Question is ⇒ Skin effect is noticeable only at ____ frequencies, Options are ⇒ (A) audio, (B) low, (C) high, (D) all, (E) , Leave your comments or Download question paper.

Question is ⇒ Skin effect is noticeable only at ____ frequencies, Options are ⇒ (A) audio, (B) low, (C) high, (D) all, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Skin effect is noticeable only at ____ frequencies
A.	audio [Wrong Answer]
B.	low [Wrong Answer]
C.	high [Correct Answer]
D.	all [Wrong Answer]
View Answer 10 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A synchronous condenser is generally installed at the of the ____ transmission line
receiving end
sending end
middle
none of the above

⇒ The steel used in steel cored conductors is usually
alloy steel
stainless steel
mild steel
high speed steel

⇒ A.C.S.R. conductor having 7 steel stands surrounded by 25 aluminium conductors will be specified as
25/7
50/15
7/25
15/50

⇒ Impedance relay is used on ____ transmission lines
short
medium
long
all

⇒ A feeder, in a transmission system, feeds power to
distributors
generating stations
service mains
all of the above

⇒ The area of cross-section of the neutral in a 3-wire D.C. system is generally ____ the area of cross-section of main conductor
same as
one-fourth
one half
double

⇒ By using bundled conductors which of the following is reduced ?
Power loss due to corona
Capacitance of the circuit
Inductance of the circuit
None of the above

⇒ On which of the following does the size of a feeder depend ?
Voltage drop
Voltage
Frequency
Current carrying capacity

⇒ Overhead system can be designed for operation upto
11 kV
33 kV
66 kV
400 kV

⇒ Ground wire is used to
avoid overloading
give the support to the tower
give good regulation
connect, a circuit conductor or other device to an earth-plate

⇒ Due to which of the following reasons aluminium is being favoured as busbar material ?
Low density
Low cost
Ease of fabrication
None of the above

⇒ A circuit is disconnected by isolators when
line is energized
there is no current in the line
line is on full load
circuit breaker is not open

⇒ By which of the following methods voltage of transmission can be regulated ?
Use of series capacitors to neutralise the effect of series reactance
Switching in shunt capacitors at the receiving end during heavy loads
Use of tap changing transformers
Any of the above methods

⇒ The voltage drop, for constant voltage transmission is compensated by installing
inductors
capacitors
synchronous motors
all of above

⇒ The power factor of industrial loads is generally
unity
lagging
leading
zero

⇒ For an overhead line, the surge impedance is taken as
20-40 ohms
70-80 ohms
100-200 ohms
500-1000 ohms

⇒ Transmission line insulators are made of
glass
porcelain
iron
P.V.C.

⇒ The frequency of voltage generated, in case of generators, can be increased by
using reactors
increasing the load
adjusting the governor
reducing the terminal voltage

⇒ High voltages for transmitting power is economically available from
d.c. currents
a.c. currents
carrier currents
none of the above

⇒ Which of the following is the main advantage of A.C. transmission system over D.C. transmission system ?
Less instability problem
Less insulation problems
Easy transformation
Less losses in transmission over long distances

⇒ The distributors for residential areas are
single phase
three-phase three wire
three-phase four wire
none of the above

⇒ Which of the following has least effect on corona ?
Atmospheric temperature
Number of ions
Size and charge per ion
Mean free path

⇒ The phenomenon of rise in voltage at the receiving end of the open-circuited or lightly loaded line is called the
Seeback effect
Ferranti effect
Raman effect
none of the above

⇒ The operating voltage of extra high tension cables is upto
66 kV
11 kV
33 kV
66 kV

⇒ Floating neutral, in 3-phase supply, is undesirable because it causes
low voltage across the load
high voltage across the load
unequal line voltages across the load
none of the above

⇒ For transmission of power over a distance of 200 km, the transmission voltage should be
132 kV
66 kV
33 kV
11 kV

⇒ The minimum clearance between the ground and a 220 kV line is about
4.3 m
5.5 m
7.0 m
10.5 m

⇒ The string efficiency of an insulator can be increased by
correct grading of insulators of various capacitances
reducing the number of strings
increasing the number of strings in the insulator
none of the above

⇒ Power loss due to corona is not directly proportional to
spacing between conductors
supply voltage frequency
phase-neutral voltage
all of the above

⇒ The operating voltage of high voltage cable's is upto
1.1 kV
3.3 kV
6.6 kV
11 kV