Question is ⇒ Silicon and germanium atoms combine orderly into array of atoms located in repetitive geometric pattern. This pattern is called, Options are ⇒ (A) crystal, (B) covalent bond, (C) molecule, (D) valence bond, (E) , Leave your comments or Download question paper.

Question is ⇒ Silicon and germanium atoms combine orderly into array of atoms located in repetitive geometric pattern. This pattern is called, Options are ⇒ (A) crystal, (B) covalent bond, (C) molecule, (D) valence bond, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Silicon and germanium atoms combine orderly into array of atoms located in repetitive geometric pattern. This pattern is called
A.	crystal [Correct Answer]
B.	covalent bond [Wrong Answer]
C.	molecule [Wrong Answer]
D.	valence bond [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ To obtain very high I/P and O/P impedances in a feedback amplifier, the topology used is
voltage series
current series
voltage shunt
current shunt

⇒ The hexadecimal number BBC7 is equivalent to decimal number
49761
46791
47691
49761

⇒ The resolution of a wire wound potentiometer is about
0.00001
0.001
0.01
0.05

⇒ The Nyquist plo
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the second quadrant
will start from (ω = ∞) in the fourth quadrant and will terminate (ω = 0) in the second quadrant
will start form (ω = ∞) in the second quadrant and will terminate (ω = 0) in the fourth quadrant
will start from (ω = ∞) in the first quadrant and will terminate (ω = 0) in the fourth quadrant

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Developed by)
A.	CCD charger	1.	Toshiba
B.	New vicon	2.	Philips
C.	Plumbicon	3.	Matushita
D.	Chalnicon	4.	RCA

A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-1, B-2, C-3, D-4

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V

⇒ In gases the flow of current is due to
positive ions only
electrons only
electrons, positive ions and negative ions
electrons and positive ions

⇒ In 3 phase power measurement by two wattmeter method, the reading of one wattmeter is zero. The power factor of load is
1
0.5
0
0.8

⇒ Four terminal approach is used in measuring low resistance because it
eliminates thermoelectric energy
eliminates stray capacitance
eliminates stray inductance
eliminates the effect of leads and contacts

⇒ Consider the following statem
1 alone
2 alone
3 alone
1 and 3

⇒ The first machine cycle of an instruction is always
a memory read cycle
a fetch cycle
a input/output read cycle
a memory write cycle

⇒

Assertion (A): Rochelle salt and Barium titanate are both ferroelectric.

Reason (R): Ferroelectric materials exhibit hysteresis effect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The network shown in figur
reciprocal
reciprocal and symmetrical
non-reciprocal
unsymmetrical

⇒ Which of the following statement is false?
Bandwidth of a circuit is given by the range of frequencies lying between half-power points
Half-power points on a resonance curve are those points where power is half of that at resonance
Half-power points are also known as 3 dB points
At both half-power points, the p.f. = 0.707 lagging

⇒ For an elliptically polarized wave incident on the interface of a dielectric at the Brewster angle the reflected wave will be
elliptically polarized
linearly polarized
right circularly polarized
left circularly polarized

⇒ A 4 cm by 3 cm rectangular waveguide with air cavity, is operating at 12 GHz with TE₁₁ mode. The cut-off frequency is:
6.25 GHz
4.75 GHz
1.5 GHz
8.75 GHz

⇒ If a driving point function N(s) = p(s)/q(s), then
the degree of p(s) and q(s) may differ by one only
the degree of p(s) and q(s) may differ by zero only
the degrees of p(s) and q(s) be equal
the degrees of p(s) and q(s) must not be equal

⇒ Piezoelectric materials serves as a source of
microwaves
ultrasonic waves
musical waves
resonant waves

⇒ A single phase full wave regulator feeds R-L load. The best gating signal is
short duration pulses
long duration pulses
pulse train
either (a) or (b)

⇒ Power received from Sun per m² surface area of a geosynchronous satellite in nearly __________ watt.
100
500
2000
1000

⇒ In a series circuit with fixed R and variable X_L, the current locus lies in the fourth quadrant.
TRUE
FALSE

⇒ The portion of the atmosphere closest to ground is called ionosphere.
TRUE
FALSE

⇒ In TV system in India IF video and IF audio frequencies are
33.4 and 28.4 MHz respectively
38.9 and 33.4 MHz respectively
43.8 and 38.9 MHz respectively
33.4 and 38.9 MHz respectively

⇒ In a series LCR circuit the maximum inductor voltage is twice the maximum capacitor voltage however current lags by 30° and drop across the inductance is v_L = 100 sin 377t V. Assuming the resistance being 20 Ω, Find the values of the capacitance and inductance.
235 μF, 61.18 μH
230 μF, 61.18 μH
61.18 μF, 230 μH
None of the above

⇒

Assertion (A): A high dv/dt may cause triggering of a thyristor.

Reason (R): A high dv/dt results in charging current in the thyristor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following statement is correct?
FET and junction transistor both are unipolar
FET and junction transistor both are bipolar
The FET is bipolar, while junction transistor are unipolar
The FET is unipolar, while junction transistor are bipolar

⇒ In p-n-p transistor the current I_E has two components viz. I_EP due to injection of holes from p-region to n-region and I_E due to injection of electrons from n-region to p-region. Then
I_Ep and I_En are almost equal
I_Ep >> I_En
I_En >> I_Ep
either (a) or (c)

⇒ For an op-amp source follower circuit
input and output voltages have same magnitude
output and input voltages are in phase
output and input voltages are in phase but have different magnitudes
output and input voltages have same magnitude and are in phase

⇒ Figure shows a self bias circuit for FET amplifier, I_D = 4 mA. Then I_{S4 mA
2 mA
0.4 mA
0.2 mA}

⇒ The circuit shown in the figure has 4 boxes each described by inputs P, Q, R and outputs Y, Z
4 bit adder giving P + Q
4 bit subtractor giving P - Q
4 bit subtractor giving Q - P
4 bit adder giving P + Q + R