Question is ⇒ RTD is generally suitable for temperature up to, Options are ⇒ (A) about 800°C, (B) about 1500°C, (C) about 200°C, (D) about 50°C, (E) , Leave your comments or Download question paper.

Question is ⇒ RTD is generally suitable for temperature up to, Options are ⇒ (A) about 800°C, (B) about 1500°C, (C) about 200°C, (D) about 50°C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	RTD is generally suitable for temperature up to
A.	about 800°C [Correct Answer]
B.	about 1500°C [Wrong Answer]
C.	about 200°C [Wrong Answer]
D.	about 50°C [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ j⁶ =
j
j²
j³
- j

⇒ The scaling factor of an MOS device using constant voltage scaling model, the gate area of the device will be scaled as
1/a
1/a²
1/a³
1/a⁴

⇒ Which of the following statement is false?
A stationary process is always a ergodic process
A ergodic process is always a stationary random process
It is possible to have a stationary random
None of the above

⇒ Figure shows a parallel resonant circuit having resonance frequency of 15 MHZ. At this frequ
its impedance is minimum
its impedance is maximum
its impedance is infinite
its impedance is zero

⇒ For a 400 kHz transmission line having L = 0.5 mH/km, C = 0.08 mF and negligible R and G, the velocity propagation will be
15.8303 km/s
15.830 km/s
1.583 km/s
0.1583 km/s

⇒ The characteristics of which device has peak point and valley point
SCR
PUT
SCS
Shockley diode

⇒ PIL colour picture tube has the main advantage that
it is cheap
it ensures purity in colour
it is self convergent
both (a) and (b)

⇒ Binary multiplication can be done by repeated addition.
TRUE
FALSE

⇒ In the signal flow graph of the given figure, the number of forward path
1
2
3
4

⇒ The primary function of a clamper circuit is to
suppress variations in signal voltage
raise +ve half cycle to the signal
Lower -ve half cycle of the signal
introduce a dc level into an a.c. signal

⇒ Wave A = 100 sin ωt and wave B = 100 cos ωt. Then
rms values of the two waves are equal
rms values of A is more than that of B
rms values of A is less than that of B
rms values of the two waves may or may not be equal

⇒ In hexadecimal number system, A is equal to decimal number
10
11
17
18

⇒ Two ammeters A and B both 0-10 A have internal resistance of 1 Ω and 0.5 Ω respectively. They are connected in parallel. If total current is 15 A, then
I_A = I_B = 7.5 A
I_A = 5 A, I_B = 10 A
I_A = 10 A, I_B = 5 A
I_A = 9 A, I_B = 6 A

⇒ Threshold of perception occurs at a current of about 1 mA.
TRUE
FALSE

⇒ Find V_th in the cir
100 V
10 V
0 V
5 V

⇒ At a temperature of about 1 K, aluminium is a
conductor
insulator
photoconductor
superconductor

⇒ In a Hurwitz polynomial
all coefficients are non-negative
the coefficients may be positive or negative
all coefficients are negative
all coefficients are non-negative and all zeros should be either in left half plane or simple on the imaginary axis

⇒ The most widely used LC oscillator is
Hartley oscillator
Crystal oscillator
Colpitt's oscillator
Clapp's oscillator

⇒ The mobility of e^- for Ge and Si respectively is
1.66, 2.5
2.5, 1.66
2.7, 2.33
2.33, 2.7

⇒ A Hall effect transducer has K_H = - 1 x 10^-8. If B = 1 Wb/m², I = 3 A and bismuth slab is 2 mm wide, the Hall voltage is
-7.5 x 10^-6 V
-15 x 10^-6
-20 x 10^-4 V
-22.5 x 10^-4 V

⇒ The on voltage and forward breakover voltage of an SCR depend on
gate current alone
band gap of semiconductor alone
gate current and semiconductor band gap respectively
semiconductor band gap and gate current respectively

⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance

⇒ Indicate the false statement: If SWR on a transmission line is infinite, the line is terminated in
open circuit
short circuit
pure reactance
complex impedance

⇒ In the expression 3 * * 2 ** 4 ** 2 in FORTRAN 77 which exponentiation is performed first
4 * * 2
2 * * 4
3 * * 2
all exponentiation are performed together

⇒ For the circuit, let us assume that R = 1 Ω, L = 10^-3 H, and V(t) = 10 cos (1000t + 30°)V and the differential equation for I(t) is give
7.07 cos (1000t + 15°) A
70.7 cos (1000t - 30°) A
7.07 cos (1000t - 15°) A
7.07 cos (1000t + 15°) A

⇒ Maximum efficiency of class B power amplifier is 50%.
TRUE
FALSE

⇒ Analysis of EM wave in waveguide based on
circuit theory
field theory
optical theory
both (a) and (b)

⇒

Assertion (A): For a dielectric, P = ∈₀(∈_r - 1) E.

Reason (R): Dipole moment per unit volume is called polarization of dielectric.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ If input frequency is 50 Hz, the frequency of output wave in a half wave diode rectifier circuit is
25 Hz
50 Hz
100 Hz
200 Hz

⇒ In the signal flow graph in the given figure the number of forward paths and pairs of non-touching loops are respecti
3 and 1
3 and 2
4 and 2
2 and 4