Question is ⇒ Surface impedance at high frequencies is a consideration for, Options are ⇒ (A) good conductors, (B) semiconductors, (C) dielectrics, (D) ferrites, (E) , Leave your comments or Download question paper.

Question is ⇒ Surface impedance at high frequencies is a consideration for, Options are ⇒ (A) good conductors, (B) semiconductors, (C) dielectrics, (D) ferrites, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Surface impedance at high frequencies is a consideration for
A.	good conductors [Correct Answer]
B.	semiconductors [Wrong Answer]
C.	dielectrics [Wrong Answer]
D.	ferrites [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ High intermediate frequency in a superheterodyne receiver
higher than
lower than
equal to
not comparable to

⇒ The output of basic DTL configuration is
low when one of the input is high
low when all inputs are high
high when all inputs are high
high when all inputs are low

⇒ The maximum power dissipation capacity of a transistor is 50 mW. If the collector emitter voltage is 10 V, what is the safe collector current that can be allowed through the transistor?
5 mA
2.5 mA
10 mA
25 mA

⇒ In 8355, the ROM is organized as __________ words of 8 bits each.
2000
2048
8355
835

⇒ The number of PM radio channels which can be accommodated in a spectrum of 300 MHz is about
10
100
500
1500

⇒ Which of the following is not a key word in C?
pop
for
if
union

⇒ Hari (H), Gita (G), Irfan (I) and Saira (S) are sibiligs (i.e. brothers and sisters). All were born on 1st January. The age difference between any two successive siblings (that is born one after another) is less than 3 years. Given the following fa
HSIG
SGHI
IGSH
IHSG

⇒ The relation between the apparent power, actual power and reactive power is given by
Apparent power = actual power + reactive power
Apparent power = actual power - reactive power
Apparent power = (actual power)² - (reactive power)²
Apparent power = (actual power)² + (reactive power)²

⇒ Which is not a valid Java variable
lot
c 1t
s $ 2
2 s $

⇒ Three Mod-16 counters are connected in cascade. The maximum counting range is
16
256
4096
none of the above

⇒ A delay equalizer is a
low pass filter
band pass filter
all pass filter
high pass filter

⇒ Steady state conditions are considered to be achieved in R-L circuits at the end of __________ time constant.
one
two
four
five

⇒ Which of the following bridges is also used in an oscillator?
Maxwell
Schering
Hay
Wien

⇒ Robotic manipulator arms mostly use
hydraulic actuator
pneumatic actuator
electric motor actuator
none of the above

⇒ A PC has typically
5 to 10 KB of main memory
10 to 100 KB of main memory
100 to 256 KB of main memory
256 KB to 1 MB of main memory

⇒ In EM waves, polarization
is always vertical in an isotropic medium
is caused by reflection
is due to transverse nature of waves
results from longitudinal nature of waves

⇒ The number of product terms in the minimized sum of product expression obtained through the following k map is (where "d" denotes don't care states)
2
3
4
5

⇒ The most serious problems in ac bridge measurement is
eddy currents
leakage current
residual magnetism
stray fields

⇒ The type of noise that interfere very much with high frequency transmission is
white
transit time
flicker
shot

⇒ The input to negative clamper has a peak value of V_p. Then in the output the positive and negative peaks are nearly
0 and -2 V respectively
V_p and -V_p respectively
2 V_p and 0 respectively
none of the above

⇒ The ASCII code is
5-bit code
7-bit code
9-bit code
11-bit code

⇒ In the circuit of figure the current through 5 Ω resistance at t = 0^{+0.166666666666667
2.5 A
3.1 A
0}

⇒ A class A chopper has an input voltage of 200 V. T_on = 1.5 ms and T_off = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are
0.5, 100 V and 1
0.25, 50 V and 3
0.25, 50 V and 1
0.5, 100 V and 3

⇒ The contents of the program counter after the call operation point to the first instruction on
stack
subroutine
either of the above
none of the above

⇒ In an oscillator crystal, the parallel resonant frequency is
equal to
higher than
less than
series resonant frequency

⇒ Rayleigh current balance is an absolute instrument.
TRUE
FALSE

⇒ Consider the following statements:

Race around condition can occur in JK flip flop when both inputs are 1
A flip flop is used to store one bit of information
A transparent latch is a D type flip flop
Master slave flip flop is used to store two bits of information

Which of the above are correct?
1, 2, 3
1, 3, 4
1, 2, 4
2, 3, 4

⇒ Overall efficiency of class B amplifier is
0.72
0.75
0.785
0.7

⇒ A single phase cycloconverter with centre tapped input transformer requires
2 thyristors
4 thyristors
8 thyristors
either 2 or 4 thyristors

⇒ A uniform plane wave in the free space is normally incident on an infinitely thick dielectric slab (dielectric constant ε_r = 9). The magnitude of the reflection coefficient is
0
0.3
0.5
0.8