Question is ⇒ The 54/74164 chip is an 8-bit serial-input-parallel-output shift register. The clock is 1 MHz. The time needed to shift a 8-bit binary number into the chip is, Options are ⇒ (A) 1 μs, (B) 2 μs, (C) 8 μs, (D) 16 μs, (E) , Leave your comments or Download question paper.

Question is ⇒ The 54/74164 chip is an 8-bit serial-input-parallel-output shift register. The clock is 1 MHz. The time needed to shift a 8-bit binary number into the chip is, Options are ⇒ (A) 1 μs, (B) 2 μs, (C) 8 μs, (D) 16 μs, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The 54/74164 chip is an 8-bit serial-input-parallel-output shift register. The clock is 1 MHz. The time needed to shift a 8-bit binary number into the chip is
A.	1 μs [Wrong Answer]
B.	2 μs [Wrong Answer]
C.	8 μs [Correct Answer]
D.	16 μs [Wrong Answer]
View Answer 4 -3 Explanation:- Answer : C Discuss it below : Satpal Nehra Said on 2020-07-22 09:28:19 Frequency 1Mhz means time is 1us..and as it's an 8 bit input and 8 bits are required to shift so 8 clocks will be needed hence 8us !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which one of the following is non-resonant antenna?
Folded dipole
Broad side array
End fire array
Rhombic antenna

⇒ The current in a circuit is measured using a 150 : 1 CT If the ammeter reads 0.6 A, the circuit current is
250 A
90 A
156 A
144 A

⇒ In a radio receiver, if the intermediate frequency is too high
Selectivity will be poor
Tracking difficulties will be least
Adjacent channel rejection will improve
All of the above will occur

⇒

Match the following:

	List I (Types of memory)		List II (Used As)
A.	DRAM	1.	Cache memory
B.	SRAM	2.	Main memory
C.	Parallel Access Registers	3.	BIOS memory
D.	ROM	4.	CPU registers

A-1, B-4, C-2, D-3
A-3, B-4, C-2, D-1
A-1, B-2, C-4, D-3
A-3, B-2, C-4, D-1

⇒ The velocity factor of a transmission line
mainly depends on the skin effect
is always higher for a solid dielectric than for air
mainly depends on the dielectric constant of the material used
increases the velocity along the transmission line

⇒ A high level language is less efficient than machine language.
TRUE
FALSE

⇒ The simplest register is
buffer register
shift register
controlled buffer register
bidirectional register

⇒ Find equivalent capacitance if each capacitance is
5/12 F
12/5 F
6/5 F
5/6 F

⇒ Consider the following statements:

If any root of characteristic equation has a positive real part the impulse response is unbounded and system is unstable.
If all the roots of a characteristic equation have negative real parts, the impulse response decays to zero.
If one or more non-repeated roots of characteristic equation are on jω axis impulse response is bounded but the system is unstable.

Which of the above equations are correct?
1, 2 and 3
1 and 2 only
1 and 3 only
2 and 3 only

⇒ As compared to an ordinary semiconductor diode, a Schottky diode
has higher reverse saturation current
has higher reverse saturation current and higher cut in voltage
has higher reverse saturation current and lower cut in voltage
has lower reverse saturation current and lower cut in voltage

⇒ BPSK stands for
Binary Phase Shifting Key
Broad Phase Shifting Key
Bit Phase Shifting Key
Binary Pulse Shifting Key

⇒ Crompton potentiometer has
14 coils and a slide wire all having the same resistance
14 coils and a slide wire but the resistance of slide wire is half that of each coil
14 coils each of different resistance
14 coils out of which 7 coils have resistance which is twice that of remaining 7 coils

⇒ Which is not a valid Java variable
lot
c 1t
s $ 2
2 s $

⇒ An RC series circuit has R = 20 Ω and X_C = 20 Ω. Then Z =
40 Ω
28.28 Ω
20 Ω
1 Ω

⇒ In p mode of operation of magnetron the spikes due to phase focussing effect rotate at an angular velocity corresponding to
one pole/cycle
two pole/cycle
four pole/cycle
six pole/cycle

⇒ A 1000 kHz carrier wave modulated 40% at 4000 Hz is applied to a resonant circuit tuned to a carrier frequency and having Q = 140. What is the degree of modulation after passing the wave through this circuit?
0.4
0.2
0.27
0.554

⇒ When thyristors are connected in parallel, the current distribution may become non-uniform due to
inductive effect of current carrying conductors
capacitive effect of current carrying conductors
both inductive and capacitive effects
none of the above

⇒ The term VLSI generally refers to a digital IC having
more than 1000 gates
more than 100 gates
more than 1000 but less than 9999 gates
more than 100 but less than 999 gates

⇒ The discone antenna is
used in UHF range
circularly polarized
used in radar
used as a direction finding antenna

⇒ A first-order system has a time constant t. For unit ramp input, the steady state error is
t²
t
t
1/t

⇒ Before doping the semiconductor material is
dehydrated
heated
hardened
purified

⇒ If luminance signal Y = 0.3 R + 0.59 G + 0.11 B, the hue of R - Y colour is
0.7 R - 0.59 G - 0.11 B
- 0.7 R + 0.59 G + 0.11 B
1.3 R - 0.59 G - 0.11 B
none of the above

⇒

Assertion (A): At a temperature of 1000 K, thermionic emission current is about 0.1 A/cm² of surface.

Reason (R): Thermionic emission current is given by I_th = SA₀ T² e^-Ew/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In practical commercial AM system channel bandwidth is
150 kHz
100 kHz
15 kHz
200 kHz

⇒ Consider Pole zero diagram as shown, If two Poles are moved in opposite direction towards ω = p/2 and -p/2, the filter wil
change to high pass filter
change to Band Pass filter
remains same
change to LPF

⇒ The 4 point Discrete Fourier Transform (DFT) of a discrete time sequence {1, 0, 2, 3} is
[0, - 2 + 2j, 2, - 2 - 2j]
[2, 2 + 2j, 6, 2 - 2j]
[6, 1 - 3j, 2, 1 + 3]
[6, - 1 + 3j, 0, - 1 - 3j]

⇒ If F = 95.0 what will be the result of following FORTRAN 77 program? 35
35
25
25

⇒ In Fermi-Dirac statistics, the probability of electron occupation of an energy level equal to Fermi level is
0
0.25
0.5
1

⇒ The natural frequency S_n of the given circui
-1
1
42737
-2

⇒ In the given circuit, V₁ = 40 V when R is 10 Ω. When R is zero, the value of V₂ wil
40 V
30 V
20 V
10 V