Question is ⇒ Square law modulators utilise, Options are ⇒ (A) linear range of V-I characteristics of a diode, (B) linear range of V-I characteristics of a triode, (C) non-linear region of V-I dynamic characteristics of a diode, (D) non-linear region of V-I dynamic characteristics of a triode, (E) , Leave your comments or Download question paper.

Question is ⇒ Square law modulators utilise, Options are ⇒ (A) linear range of V-I characteristics of a diode, (B) linear range of V-I characteristics of a triode, (C) non-linear region of V-I dynamic characteristics of a diode, (D) non-linear region of V-I dynamic characteristics of a triode, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Square law modulators utilise
A.	linear range of V-I characteristics of a diode [Wrong Answer]
B.	linear range of V-I characteristics of a triode [Wrong Answer]
C.	non-linear region of V-I dynamic characteristics of a diode [Correct Answer]
D.	non-linear region of V-I dynamic characteristics of a triode [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a tape recorder the erase head is
engaged during playback but disengaged during recording
engaged both during recording and playback
disengaged both during recording and playback
engaged during recording but disengaged during playback

⇒ Neutralization is used in RF amplifiers to
stop oscillation
increase bandwidth
improve selectivity
all of the above

⇒ Which of the following is the ferric electric material?
Rochelle salt
Barium titanate
Potassium dihydrogen phosphate
All of the above

⇒ The electrical requirement on wall thickness of rectangular wave guide is
wall thickness is more than skin depth
wall thickness is less than skin depth
wall thickness is equal to skin depth
either (b) or (c)

⇒ The energy of constant-amplitude complex valued exponential sequence is __________ (where A is the constant amplitude)
0
1
∞
A²

⇒ In the graph of figure, the total number of tree
4
5
6
8

⇒ In a bipolar transistor which current is smallest
collector current
base current
emitter current
any of the three currents

⇒ JFET has __________ degree of isolation between input and output, and a __________ noise figure.
low, low
high, high
low, high
high, low

⇒ In a N-P-N transistor of the emitter junction is reverse biased and collector junction is also reversed biased, the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ In the figure circuit, V₁ = 40 V. When R is 10 Ω. When R is zero, the value of V₂ wil
40 V
30 V
20 V
10 V

⇒ For a sinusoidal input, the circuit shown in the figure will act
Pulse generator
Full wave rectifier
Ramp generator
Voltage Doubler

⇒ When a wave is incident from the more dense into a less dense medium at an angle equal to or exceeding the critical angle, the wave suffers total internal __________ .
reflection
refraction
transmission
none of the above

⇒ The power dissipation in a transistor is the product of
emitter current and emitter to base voltage
emitter current and collector to emitter voltage
collector current and collector to emitter voltage
none of the above

⇒ VLF is generally used for
telegraphy
satellite communication
instrument landing system
all of the above

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal.
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal.

⇒ In a series inverter
the commutating elements L and C are in parallel
the commutating elements L and C are in series with load
the commutating L and C may be in series or parallel with the load
none of the above

⇒ If a sheet of a mica is inserted between the plates of an air capacitor, the capacitance
will increase
will return the same
will decrease
may increase or decrease

⇒ When P_c is the unmodulated carrier power and P_t is the total power in the modulated wave, then the maximum power in AM wave is
P_t = 1.5 P_c
P_t = 2.5 P_c
P_t = 2
P_t = 22 P_c

⇒ The root locus branches
start from open loop poles and terminate at zeros
start from open loop zeros and terminate at poles
may start from pole or zero and terminate at another pole or zero
none of the above

⇒ Which of these instrument does not have a control spring?
Moving iron ammeter
PMMC ammeter
Electrostatic voltmeters
Power factor meter

⇒ A potential of 7 V is applied to a silicon diode. A resistance of 1 K ohm is also in series with the diode. The current is
7 mA
6.3 mA
0.7 mA
0

⇒ In the following limiter circuit, an input voltage V₁ = 10 sin 100pt applied. Assume that the diode drop is 0.7 V when it is forward biased. The zener breakdown voltage is 6
6.1 V, -0.7 V
0.7 V, -7.5 V
7.5 V, -0.7 V
7.5 V, -7.5 V

⇒ When a p-n Junction is forward biased
the current flow is due to electrons only
the majority carriers in both p and n materials are driven toward the junction.
the majority carriers in both p and n materials are away from the junction.
both (a) and (c).

⇒ A transistor with a = 0.9 and I_CBO = 10 μA is biased so that I_BQ = 90 μA. Then I_CQ will be
910 mA
5 mA
5.25 mA
4.95 mA

⇒ Number of fundamental cut-sets of any graph will be
same as the number of twigs
same as the number of tree branches
same as the number of nodes
equal to one

⇒ 'WRITE' is a
Word processor
Line editor
Text editor
Column editor

⇒ A signal x(n) = sin(ω₀n + φ) is the input to a linear time invariant system having a frequency response H(e^jω) If the O/P of the system is Ax(n -n₀), then the general form of H(e^jω) will be
- n₀ω₀ + β for any arbitrary real β
- n₀ω₀ + 2pk for any arbitrary integer k
n₀ω₀ + 2pk for any arbitrary integer k
- n₀ω₀ + φ

⇒ Electric dipole is located at origin in a medium with ε_r = 6, has a moment P = (4a_x - 2a_y + a_z ) nC. Then potential at (2, 4, 4) is:
0.062
0.027
0.042
0.072

⇒ The power dissipated per gate
is constant at all frequencies
increases with frequency
decreases with frequency
may increase or decrease with frequency

⇒ Optical encoders most commonly used in control systems are
absolute encoders
secondary encoders
incremental encoders
none of the above