Question is ⇒ Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using, Options are ⇒ (A) divide by 5 circuit, (B) divide by 2 circuit, (C) divide by 5 circuit followed by divide by 2 circuit, (D) BCD counter, (E) , Leave your comments or Download question paper.

Question is ⇒ Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using, Options are ⇒ (A) divide by 5 circuit, (B) divide by 2 circuit, (C) divide by 5 circuit followed by divide by 2 circuit, (D) BCD counter, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Symmetrical square wave of time period 100 μs can be obtained from square wave of time period 10 μs by using
A.	divide by 5 circuit [Wrong Answer]
B.	divide by 2 circuit [Wrong Answer]
C.	divide by 5 circuit followed by divide by 2 circuit [Correct Answer]
D.	BCD counter [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statements in FORTRAN 77 is non executable?
GO TO
RETURN
STOP
PARAMETER

⇒ A magnetic field exists around
moving charges
static charges
iron
copper

⇒ In the basic series inverter circuit, the source current has
low harmonic content
high harmonic content
low or high harmonic content depending on firing angle
zero harmonic content

⇒ Which of the following terms is not applicable to Yagi-Uda array?
High gain
Folded dipole
Parasitic elements
Good bandwidth

⇒ The total number of pulses in a TV remote control is
14
12
10
8

⇒ The traffic-handling capacity of an Earth station on the uplink depends on
its EIRP
satellite antenna gain
noise associated with the satellite
all of the above

⇒ In a typical microcomputer data transfer takes place between
μP and memory
μP and I/O devices
memory and I/O devices
all of the above

⇒

Assertion (A): If we overdrive an amplifier the output signal may get clipped

Reason (R): To dissipate heat to atmosphere a heat sink is sometimes attached to the case of transistor

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒

Assertion (A): In p-n-p transistor collector current is termed negative.

Reason (R): In p-n-p transistor holes are majority carriers.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): TTL uses multiple emitter transistor.

Reason (R): Multiple emitter transistors with about 60 emitters have been developed.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ If the peak transmitted power in a radar is increased by a factor 81, the maximum range is increased by a factor of
3
9
27
81

⇒ Poynting vector signifies which of the following?
Power density vector producing electrostatic field
Power density vector producing electromagnetic field
Current density vector producing electrostatic field
Current density vector producing electromagnetic field

⇒ In a resistance strain gauge, G = 2, stress = 1050 kg/cm², R = 1000 Ω. The value of ΔR will be
2 Ω
3 Ω
4 Ω
1 Ω

⇒ In which of the following 8085 instructions no condition flags are affected?
INX rp
INR r
SBI data
INR M

⇒ Distances near the skip distance should be used for sky-wave propagation
to avoid the Faraday effect
to avoid tilting
to prevent sky-wave and upper ray interference
so as to exceed the critical frequency

⇒ If the temperature of on extrinsic semiconductor is increased so that the intrinsic carrier concentration is doubled, then
the majority carrier density doubles
the minority carrier density doubles
the minority carrier density becomes 4 times the original value
both majority and minority carrier densities double

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The rejection ratio at 25 MHz will be
1.116
1.386
2.116
2.386

⇒ In the circuit of figure the current through 3 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC
the faster the time constant of AGC, more accurate the output

⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high

⇒ Which one of the following circuits is used for converting a sine wave into a square wave?
Astable multivibration
Monostable multivibration
Bistable multivibration
Schmitt trigger

⇒ The number of protons in a silicon atom are
4
8
12
14

⇒ Which of the following is a valid logical expression in Pascal?
2.5 : = A
(A + B) < < (C + D)
A = < B
A > = B

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_B
24 μA
23 μA
20 μA
10 μA

⇒ The relation between thermionic emission current and temperature is known as
Richardson Dushman equation
Langmuir child law
Ohm's law
Boltzmann's law

⇒ In the circuit shown in the figure, steady-state was reached when the switch S was open. The switch was closed at t = 0. The initial value of the current through the capacitor 2
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ In 8085 microprocessor, what are the contents of register SP, after the interrupt has been star
0210 H
0211 H
054 CH
054 EH

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ CMRR of a difference amplifier is equal to
(A_v')/(A_com)
A_v/A_com
A_com/A_v'
(A_v)/(A_com)²

⇒ In a second order system, peak overshoot is independent of
damping factor
natural frequency
both damping factor and natural frequency
neither damping factor nor natural frequency