Question is ⇒ Saturation region of a JFET is also known as, Options are ⇒ (A) source region, (B) analog region, (C) pinch off region, (D) ohmic region, (E) , Leave your comments or Download question paper.

Question is ⇒ Saturation region of a JFET is also known as, Options are ⇒ (A) source region, (B) analog region, (C) pinch off region, (D) ohmic region, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Saturation region of a JFET is also known as
A.	source region [Wrong Answer]
B.	analog region [Wrong Answer]
C.	pinch off region [Wrong Answer]
D.	ohmic region [Correct Answer]
View Answer 1 -11 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): FM requires more bandwidth than AM

Reason (R): Wide band FM is used for broadcast transmissions.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒ Consider the following materials

Nickel
Silver
Oxygen
Aluminium

The correct sequence in the order of decreasing permeability is
1, 4, 3, 2
1, 4, 2, 3
4, 1, 3, 2
4, 1, 2, 3

⇒ The different channels in a TDM receiver are separated by
integration
differentiation
AND gate
OR gate

⇒ Which one of the following is the correct statement? The region of convergence of z transform of x[n] consists of the values of z for which x[n] r^-n is
absolutely integrable
absolutely summable
unity
< 1

⇒ For decimal numbe'r 13.5, the floating point representation in 4 byte excess 128 code is
01101100 00000000 00000000 10000100
00000000 01101100 00000000 10000100
00000000 01101100 10000100 00000000
01101100 00000000 10000100 00000000

⇒ In end fire array the principle direction of radiation
is perpendicular to the array axis
is perpendicular to the array axis and also to the plane containing the array elements
coincides with the direction of the array
is at 45° to the direction of array axis

⇒ Figure represen
Tunnel diode
Zener diode
Photo diode
Photo sensitive diode

⇒ A (75 - J50) ohm load is connected to a coaxial of Z₀ = 75 ohm at 10 GHz. The best method of matching is to connect
an inductance at load
a short circuited stub at load
a short circuited stub at specific distance from load
a capacitance at specific distance from load

⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ A parity check usually can detect
one-bit error
double-bit error
three-bit error
any-bit error

⇒ Which of the following terms are equivalent?

A ⊕ B ⊕ C
A ⊕ B ⊙ C
A ⊙ B ⊕ C
A ⊙ B ⊙ C

1 and 4; 2 and 3
1 and 3
2 and 3
1, 2 and 4

⇒ In 8085 microprocessor, an active low signal INTA is not needed from up service which of the following interrupt requ
TRAP
INTR
RST 7.5
RST 5.5

⇒ In a CD the sampling frequency is nearly
half the highest frequency in audio signal
equal to highest frequency in audio signal
double the highest frequency in audio signal
four times the highest frequency in audio signal

⇒ What does the B register contain after the first MOV B, A has been executed?
40 H
60 H
80 H
80 D

⇒ Accumulator is an 8 bit register and is also known as register B.
TRUE
FALSE

⇒ Calculate the resistivity of n-type semiconductor from the following data, Density of holes = 5 x 10¹² cm^-3. Density of electrons = 8 x 10¹³ cm^-3, mobility of conduction electron = 2.3 x 10⁴ cm²/ V-sec and mobility of holes = 100 cm²/V-sec.
0.43 Ω-m
0.34 Ω-m
0.42 Ω-m
0.24 Ω-m

⇒ A clamper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ The signal to noise ratio in telemetry should be better than
5 db
10 db
25 db
60 db

⇒ In a shift register the data is loaded in one operation but shifted out one bit at a time, The shift register is
serial in-serial out
parallel in-serial out
serial in-parallel out
parallel in-parallel out

⇒ Two passive elements are connected in series and a dc voltage is applied to the circuit. The time variation of the current is shown in figure. The two elements
one resistance and the other inductance
both resistances
one inductance and the other capacitance
one resistance and the other capacitance

⇒ The signals in 8086 are in maximum mode when
MN / MX pin is tied to V_cc
MN / MX Pin is grounded
MN / Mx pin is left open
none of the above

⇒ Which of the following photodetector does not provide gain?
Phototransistor
Photoconductor
Avalanche photodiode
p-i-n photodiode

⇒ Which of the following devices is a 'hot-electron' diode?
Thermionic tube diode
Schottky-Barrier diode
Thomson-Deletion diode
Thermal electron diode

⇒ In a two stage CE amplifier circuit, the ac collector resistance of the first stage depends on
load resistance
input impedance of first stage
input impedance of second stage
all of the above

⇒ In a 100% amplitude modulated signal, the power in the upper sideband when carrier power is to be 100 W and modulation system SSBSC, is
100 W
66 W
50 W
25 W

⇒ A loop antenna may be of
square on triangular shape
hexagonal shape
circular shape
any of the above

⇒ One can format a disc using window explorer.
TRUE
FALSE

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_B
24 μA
23 μA
20 μA
10 μA

⇒ The O/P char, of a FET is given in the figure. In which region is the device biased for small signal amplificat
AB
BC
CD
BD