Question is ⇒ The address to which a software or hardware restart branches is known as, Options are ⇒ (A) Vector location, (B) SID, (C) SOD, (D) TRAP, (E) , Leave your comments or Download question paper.

Question is ⇒ The address to which a software or hardware restart branches is known as, Options are ⇒ (A) Vector location, (B) SID, (C) SOD, (D) TRAP, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The address to which a software or hardware restart branches is known as
A.	Vector location [Correct Answer]
B.	SID [Wrong Answer]
C.	SOD [Wrong Answer]
D.	TRAP [Wrong Answer]
View Answer 4 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The selectivity curve of a standard receiver is represente
curve A
curve B
curve C
curve D

⇒ The dissipation at the collector is in the quiescent state and increases with excitation in the case of a
class A series fed Amplifier
class A transistor coupled Amplifier
class AB amplifier
class B amplifier

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ In an R-C circuit, the impedance is 40 Ω at a frequency of 100 Hz. At 200 Hz the impedance should be
40 Ω
80 Ω
20 Ω
more than 20 Ω but less than 40 Ω

⇒ To measure moisture in wood, the most suitable method is
electric conduction
electrical-capacitive
absorption of radiation
equilibrium-moisture Vs humidity

⇒ Two wires A and B have the same cross-section area and are made of the same material. R_A = 600 Ω and R_B = 100 Ω. The number of times A is longer than B is
6
2
4
5

⇒ In a CRO which of the following is not a part of electron gun
cathode
grid
accelerating anode
X - Y plates

⇒ Power gain of a multicavity klystron amplifier is
more than 30 dB
causes retardation of all electrons
causes acceleration of some electrons and retardation of others
none of the above

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then I_{EQ1800 μA
180 μA
2000 μA
3000 μA}

⇒ Find the value of K and velocity constant K_v so that the maximum overshoot in the unit step response is 0.2 and the peak time is 1
12.37, 0.175
12.86, 2.175
11.36, 1.175
1.86, 0.175

⇒ The Z parameters Z₁₁ and Z₂₁ for the 2-port network in the fig
Z₁₁ = - 6/₁₁Ω; Z₂₁ = 16/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = 4/₁₁Ω
Z₁₁ = 6/₁₁Ω; Z₂₁ = - 16/₁₁Ω
Z₁₁ = 4/₁₁Ω; Z₂₁ = 4/₁₁Ω

⇒ Which device changes serial data to parallel data?
Counter
Multiplexer
Demultiplexer
Flip flop

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then R_{B200 kΩ
265 kΩ
150 kΩ
100 kΩ}

⇒ The number of bits in ASCII is
12
10
9
7

⇒ His rather casual remarks on politics __________ his lack of seriousness about the subject.
masked
belied
cherish
conserve

⇒ The merging of a hole and an electron is called
recombination
covalent bonding
thermal union
none of the above

⇒ DMA stands for direct memory access.
TRUE
FALSE

⇒ The amplifier used in bootstrap voltage sweep should have a gain of
1
+∞
-1
-∞

⇒ A 3 phase fully controlled converter is a
3 pulse converter
6 pulse converter
2 pulse converter
12 pulse converter

⇒ Two ammeters A and B both 0-10 A have internal resistance of 1 Ω and 0.5 Ω respectively. They are connected in parallel. If total current is 15 A, then
I_A = I_B = 7.5 A
I_A = 5 A, I_B = 10 A
I_A = 10 A, I_B = 5 A
I_A = 9 A, I_B = 6 A

⇒ A half bridge inverter
needs a 3 wire dc supply
may use a two wire or 3 wire dc supply
has higher output voltage if fed from 3 wire dc supply
has higher efficiency if fed from 3 wire dc supply

⇒ To couple a coaxial line to a parallel wire line, it is best to use a
balun
slotted line
quarter wave transformer
directional coupler

⇒ A band elimination constant k filter has series resonant circuit in series arms.
TRUE
FALSE

⇒ For a hollow waveguide, the axial current must necessarily be
combination of conduction and displacement current
conduction current only
time varying conduction current and displacement current
displacement current only

⇒ A push pull amplifier balance out
odd harmonics
even harmonics
both odd as well as even harmonics
neither odd nor even harmonics

⇒ Point out the wrong statement, Sequential logic circuit is
one that requires a clock to change states
one in which past affects the present states
one whose outputs changes immediately when the inputs change
also called clock logic or synchronous logic

⇒ When a lead acid battery is fully charged the colours of its positive and negative plates are
grey and dark brown
dark grey and brown
grey and brown
dark brown and grey

⇒ A microprocessor is generally
single chip SSI
single chip MSI
single chip LSI
any of the above

⇒ Two voltmeters are each 0-300 V range. Their internal resistances are 10 kΩ and 20 kΩ They are connected is series and a voltage of 400 V is applied. Their readings respectively will be
266.6 and 133.3 V
133.3 and 266.6 V
200 V each
100 and 300 V

⇒ In a degenerate n type semiconductor material, the Fermi level,
is in valence band
is in conduction band
is at the centre in between valence and conduction bands
is very near valence band