Question is ⇒ A + AB =, Options are ⇒ (A) A, (B) A, (C) A + B, (D) A + B, (E) , Leave your comments or Download question paper.

Question is ⇒ A + AB =, Options are ⇒ (A) A, (B) A, (C) A + B, (D) A + B, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A + AB =
A.	A [Wrong Answer]
B.	A [Wrong Answer]
C.	A + B [Correct Answer]
D.	A + B [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the figure, the
emits light when both S₁ and S₂ are closed
emits light when both S₁ and S₂ are open
emits light when only S₁ and S₂ is closed
does not Emit light, irrespective of the switched positions

⇒ Directive gain of elementary doublet is
100
10
1.5
0.5

⇒ The function Y = AC + BD + EF is
POS
SOP
Hybrid
none of the above

⇒ The expression Y = pM (0, 1, 3, 4) is
POS
SOP
Hybrid
none of the above

⇒ Maximum efficiency of class B power amplifier is 50%.
TRUE
FALSE

⇒ When a circuit is excited by ac sinusoidal source, the admittance is obtained by letting s = jω in Y(s).
TRUE
FALSE

⇒ The impedance parameter z₂₁ is
transfer impedance at port 1 with port 2 open circuited
transfer impedance at port 1 with port 2 short circuited
transfer impedance at port 2 with port 1 open circuited
transfer impedance at port 2 with port 1 short circuited

⇒

Assertion (A): A dc stabilizer has constant output voltage irrespective of variations in input voltage and load current

Reason (R): A dc series regulator uses a zener diode across the load to stabilize the output voltage.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Power handling capacity of wire wound potentiometer used in control systems is about
0.1 W
5 W
25 W
100 W

⇒ Which of the following does not show non-linear V-I characteristics?
Schottky diode
Tunnel diode
Thermister, at a fixed temperature
p-n junction diode

⇒ Which of the following modes can exist in a rectangular waveguide?
TM₁₀
TE₁₀
TM₀₀
TM₀₁

⇒ In a transistor the minimum and maximum values of β_dc are 100 and 121. The proper value of β_dc to be used to locate Q point is
100
121
110.5
110

⇒ Which dc servomotor requires strongest permanent magnet?
Slotted armature
Surface wound armature
Surface wound with stationary rotor
Either (a) or (b)

⇒ Which one of the following is true?
Alternating voltage and current contain odd and even harmonics
The inductance in a circuit reduces the effect of harmonics and makes current wave more sinusoidal than voltage wave
Alternating voltage and current waveforms, in general, do not contain odd harmonics
Inductance of a circuit does not alter wave shape at all

⇒ Which of the following identifiers is valid in Pascal?
THETA
NUM
1 ST
$ BETA

⇒ For the factor (1 + 0.5 jω) the corner frequency is
1 rad/sec
0.5 rad/sec
2 rad/sec
0.25 rad/sec

⇒ Piezoelectric quartz crystal resonators find application where
signal amplification is required
rectification of the signal is required
signal frequency control is required
modulation of signal is required

⇒ In commercial electron tubes the current produced by the cathode at 1000 K is about
0.01 A per cm² of cathode surface
0.1 A per cm² of cathode surface
1 A per cm² of cathode surface
5 A per cm² of cathode surface

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒ In case of surface waves the field strength at a point is directly proportional to
antenna height
wave frequency
current of the antenna
distance of the point from the antenna

⇒ The method of triggering SCS is
application of positive pulse at cathode gate or negative pulse at anode gate
application of pulse at anode gate
application of pulse at cathode gate
application of low voltage at anode

⇒ EEPROM permits
read operation only
read and byte erase operations
read, byte erase and byte write operations
read, byte erase, byte write and chip erase operations

⇒ Two voltages are v₁= 100 sin (ωt + 15°) and v₂ = 60 cosωt, then
v₁ is leading v₂ by 15°
v₁ is leading v₂ by 75°
v₂ is leading v₁ by 75°
v₂ is lagging v₁ by 15°

⇒

Assertion (A): In root locus the breakaway and break in points either lie on real axis or occur in complex conjugate pairs.

Reason (R): All root locus asymptotes intersect on real axis.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The number of spectral component of impulse wave is
1
0
2
∞

⇒

Assertion (A): For satellites and space probes, PRF of a radar is pretty low.

Reason (R): PRF of a radar depends on the range of a radar.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In the circuit, shown the current I marked is give
2.22 A
1.78 A
4.44 A
0.0833333333333333

⇒ The input to a parity detector is 1001. The output is
0
1
0 or 1
indeterminate

⇒ The interface chip for 8086 and 16 bit ADC is
8259
8255
8253
8251

⇒ A vibration galvanometer is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument