/s. What is the emf appearing at the terminals of the loop?
-5 V
-2 V
-0.4 V
0 V

⇒ The noise sources shot noise, partition noise and thermal noise are associated with which component
BJT
diode
resistor
capacitor

⇒ Which of the following is not a valid arithmetic statement in C?
x = x + 1
x = y ^* z
x ^* y = z
z = y / x

⇒

Match the following:

	List I (DOS commands)		List II (Meaning)
A.	DBLSPACE	1.	Deletes a director and its sub-directories
B.	MEM	2.	Displays the amount of used and free memory
C.	SYS	3.	Put a copy of DOS on disk
D.	DELTREE	4.	Compresses files to increase the storage capacity of disc

A-4, B-3, C-2, D-1
A-2, B-3, C-4, D-1
A-4, B-2, C-3, D-1
A-1, B-2, C-3, D-4

⇒ In a radio receiver, if the intermediate frequency is too high
Selectivity will be poor
Tracking difficulties will be least
Adjacent channel rejection will improve
All of the above will occur

⇒ LVDT is used to measure
displacement
pressure
temperature
any of the above

⇒ Consider the following mnemonics

MOV
ADD
LXI

Which of the above are valid for 8085?
1 and 2 only
1 only
1, 2 and 3
1 and 3 only

⇒ For 200V r.m.s. value triangular wave, the peak voltage will be
200 V
222 V
280 V
346 V

⇒ A flip flop is a
combinational circuit
memory element
arithmetic element
memory or arithmetic element

⇒ The O/P char, of a FET is given in the figure. In which region is the device biased for small signal amplificat
AB
BC
CD
BD

⇒ The sum of positive real function is positive real.
TRUE
FALSE

⇒ In the signal flow graph of figure below, the gain C/R will
43048
22/15
24/23
44/23

⇒ A Hartley oscillator uses
a tapped inductor
a tapped capacitor
both (a) and (b)
neither (a) nor (b)

⇒ End fire coupler is formed
when two equal radiators are operated in phase quadrature at a distance of λ/4 apart
when two equal radiators are operated in parallel at a distance of λ/4 apart
when two equal radiators are operated in phase quadrature at a distance of λ/2 apart
none of the above

⇒ In figure what is value of I_C if β_dc = 100. Neglect V_{BE5 mA
5 μA
10 mA
10 μA}

⇒ The circuits with active pull up are preferred because of their stability for
wired - AND operation
wired - OR operation
bus operated system
reasonable dissipation and speed of operation

⇒ The mechanical system shown below has its pole(s)
- K/D
- D/K
- DK
0, - K/D

⇒ What happens when a paramagnetic material is heated above Curie temperature?
It becomes diamagnetic
It becomes nonmagnetic
It becomes ferromagnetic
It becomes anti-ferromagnetic

⇒ In 8085 microprocessor, when TRAP interrupt is triggered program control is transferred to location
0020 H
0024 H
0028 H
002 CH

⇒ For a particular type of memory the access time and cycle time are 200 ns each. The maximum rate at which data can be accessed by
2.5 x 10⁶/s
5 x 10⁶/s
0.2 x l0⁶/s
10⁶/s

⇒ The HV supply to a TV receiver is 25 kV and the total beam current for the three electron guns is 2000 μA. The power handled by IHVT is
5W
0.5 W
50 W
500 W

⇒ An FM signal with deviation δ is passed through mixer. Its frequency is reduced five fold. The deviation in output of mixer is
0.28
δ
5 δ
very very high

⇒ What is the effect of cut in voltage on the wave form of output as compared to input in a semiconductor diode?
The duration of output waveform is less than 180°
Output voltage is less than input voltage
Output voltage is more than input voltage
Both (a) and (b)