Question is ⇒ Signal to noise ratio of microphone is defined as the ratio of output when the sound pressure is __________ to the output in the absence of any sound signal., Options are ⇒ (A) 0.5 Pa, (B) 0.2 Pa, (C) 0.1 Pa, (D) 0.01 Pa, (E) , Leave your comments or Download question paper.

Question is ⇒ Signal to noise ratio of microphone is defined as the ratio of output when the sound pressure is __________ to the output in the absence of any sound signal., Options are ⇒ (A) 0.5 Pa, (B) 0.2 Pa, (C) 0.1 Pa, (D) 0.01 Pa, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Signal to noise ratio of microphone is defined as the ratio of output when the sound pressure is __________ to the output in the absence of any sound signal.
A.	0.5 Pa [Wrong Answer]
B.	0.2 Pa [Wrong Answer]
C.	0.1 Pa [Correct Answer]
D.	0.01 Pa [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The electric breakdown strength is affected by
shape of the waveform of applied voltage
steepness of the wavefront of the applied voltage
composition of the material
all of the above

⇒ For most metals, Fermi level E_F is less than
0.1 eV
2 eV
5 eV
10 eV

⇒ A network N is dual of network N if
both of them have same mesh equation
both of them have same node equation
mesh equation of one are the node equations of the other
KCL and KVL equations are the same

⇒

Assertion (A): In a BJT base current is very small.

Reason (R): In a BJT recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following statements about the matched filter in a communication receiver are correct?

Its impulse response depends on the signed shape
It maximizes the SNR at the detection shape.
It produces ISI.
It may produce phase error if synchronization is improper.

Select the correct answer from the codes given below:
1 and 4 only
1 and 2 only
2, 3 and 4
1, 2 and 4

⇒ For a sinusoidal input, the circuit shown in the figure will act
Pulse generator
Full wave rectifier
Ramp generator
Voltage Doubler

⇒ In a CRO, the frequency of output of time base generator
is only one constant value
is adjustable
varies automatically
either (a) or (c)

⇒ The resolution of a 4 bit counting ADC is 0.5 volts. For an analog input of 6.6 volts, the digital output of the ADC will be
1011
1101
1100
1110

⇒ If a two port network is represented by an equivalent T network the admittance of series arm in term of ABCD parameter is equal to
C
1/C
(A - 1)/B
1/B

⇒ A sine wave is passed through an amplifier which severely limits it symmetrically. If then passes to a second amplifier which is narrow band and tuned to the frequency of the original sine wave. What will be the output wave from this second amplifier?
A square wave of the same frequency as that of the original sine wave
A square wave of double the frequency of that of original sine wave
A sine wave of constant amplitude at the frequency of the original sine wave
A sine wave of constant amplitude at double frequency of the original sine wave

⇒ When a current flows through a conductor,
an electric field exists at all points within the conductor
electric field exists only at all points on the surface of the conductor
electric field exists only at ends of the conductor
any of the above depending on magnitude of current

⇒ In cell phone antennas are
monopole
loops
helical
lens

⇒ In the spectrum of a frequency modulated wave
carrier frequency cannot disappear
carrier frequency vanishes when modulation index is large
the number of significant sidebands depends upon modulation index
none of the above

⇒ The first row of the window is called ' Title bar '.
TRUE
FALSE

⇒ (2)₃ + (3)₄ = (?)₅
4
11
none of these
not possible

⇒ In the expression 3 * * 2 ** 4 ** 2 in FORTRAN 77 which exponentiation is performed first
4 * * 2
2 * * 4
3 * * 2
all exponentiation are performed together

⇒ For a system to work, as oscillator the total phase shift of the loop gain must be equal to
90°
45°
270°
360°

⇒ Intrinsic or characteristic impedance of free space has a value of
120 ohm
73 ohm
73 ε ohm
120 ε ohm

⇒ For the infix expression (A/B) * (C * F + (A - D) * E) the corresponding Post fix notation is
A / D * CF AD - F * +
AB / CF * AD - E * + *
AB / C * FAD - E * + *
None of the above

⇒ A discrete time linear shift-invariant system has an impulse response h[n] with h[0] = 1, h[1] = - 1, h[2] - 2, and zero otherwise. The system is given an input sequence x[n] with x[0] - x[2] - 1, and zero otherwise. The number of nonzero samples in the output sequence y[n], and the value of y[2] are, respectively
5, 2
6, 2
6, 1
5, 3

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal

⇒ The number of memory locations in which 14 address bits can access is
1024
2048
4096
16384

⇒ In tape recorder erase head is active during recording.
TRUE
FALSE

⇒

Assertion (A): The horizontal intercept of dc load line is the same as ideal cut off point

Reason (R): When a transistor is in cut off region, collector current is zero

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a CD, the depth and width of each pit is
0.5 μm each
0.5 μm and 1 mm respectively
1 μm and 0.5 mm respectively
1 μm each

⇒ FM is named so because
it restrains the frequency excursions of FM
it increases the frequency excursions of FM
it decreases the amplitude of FM signal
it increases the amplitude of FM signal

⇒ A series R, L, C circuit has R = 2Ω, L = 1H, C = 1 μF. It is connected to an ac variable frequency source of peak voltage 10 V. At resonance the power supplied by the source will be
50 Ω
25 Ω
12.5 Ω
6.25 Ω

⇒ Consider the following statements: In a differential amplifier using JFET, the differential output offset is due to

mismatch between FET parameters
difference in values of resistances used in circuit
variation in supply voltage.

Of the statements, the correct statements are
1 and 2
1, 2, 3
2, 3
1, 3

⇒ Which one of the following is D/A conversion technique?
Successive approximation
Weighted resistor
Dual slope
Single slope

⇒ Materials in order of decreasing electrical conductivity are
aluminium, silver, gold, copper
gold, silver, copper, aluminium
copper, silver, gold, aluminium
silver, copper, gold, aluminium