Question is ⇒ Some ceramic materials become superconducting, Options are ⇒ (A) below liquid helium temperature, (B) between liquid helium and liquid nitrogen temperature, (C) above liquid nitrogen but below room temperature, (D) at room temperature, (E) , Leave your comments or Download question paper.

Question is ⇒ Some ceramic materials become superconducting, Options are ⇒ (A) below liquid helium temperature, (B) between liquid helium and liquid nitrogen temperature, (C) above liquid nitrogen but below room temperature, (D) at room temperature, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Some ceramic materials become superconducting
A.	below liquid helium temperature [Correct Answer]
B.	between liquid helium and liquid nitrogen temperature [Wrong Answer]
C.	above liquid nitrogen but below room temperature [Wrong Answer]
D.	at room temperature [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The given figure shows a control system. The maximum value of gain for which the system is stabl
3
3
4
5

⇒ The first geostationary satellite was named
Intelsat I
Intelsat II
Intelsat III
Early bird

⇒

Assertion (A): When reverse voltage across a p-n junction is increased, the junction capacitance decreases.

Reason (R): Capacitance of any layer is inversely proportional to thickness.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?
Wave traps in each stage
Stagger tuning
A shunt damping resistor across each tuned circuit
Doubled tuned transformers with tighter coupling

⇒ Short-circuited stubs are used, because open-circuited stubs are
liable to radiate
complex in nature
providing open-circuit environments
unable to provide work over large frequency range

⇒ Which of the following devices has metal-silicon junction?
General purpose power diode
Schottky diode
SCR
MOSFET

⇒

Assertion (A): Impedance measurement at microwave frequencies is done by finding SWR.

Reason (R): SWR and reflection coefficient depend on the characteristic impedance and load impedance.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A permanent magnet moving coil meter can be used as
ac only
dc only
both ac and dc
low frequency ac and dc

⇒ The terminals of a power MOSFET are called
emitter, base, collector
source, gate, drain
source, base, drain
emitter, gate, drain

⇒ The load impedance Z_L of a CE amplifier has R and L in series. The phase difference between output and input will be
180°
0
more than 90° but less than 180°
more than 180° but less than 270°

⇒ Ferrite have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ A broadside array operating at 100 cm wavelength consist of 4 half-wave dipoles spaced 50 cm apart. Each element carries radio frequency current in the same phase and of magnitude 0.5 A. The radiated power will be
196 W
73 W
36.5 W
18.25 W

⇒ In a CE amplifier, the output voltage is equal to product of
ac collector current and ac collector resistance
ac base current and ac collector resistance
ac emitter current and ac emitter resistance
ac collector current and source resistance

⇒ In a single phase half wave ac regulator feeding a resistive load, the rms load current
is always positive
may be positive or negative
is always negative
can be even zero

⇒

Assertion (A): Master slave JK flip flop is commonly used in high speed synchronous circuitry

Reason (R): Master slave JK flip flop uses two JK flip flops in cascade.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ An MTI compares a set of received echos with those received during the previous sweep.
TRUE
FALSE

⇒ In a p-n-p transistor operating in forward active mode
base is positive with respect to emitter and collector
base is negative with respect to emitter and collector
emitter is positive with respect to base and base is positive with respect to collector
emitter is negative with respect to base and base is positive with respect to collector

⇒ The semi-conductor type 2 N 34 indicates
a n-channel MOSFET
a JFET
a diode with two electrodes
a diode with three electrodes

⇒ The read and write cycle times of cache memory are in the range of
1 - 3 ns
25 ns - 45 ns
200 ns - 300 ns
1 μs

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒ The dynamic impedance of an R-L and C parallel circuit at resonance is __________ ohm.
R/LC
C/LR
LC/R
L/CR

⇒ Available multiplexer IC package can have a maximum of 8 inputs.
TRUE
FALSE

⇒ At 0 K the forbidden energy gap in intrinsic semi conductor is about
10 eV
6 eV
1 eV
0.2 eV

⇒ An antenna having an effective temperature of 27°K is fed into a microwave amplifier that has an effective noise temperature of 30 K. Calculate the available noise power per unit bandwidth
30 K
57 K
27 K
3K, K is Boltzmann constant

⇒ The sign of a floating point number depends on
only the sign of mantissa
only the sign of exponent
the sign of both mantissa and exponent
either (a) or (b)

⇒ In auxiliary commutated chopper, the charging and discharging time of capacitor
are constant
depend on load current
may be constant or may depend on load current
none of the above

⇒ For the polynomial P(s) = s⁵ + s⁴ + 2s³ + 2s² + 3s + 15 The number of roots which lie in the right half of the s plane is :
4
2
3
1

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒ In AM, if modulation index is more than 100%, then
bandwidth increases
the wave gets distorted
power of the wave increases
efficiency of transmission increases

⇒ The VLF, LF and MF antennas are
horizontally polarized
vertically polarized
non linearly polarized
either (a) or (b)