Question is ⇒ Status register in the 8156 is read with, Options are ⇒ (A) IN 20 H, (B) OUT 20 H, (C) either (a) or (b), (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Status register in the 8156 is read with, Options are ⇒ (A) IN 20 H, (B) OUT 20 H, (C) either (a) or (b), (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Status register in the 8156 is read with
A.	IN 20 H [Correct Answer]
B.	OUT 20 H [Wrong Answer]
C.	either (a) or (b) [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ Pilot-carrier transmission is one in which
only one sideband is transmitted
one sideband and carrier are transmitted
only two sidebands are transmitted
two sidebands as well as a trace of carrier are transmitted

⇒ A volt ratio box should have low resistance.
TRUE
FALSE

⇒ Virus is a
computer hardware problem
an operating system
a computer program
a computer language

⇒ In PCM, if the number of quantization levels is increased from 4 to 64, then the bandwidth requirement will approximately be increased __________ times.
8
16
3
32

⇒ In the circuit shown in the fi
only red will glow
only green will glow
both red and green will glow
none will glow

⇒ Panel instruments are generally mounted vertically.
TRUE
FALSE

⇒ For a stable system
both phase and gain margin are negative
both phase and gain margin are positive
phase margin is positive but gain margin is negative
gain margin is positive but phase margin is negative

⇒ In indicating instruments the controlling torque is provided by a spring.
TRUE
FALSE

⇒ The main advantage of CMOS circuit is
high gain
high output impedance
low power consumption
high gain and high output impedance

⇒ The units for electric dipole moment are
coulombs
colomb-metre
coulomb/metre
coulomb/m²

⇒ The fourier transform of the half cosine pulse as shown below is _______
0.5 {sin [0.5(f - 1)] + sin [0.5 (f + 1)]}
0.25 [sin c[0.25 (f - 2)1 + sin c[0.25(f + 2)]]
0.5 {sin c [0.5 (f - 1)] + sin c [0.5 (f + 1)]}
sin c(f - 0.5) + sin c (f + 0.5)

⇒ The purpose of impedance matching in an amplifier circuit is to achieve
high efficiency
reduce distortion
maximum power transfer
none of the above

⇒

Match the following:

	List I		List II
A.	Bode	1.	Asymptotic plots
B.	Evans	2.	Polar plots
C.	Nyquist	3.	Root locus technique
		4.	M and N circles

A-1, B-4, C-2
A-2, B-3, C-4
A-3, B-1, C-4
A-1, B-3, C-2

⇒ Which rectifier has the best ratio of rectification?
Half wave rectifier
Full wave rectifier
Bridge rectifier
Three phase full wave rectifier

⇒ In two level logic, logic race does not occur.
TRUE
FALSE

⇒ In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
class A
class B
class C
class AB

⇒ An ammeter of 0-25 A range has a guaranteed accuracy of 1% of full scale reading. The current measured is 5 A. The limiting error is
0.02
0.025
0.04
0.05

⇒ A phase shifting transformer is used in conjunction with
DC slide wire potentiometer
Crompton potentiometer
AC coordinate potentiometer
Drysdale potentiometer

⇒ Calculate the stability factor and change in I_c from 25°C to 100°C for, β = 50, R_B/R_E = 250, ΔI_CO = 19.9 nA for emitter bias configuration
42.553, 0.85 μF
40.91, 0.58 μF
38.53, 0.85 μF
41.10, 0.39 μF

⇒ A delta modulation system is designed to operate at 3 times the Nyquist rate for a signal with a 3 KHz bandwidth. The quantization step size is 250 mv. The maximum amplitude of a 1 KHz input sinusoidal for which the delta modulator does not show slope overload is :
716.2 mV
500 mV
647.87 mV
400 mV

⇒ To avoid the effect of stray magnetic fields in ac bridge we can use
magnetic screening
Wagner earthing device
wave filter
transformer

⇒ In a DM system, the granular noise occurs when modulating signal
decrease Rapidly
increase
has high frequency component
change within step size

⇒

Assertion (A): The phase angle plot in Bode diagram is not affected by change in system gain.

Reason (R): The variation in gain has no effect on phase margin of the system.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Which of the following best represents the bandwidth of an actual op-amp?
100 Hz to 1 MHz
0 Hz to 100 kHz
0 Hz to 10 MHz
0 Hz to infinity

⇒ Nyquist stability criterion uses open loop frequency response characteristics.
TRUE
FALSE

⇒ Point out the wrong statement, Sequential logic circuit is
one that requires a clock to change states
one in which past affects the present states
one whose outputs changes immediately when the inputs change
also called clock logic or synchronous logic

⇒ In a common emitter BJT amplifier, the maximum usable supply voltage is limited by
avalanche Beakdown of Base-Emitter junction
collector emitter breakdown voltage with base open(βV_CEO)
collector emitter breakdown voltage with emitter open(βV_CEO)
zener break down voltage of the emitter base junction

⇒ Donor energy level is n type semiconductor is very near valence band.
TRUE
FALSE

⇒ A copper coil has a resistance of 40 ohm at 20°C. At 100°C the resistance is likely to be
44 Ω
54 Ω
84 Ω
104 Ω