Question is ⇒ The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6, Options are ⇒ (A) 1.2 kΩ, (B) 80 Ω, (C) 50 W, (D) 0, (E) , Leave your comments or Download question paper.

Question is ⇒ The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6, Options are ⇒ (A) 1.2 kΩ, (B) 80 Ω, (C) 50 W, (D) 0, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The 6 V zener diode shown in figure has zero zener resistance and a knee current of 5 mA. The minimum value of R, so that the voltage across it does not fall below 6
A.	1.2 kΩ [Wrong Answer]
B.	80 Ω [Correct Answer]
C.	50 W [Wrong Answer]
D.	0 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In PM, without any modulation, all the transmitted pulses have the same
amplitude
width
amplitude and spacing
amplitude, spacing and width

⇒

Assertion (A): Inter-digitated geometry is widely used for microwave transistors.

Reason (R): Tuning at input and output of transistor uses MOS chip capacitors.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The angle δ for a mica capacitor is about
25°
15°
5°
1°

⇒ As per BIS there are 6 accuracy classes of instruments.
TRUE
FALSE

⇒ Some desirable features of a computer communication network are

It should accept an intended transmission without excessive delay
The data arriving at a receiving point should be processed rapidly
When a transmission calls for a response, the delay of response should be minimum.

Which of the above are true?
1 and 2 only
1 and 3 only
1, 2, 3
2 and 3 only

⇒ A network N is dual of network N if
both of them have same mesh equation
both of them have same node equation
mesh equation of one are the node equations of the other
KCL and KVL equations are the same

⇒ In figure, the switch S is initially open and steady state conditions are reached. At t = 0 switch is closed. The initial current through 2C capacito
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ Calculate the stability factor and change in I_C from 25°C to 100°C for, β = 50, R_B/ R_E = 250, ΔI_C0 = 19.9 nA for emitter bias configuration.
42.53, 0.85 μA
40.91, 0.58 μA
40.91, 0.58 μA
41.10, 0.39 μA

⇒ Shaft encoder is used to measure
angular position
linear position
linear velocity
linear acceleration

⇒ The time constant of a series RL circuit is
LR
L/R
R/L
e^-R/L

⇒ Examine the following truth table. The product of sum from this truth tabl
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)
(X + Y) (X + Y)

⇒ Automatic sensitivity control by target voltage control is easily possible in
Vidicon
Plumbicon
New vicon
both (b) and (c)

⇒ The gain margin of first and second order systems is infinite.
TRUE
FALSE

⇒ A single mode fibre not suffer from which type of dispersion?
Waveguide dispersion
Material dispersion
Intermodal dispersion
Polarization mode dispersion

⇒

Assertion (A): CRT is the most important component of a CRO.

Reason (R): When an electron beam strikes the screen of CRT, a spot of light is produced.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ It is required to trace the output characteristics of a CE bipolar transistor on a CRO screen. The proper method is
apply the voltage drop across collector resistance to Y input, disconnect sweep generator and apply V_CE to X input
apply voltage drop across collector resistance to Y input
apply V_CE to X input
apply V_CE to Y input, disconnect the sweep generator and apply voltage drop across collector resistance to X input

⇒ The state equations are in the form
X = AX + BW
X = AX + Bu
X = AX + Bx
either (a) or (b)

⇒ An arrangement of several individual antennas to spaced and phased that their individual contributions combine in one preferred direction and cancel in all other directions, to get greater directive gain or directivity, is known as
directional radiation of antennas
antenna gain stability
array of antennas
none of the above

⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high

⇒ Examine the following statements

Air and gases are compressible.
Air, gases and some liquids are compressible.
Oil can function as hydraulic fluid as well as lubricator.

Which of the above statements are correct?
3 only
2 and 3 only
1 and 3 only
2 only

⇒ Which of the following wave remains unaffected during day and night?
Tropospheric wave
Sky wave
Ground wave
None of the above

⇒ Tesla is a unit of
flux
field strength
flux density
MMF

⇒ The AM, PM, and TV broadcast frequencies are
of the same order as microwave range
much lower than microwave range
much higher than microwave range
either (a) or (c)

⇒ The contents of the program counter after the call operation point to the first instruction on
stack
subroutine
either of the above
none of the above

⇒ An increase in temperature increases the width of depletion layer.
TRUE
FALSE

⇒ In a J-K FF we have J = Q and K = 1. Assuming the FF was initially cleared and then clocked for 6 pulses, the sequence at the Q output wil
10000
11001
10010
10101

⇒ For the power amplifier circuit shown below, the maximum power dissipated by both output transisto
9.66 W
30.11 W
31.66 W
33.66 W

⇒ Bit is a unit of
entropy
information
channel capacity
rate of information

⇒ In an RL series circuit the inductance is 1H and current at an instant is 0.6 A. The energy stored in magnetic field is
0.36 J
0.18 J
0.09 J
0.03 J

⇒ In case of photo conductor for germanium when forbidden energy gap is 0.72 eV, the critical wavelength for intrinsic excitation will be
1.43 m
1.43 mm
1.73 mm
1.73 x 10¹² m