Question is ⇒ Short circuiting of a cell results in, Options are ⇒ (A) reduced gassing during charging., (B) abnormal high temperature., (C) low specific gravity of the electrolyte., (D) all of the above., (E) , Leave your comments or Download question paper.

Question is ⇒ Short circuiting of a cell results in, Options are ⇒ (A) reduced gassing during charging., (B) abnormal high temperature., (C) low specific gravity of the electrolyte., (D) all of the above., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Short circuiting of a cell results in
A.	reduced gassing during charging. [Wrong Answer]
B.	abnormal high temperature. [Wrong Answer]
C.	low specific gravity of the electrolyte. [Wrong Answer]
D.	all of the above. [Correct Answer]
View Answer 5 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Battery charging equipment should be installed
in well ventilated, clean and dry place.
as near as practical to the battery under charge.
both (a) and (b).
wherever convenient.

⇒ For keeping the lead acid battery terminals free from corrosion it is advisable to
keep electrolyte level low
apply petroleum jelly.
charge the battery at frequent intervals.

⇒ In lead acid batteries, sedimentation occurs due to
idleness foralongeiperiod.
overcharging at slow rate.
overcharging at high rate
slow charging at low rate.

⇒ Which of the following cells is more likely to be damaged due to short circuiting ?
Daniel cell
Dry Cell
Acid cell
Fuel cell

⇒ The capacity of a lead acid battery does not depend upon
charge rate.
discharge rate.
temperature.
density of electrolyte & quantity of active material.

⇒ Internal resistance of primary cell varies
inversely with the distance between electrodes.
inversely with the surface area of electrodes.
directly with the distance between electrodes
with the nature of electrodes.

⇒ Which of the following acts as depolariser in Lechlanche cell ?
MnO₂
NH₄Cl
Mn₂O₃
ZnCI₂

⇒ A battery is connected to a resistance causing a current of 0.5 A in the circuit. The current drops to 0.4 A when an additional resistance of 5 ω is connected in series. The current will drop to 0.2 A when the resistance is further increased by
10 ω
15 ω
25 ω
40 ω

⇒ Common impurity in a battery electrolyte is
dust particles.
iron.
lead crystals.
sodium chloride.

⇒ Overcharging of a lead acid battery would cause
excessive gassing.
loss of active material.
increase in temperature resulting in buckling of plates.
all of the above.

⇒ In a battery, cover is placed over the elements and sealed at the top of the battery container. This is done in order to
exclude dirt and foreign matter from the electrolyte.
reduce evaporation of water from electrolyte.
both (a) and (b).
none of the above

⇒ Short circuiting of a cell results in
reduced gassing during charging.
abnormal high temperature.
low specific gravity of the electrolyte.
all of the above.

⇒ What carries current in an electrolyte
Electrons only
- ve ions only
+ ve ions only
Both + ve and - ve ions

⇒ In a lead acid battery, the level of the electrolyte should be
equal to that of the plates.
below the level of plates.
above the level of plates.
none of the above.

⇒ Rust, scales and oxides can be removed from a surface with the help of
various acids.
alkali and salt solution.
mechanical abrasion.
electrolytic cleaning any of the above.

⇒ Standard cell
will have precise and accurate constant voltage when current drawn from it is few microamperes only.
will have precise and accurate constant voltage when few milliamperes are drawn from it.
will continue to have constant voltage irrespective of loading conditions.
can supply voltages up to 10 V.

⇒ Charging of a sulphated battery at high rate causes
warping of plates.
boiling of electrolyte owing to gassing.
damage to separators, cell caps, covers and battery case due to excessive temperature.
all of the above.

⇒ The emf of a lead battery
increases with the increase in specific gravity of the electrolyte.
slightly increases with the increase in temperature.
decreases with the increase in temperature.
both (a) and (b).

⇒ Vent plug is provided in each lead acid cell to
pour water or electrolyte when needed.
check the electrolyte level.
allow escape out of gases during charging.
all of the above.

⇒ The amount of ions liberated by 96500 C of charge passed through the electrolyte is called ?
Electrochemical equivalent
Chemical equivalent
Gram equivalent
None of these

⇒ In which of the following cells polarisation is the major defect ?
Voltanic cell
Lechlanche cell
Daniel cell
None of these

⇒ First electrochemical cell was designed by
Galvani
Faraday
Lechlanche
None of these

⇒ A floating battery is one
which is charged and discharged simultaneously.
in which battery voltage is equal to charger voltage.
which supplies current intermittently and also during idle period gets charged.
none of the above.

⇒ Who was the first to design storage cell ?
Plante
Galvani
Edison
Volta

⇒ What happens during the charging of acid cell ?
Voltage increases
Energy is given out
Both
None of these

⇒ Oil and grease can be removed from a surface with the help of
soaps.
hot alkaline solutions.
solvents such as gasoline or carbon tetrachioride.
any of the above.

⇒ During electrodeposition. the amounts of different substances liberated by same quantity of electricity are proportional to
atomic weights.
valency.
chemical equivalents.
atomic numbers

⇒ The electric cell is a device to obtain
Electrons
Electric charge
Electric energy from chemical energy
Electric force

⇒ The emf of primary cell depends upon the
physical dimensions of a cell.
nature of electrolyte.
nature of electrode.
both (b) and (c).

⇒ The energy capacity of a storage battery is rated in
kWh.
kW.
ampere hours.
joules.