Question is ⇒ The advantage of FET over BJT is, Options are ⇒ (A) high input impedance, (B) lower noise, (C) no thermal runaway, (D) all of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ The advantage of FET over BJT is, Options are ⇒ (A) high input impedance, (B) lower noise, (C) no thermal runaway, (D) all of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The advantage of FET over BJT is
A.	high input impedance [Wrong Answer]
B.	lower noise [Wrong Answer]
C.	no thermal runaway [Wrong Answer]
D.	all of the above [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Figure shows the variation of Z(ω) for a positive real function. The functio
RC impedance
RL impedance
RLC impedance
Reactance function

⇒ The number of digits in octal system is
8
7
9
10

⇒

Assertion (A): In liquids and glassy substances, dielectric losses occur.

Reason (R): The orientation polarization in many substances is frequency dependent.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Nichrome is commonly used for
lamp filaments
transformer winding
heater coils
battery connections

⇒

Assertion (A): To add 8 bit words, two 1C 74181 can be cascaded.

Reason (R): In 1C 74181 a sum greater than 15 leads to high carry out.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ If a = 0.995, I_E = 10 mA, I_CO = 0.5 mA, then I_CEO will be
100 μA
25 μA
10.1 μA
10.5 μA

⇒

Assertion (A): When the phase margin of a control system is improved using a lead network, noise transmission increases.

Reason (R): Phase lead compensation increases bandwidth.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ TE₀₁ mode of propagation of electromagnetic energy
is merely the TE₁₀ mode rotated 90°
is merely the TE₁₀ mode rotated 180°
is the same as TE₁₀ mode
either (b) or (c)

⇒ An open wire transmission line having a characteristic impedance of 600 ohms is terminated by a resistive load of 900 Ω. The standing wave ratio will be
1.5
2.5
3.5
4.5

⇒ Which one of the following power amplifier has the maximum efficiency?
Class A
Class B
Class AB
Class C

⇒ Which of the following plot can be used to show the input volt-ampere characteristics of a common-emitter configuration?
V_BE versus i_B for constant values of V_CE
V_CE versus i_C for constant values of I_B
V_CE versus i_C for constant values of I_E
None of the above

⇒ To turn off an SCR, it is necessary to reduce its current to less than :
trigger current
holding current
breakover current
none of the above

⇒ Which gives minimum probability of error?
ASK
FSK
PSK
DPSK

⇒ In a JFET V_DS exceeds the rated value. Then it operates in
active region
ohmic region
cut off region
either cut off or active region

⇒ If F(t) = δ(t - a), F(s)=
0
1
e^-as
e^as

⇒ When a binary adder is used as BCD adder, the sum is
correct when it is < 9
correct when it is > 9
correct when it is < 16
none of these

⇒ In a CE amplifier the Q point is very close to saturation point on the dc load line. This results in
positive clipping of collector current
negative clipping of collector current
both positive and negative clipping of collector current
either positive or negative clipping of collector current

⇒ Troposphere is the upper part of the Earth's atmosphere which absorbs large quantities of Sun's radiations.
TRUE
FALSE

⇒ Which of the following can be accessed only sequentially?
Floppy disk
Hard disk
Magnetic tape
ROM

⇒ If each stage has a gain of 10 dB and noise figure of 10 dB, then the overall noise figure of a two stage cascade amplifier will be
10
1.09
1
10.9

⇒ A surge voltage
has very high magnitude and very long duration
has very high magnitude and very small duration
has very high magnitude and very small duration and can be positive or negative
can be only positive

⇒ A square current wave of magnitude 1 A is applied to an element for 5 seconds. The voltage across the element rises linearly from 0 to final value linearly. The element is
resistance
inductance
capacitance
R and C in series

⇒

Match the following:

	List I (BJT amplifier)		List II (Characteristics)
A.	CE	1.	good voltage gain, good current gain
B.	CC	2.	voltage gain less than 1, high current gain
C.	CB	3.	current gain less than 1, voltage gain high

A-1, B-2, C-3
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ In a TWT the amplitude of resultant wave travelling down the helix remains constant
TRUE
FALSE

⇒ For transmission-line matching over range of frequencies, it is best to use a
single stub of adjustable position
double stub
broadband directional coupler
balun

⇒ The command ^C in MS WORD
copies the text in clip board
copies the text in secondary storage device
copies the text in file
None of the above

⇒ If the energy gap of a semiconductor is 1.1 eV, then it would be
opaque to visible light
transparent to visible light
transparent to ultraviolet radiation
transparent to infrared radiation

⇒ MTI stands for
Moving Target Indicator
Microprocessor Tracking Index
Multiplexed Telemetry Index
Maximum Transmission Index

⇒ When Schrodinger equation is applied to the motion of electron in the field of protons, the physically acceptable solutions for the wave function exist for quantum number which are
2
3
4
5

⇒

Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.

Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct