Question is ⇒ The advantage of moving coil permanent magnet type insfrument is, Options are ⇒ (A) no hysteresis loss, (B) low power consumption, (C) efficient eddy current damping, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The advantage of moving coil permanent magnet type insfrument is, Options are ⇒ (A) no hysteresis loss, (B) low power consumption, (C) efficient eddy current damping, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The advantage of moving coil permanent magnet type insfrument is
A.	no hysteresis loss [Wrong Answer]
B.	low power consumption [Wrong Answer]
C.	efficient eddy current damping [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 15 -5 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An induction wattmeter can be used for
both D.C. and A.C.
D.C. only
A.C. only
any of the above

⇒ Vibrating reeds are used in which of the following instruments ?
Power factor meter
Frequency meter
Wattmeter
Synchronoscope

⇒ Sensitivity of a voltmeter is given by the
ohms per volt
reciprocal of full scale deflection current
both (a) and (b)
none of the above

⇒ In a portable instrument, the controlling torque is provided by
spring
gravity
eddy currents
all of the above

⇒ The instrument used for the measurement of power at 500 MHz is
compensated wattmeter
electrodynamometer wattmeter
bolometer
none of the above

⇒ In optical pyrometer temperature is measured by
photocell principle
thermocouple effect
comparing the brightness of the source with the brightness of a standard source
none of the above

⇒ The readings of a dynamometer type wattmeter can be highly erratic at
low frequencies
fluctuating loads
low power factors
high voltages

⇒ Moving coil and moving iron type instruments can be distinguished by looking at
scale
their range
pointer
size of terminals

⇒ The output of LVDT is in the form of
pulses
high frequency signals
rotary movement of core
linear displacement of core

⇒ Moving iron instruments are rarely used in low power high resistance circuits because of
high resistance of the coil
low reluctance of magnetic path
high reluctance of magnetic path
none of the above

⇒ High voltage tests are
high frequency tests
constant direct current tests
sustained low frequency tests
surge tests

⇒ Commonly used instruments in power system measurement are
induction
moving coil or iron
rectifier
electrostatic

⇒ A ____ is used to measure frequency in wave guides.
galiometer
klystron.
bolometer
cavity resonator

⇒ Which of the following devices should be used for accurate measurement of low D.C. voltage ?
Small range moving coil voltmeter
D.C. potentiometer
Small range thermocouple voltmeter
None of the above

⇒ The temperature of a furnace can be measured by
bimetallic thermometer
mercury thermoineter
clinical thermometer
optical pyrometer

⇒ In hot wire instruments the sensing wire is made of
copper-nickel
silver
copper
platinum-iridium

⇒ Which of the following is the pH value of pure water ?
Infinity
50
20
7

⇒ The input impedance of a C.R.O. is
zero
around 100 ohms
around 1000 ohms
around one mega-ohm

⇒ Aluminium is selected as the material for rotating disc of energy meter because
it is good conductor
it is light
it is indigenously available
all of the above reasons

⇒ Operating torques in analogue instruments are
deflecting and control
deflecting and damping
deflecting, control and damping
vibration and balancing

⇒ ____ type instrument has identical calibration for A.C. as well as D.C. values ?
Hot wire
Moving coil
Induction
Moving iron

⇒ The pressure coil of a wattmeter should be connected on the supply side of the current coil when
load impedance is high
load impedance is low
supply voltage is low
none of the above

⇒ The sensitivity inaccuracy of an instrument does not depend on
frequency response
hysteresis
amplitude distortion
all of the above

⇒ Rosette gauges are used to
amplify strain values
measure variable strain
compensate for temperature variations
measure strain in more than one direction

⇒ For handling greater currents induction wattmeters are used in conjunction with
potential transformers
current transformers
power transformers
either of the above

⇒ A power factor meter has _____ control springs.
one
two
four
no

⇒ Phosphor coating for cathode ray tubes is provided on
inside surfaces only
outside surfaces only
both the surfaces
within the glass

⇒ A potentiometer may be used for
measurement of resistance
measurement of current
calibration of ainmeter
calibration of voltmeter

⇒ Commonly used standard capacitor is
spherical type
concentric cylindrical type
electrostatic type
multilayer parallel plate type

⇒ ____ can measure pressure directly ?
Rotameter
Bourden tube
LVDT
Strain gauge