Question is ⇒ Single parity check is not reliable in case of, Options are ⇒ (A) paper tape, (B) magnetic tape, (C) magnetic drum, (D) cores, (E) , Leave your comments or Download question paper.

Question is ⇒ Single parity check is not reliable in case of, Options are ⇒ (A) paper tape, (B) magnetic tape, (C) magnetic drum, (D) cores, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Single parity check is not reliable in case of
A.	paper tape [Wrong Answer]
B.	magnetic tape [Wrong Answer]
C.	magnetic drum [Correct Answer]
D.	cores [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The function δ (t - b) is a
unit impulse
unit step
unit doublet
none of the above

⇒ Which of the following is not valid in case of bipolars?
It has a low input impedance
It has high voltage gain
It is a current controlled device
It is difficult to bias

⇒ In pulse code modulation when the maximum frequency in the signal is f_max the bandwidth required will be
≤ p.f_max
≥ p.f_max
≤ (p.f_max)²
≥ (p.f_max)²

⇒ If N = 196, the result of the following program will be 196
16
16
196

⇒

Assertion (A): In high Q circuits poles of Y(s) lie close to ω axis in complex frequency plane.

Reason (R): Q is inversely proportional to damping factor.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of these has peak and valley points in v-i curve?
Tunnel diode
Zener diode
PIN diode
Schottky diode

⇒

Assertion (A): A JFET can be used as a current source.

Reason (R): In beyond pinch off region the current in JFET is nearly constant.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ All of the output pulses are at full transmitter power for a strong signal in all of the following except
PWM
PAM
PFM
PCM

⇒ In 8085 microprocessor system, can an input and output port have same port address?
Yes
No
Insufficient data
None of these

⇒ In thermal ohm's law, temperature and power loss are analogous to
V and I respectively of ohm's law
I and V respectively of ohm's law
R and V respectively of ohm's law
I and R respectively of ohm's law

⇒ The reverse voltage applied to a varactor diode
is less than avalanche breakdown voltage
is more than avalanche breakdown voltage
may be more or less than a avalanche breakdown voltage
is very high as compared to avalanche breakdown voltage

⇒ A dynamometer wattmeter is connected in ac circuit. The reading will be
V-A product
average power
peak power
instantaneous power

⇒ Gray code is used in devices which convert analog quantities to digital signal because it is
more error free
much simpler than binary code
superior to Excess-3 code
absolutely error free

⇒ Which dc servomotor requires strongest permanent magnet?
Slotted armature
Surface wound armature
Surface wound with stationary rotor
Either (a) or (b)

⇒ Which language has a preprocessor?
Fortran 77
Pascal
C
None of the above

⇒ The main difference between the broadside arrays and end fire arrays is that
individual elements are fed with same current in broadside arrays and of different magnitude in end fire arrays
in broadside arrays the elements are equidistant whereas in end fire array the distance between elements increases progressively
the total number of elements in broadside array is always one and a half times that of elements in end fire arrays
in broadside array the individual elements are fed in, out of phase by 180° whereas in end fire array individual elements are fed with currents of equal magnitude but their phases vary progressively along the line in such a way as to make the entire arrangement substantially unidirectional

⇒ The function Z(s) has a pole at infinity if
the degree of numerator and denominator of Z(s) are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ In TV scanning sequence of lines is
left to right
right to left
left to right for odd fields and right to left for even field
left to right for even fields and right to left for odd field

⇒ Windows can run several tasks simultaneously.
TRUE
FALSE

⇒ In which configuration does output ac voltage appear between emitter and ground?
CE
CB
CC
Both CE and CB

⇒ In 8421 Binary coded Decimal system the decimal number 237 is represented by
1000110111
1000111110
1000110111
10010010011

⇒ A rectangular waveguide having TE₁₀ mode as dominant mode is having a cut off frequency of 18 GHz for the TE₃₀ mode. The inner broad wall dimension of the rectangular waveguide is
5/3 cm
5 cm
5/2 cm
10 cm

⇒

Assertion (A): Electron concentration n, hole concentration p and charge concentration n_i are related by n_i² = np.

Reason (R): p type semiconductor is obtained by adding trivalent impurity to intrinsic semiconductor.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): A RAM with access time of the order of hundreds of nano seconds is suitable for a control memory.

Reason (R): The time taken to execute an operation in a microcomputer is critically de pendent on access time of control memory.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The component in the given figur
attenuator
T type low pass filter
T type high pass filter
phase shifter

⇒ The number of inputs and outputs in a full adder are
2 and 1
2 and 2
3 and 3
3 and 2

⇒ The noise figure is
3 dB
6 dB
6.6 dB
12 dB

⇒ The hexadecimal number (3E8)₁₆ is equal to decimal number
1000
982
768
323

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In 8085 microprocessor, what is the memory word addressing capability?
32 K
64 K
256 K
512 K