Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Schrodinger wave equation is a |

A. | linear equation [Wrong Answer] |

B. | differential equation [Wrong Answer] |

C. | partial differential equation [Correct Answer] |

D. | none of the above [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ A single phase cycloconverter with centre tapped input transformer requires

2 thyristors

4 thyristors

8 thyristors

either 2 or 4 thyristors

⇒ Consider the following stateme

1 and 2

1 and 3

2 and 3

3 only

⇒ In figure, secondary winding has 40 turns. For maximum power transformer to 2 ohm resistance the number of turns in primar

20

40

80

160

⇒ In a push pull circuit

each transistor conducts for 180°

each transistor conducts for more than 180° but less than 360°

each transistor conducts for less than 180°

the period of conduction of each transistor depends on circuit configuration

⇒ A stationary process has

all statistical properties independent of time

all statistical properties dependent of time

zero variance

ensemble average equal to time average

⇒ A voltage

*v*= 100 sin ω

*t*+ 10 sin 5 ω

*t*is applied to a pure capacitor having capacitance of 1 μF. If ω = 314 rad/sec, the current through the capacitor is

0.0314 cos 314

*t*+ 0.0157 cos 1570

*t*

0.0314 sin 314

*t*+ 0.0157 sin 1570

*t*

0.0314 cos 314

*t*+ 0.0314 cos 1570

*t*

0.0157 cos 314

*t*+ 0.0157 cos 1570

*t*

⇒ For a resistance of about 15 kΩ operating in a frequency range of a few MHz, the noise voltage is in the range of

a few μV

about 100 μV

a few μV

a few volts

⇒ Which of the following is 'synchronous'?

Half adder

Full adder

R-S flip-flop

Clocked R-S flip-flop

⇒ In a 3 phase full wave regulator feeding resistance load connected in star, the possible range of firing angle a is

0 ≤ a ≤ 180°

0 ≤ a ≤ 150°

0 ≤ a ≤ 120°

0 ≤ a ≤ 90°

⇒ In a bistable multivibrator, commutating capacitors are used to

increase the base storage charge

provide ac coupling

increase the speed of response

alter the frequency of the output

⇒ Bitter powder patterns prove the existence of domains.

TRUE

FALSE

⇒ The circuit shown in figure conv

BCD to binary code

binary to excess-3 code

excess-3 to Gray code

gray to binary code

⇒ Which instrument needs creep compensation?

Dynamometer wattmeter

Induction wattmeter

Energy meter

Both (b) and (c)

⇒ The dynamic resistance of a forward biased

*p*-

*n*diode

varies inversely with current

varies directly with current

is constant

is either constant or varies directly with current

⇒ An open loop system has a forward path transfer function (42.25)/

*s*(

*s*+ 6.5). The unit step response of the system starting from rest will have its maximum value at a time equal to

0 sec

0.56 sec

5.6 sec

infinity

⇒

**Assertion (A):** PIN diode can be used as attenuator and limiter.

**Reason (R):** PIN diode has a thin intrinsic layer.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is correct but R is wrong

A is wrong but R is correct

⇒ CMRR is the ratio of differential voltage gain to common mode gain.

TRUE

FALSE

⇒ In 8086 a word OA 50 FH is stored in 02 and 03 memory locations. Then

OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 02

OFH is stored at location 03 and 0 A 5 at location 02 and address of word in 02

OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 03

OFH is stored at location 03 and 0 A 5 at location 02 and address of word is 03

⇒ In a modified series inverter

the maximum output frequency is less than frequency of damped oscillations

the output frequency can be even higher than the frequency of damped oscillations

the output frequency cannot exceed the frequency of damped oscillations

any of the above

⇒ Transconductance indicates the

control of output voltage by input voltage

control of output current by input voltage

control of input voltage by output current

control of input current by input voltage

⇒ In figure, A is ideal ammeter having zero resistance. It will read __________ amp

2

2.5

3

4

⇒ There are four different algorithms A1, A2, A3 and A4 to solve, a given problem with the complexity order log(n), log(log(n)), n log and n/log(n) respectively. Which is the best algorithm?

A1

A2

A3

A4

⇒ The colour coding of a resistors shows 100 K, ± 10%. When the resistance was measured with an ohmmeter, it read

95 K

80 K

120 K

85 K

⇒ The gain margin for a stable system

has a positive decibel value

has a negative decibel value

has a large negative decibel value

none of the above

⇒ Saturation of iron core causes distortion.

TRUE

FALSE

⇒ If reflection coefficient is 1/5, then corresponding VSWR is given by

1

2

3

42796

⇒ Which is correct for a transfer function?

The poles and zero must be complex

If the poles and zeros are complex or imaginary, they must be conjugate

If the poles and zeros are complex they must be simple

If a zero is imaginary, it must be simple

⇒ Ferrites have

a low copper loss

low eddy current loss

low resistivity

higher specific gravity compared to iron

⇒ Load cell uses

piezoelectric crystal

capacitor

mutual inductance

strain gauge

⇒ To measure an emf by dc potentiometer it is necessary to standardise the potentiometer with the help of a standard cell.

TRUE

FALSE