Question is ⇒ ROC of sequence x[n] = δ[n] is, Options are ⇒ (A) Not exist, (B) z = 0, (C) Entire Plane, (D) Entire Plane expect z = 0, z = ∞, (E) , Leave your comments or Download question paper.

Question is ⇒ ROC of sequence x[n] = δ[n] is, Options are ⇒ (A) Not exist, (B) z = 0, (C) Entire Plane, (D) Entire Plane expect z = 0, z = ∞, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	ROC of sequence x[n] = δ[n] is
A.	Not exist [Wrong Answer]
B.	z = 0 [Wrong Answer]
C.	Entire Plane [Correct Answer]
D.	Entire Plane expect z = 0, z = ∞ [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then find the width of major lobe
60
50
51.25
None of the above

⇒ Brewster angle is the angle for which there is
no reflection and the incident wave is vertically polarized
reflection and the incident wave is horizontally polarized
no reflection and the incident wave is horizontally polarized
none of the above

⇒ A MOD - 2 counter, the FF has a t_pd = 60 nsec. The NOR gate has a t_pd of 30 nsec. The clock frequency is
37 MHz
40 MHz
111 MHz
none

⇒ Zero bias works only with
D MOSFETs
E MOSFETs
both D and E MOSFETs
neither D nor E MOSFETs

⇒ In a JFET avalanche breakdown occurs when V_DS = 22 V and V_GS = 0. If V_GS = -1 V, the avalanche breakdown will occur at
V_DS = 22 V
V_DS more than 22 V
V_DS equal to or more than 22 V
V_DS less than 22 V

⇒ The function to Calculate the maximum value in the specified field of a database is
DM
DMAX
MAX
DBMAX

⇒ A communication channel with additive white Gaussian noise, has a bandwidth of 4 kHz and an SNR of 15. Its channel capacity is
1.6 kbps
16 kbps
32 kbps
256 kbps

⇒ The number FF in hexadecimal system is equivalent to number __________ in decimal system.
256
255
240
239

⇒ In 8085
the upper 8 address bits appear on address bus and lower 8 bits on address data bus
the lower 8 address bits appear on address bus and the upper 8 address bits appear on address data bus
either upper or lower 8 address bits may appear at address bus
either upper or lower 8 address bits may appear at address data bus

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ An image uses 512 x 512 picture elements. Each of the picture elements can take any of the 8 distinguishable intensity levels. The maximum entropy in the above image will be
2097152 bits
786432 bits
648 bits
144 bits

⇒ An electromechanical closed loop control system has the following characteristics equation :s³ + 6Ks² + (K + 2)s
K = 0.528
K = 2
K = 0
K = -2528

⇒ The receiver of a pulsed RADAR can detect signal power in the order of
1 W
0.1 W
10^-5 W
10^-12 W

⇒ A steel bar needs 1200 AT to magnetise it. The voltage that must be applied to the magnetising coil of 100 turns and 10 Ω resistance is __________ volt.
120
12
1200
10

⇒ If X = 2.5 and Y = 2.5, which of the following expressions would give the result as 5/7?
X + 2.5 / Y + 3.0
(X + 2.5) / Y + 4.5
(X + 2.5) / (Y + 4.5)
(X + 2.5) / Y + 3.5

⇒ An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
AM-DSB signal with suppressed carrier
AM-DSB signal with carrier
AM-SSB signal with carrier
a sequence of exponentially decaying sine waves

⇒ Which one of the following materials is used for making permanent magnets?
Steel
Carbon
Carbon-Steel
Graphite

⇒

Match the following:

	List I (BHE, A0)		List II (Word is read/write)
A.	0, 0	1.	1 byte from/to odd address
B.	0, 1	2.	1 byte from/to even address
C.	1, 0	3.	16 bit word
D.	1, 1	4.	None

A-1, B-2, C-3, D-4
A-3, B-1, C-2, D-4
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3

⇒ As frequency increases, the transmission efficiency
decreases
increases
is not affected
either (a) or (c)

⇒

Assertion (A): The condition of minimum distortion in a transmission line is L = RC/G.

Reason (R): Line loading means addition of inductance to satisfy the condition L = RC/G.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The drain characteristics of JFET are drawn between
V_GS and V_DS for different values of drain current
drain current and V_GS for different values of V_DS
drain current and V_DS for different values of V_GS
drain current and V_GSfor one value of V_DS

⇒ A thyristor circuit is feeding an R-L load. The turn on time can be reduced by
decreasing R
decreasing L
increasing L
decreasing R and L together

⇒ What will be minimum conversion rate in 6 bit dual slope A/D converter uses a reference of -6v and a 1 MHz clock. It uses a fixed count of 40 (101000).
9000
9259
1000
1000

⇒ The range of value "a" for which system will be stable. If impulse response of DT system is = aⁿ ∪[n]
a > 1
a < 1
1 < a < ∞
-1 < a < 1

⇒ The ac bridge in figure is balanced. Z₁ = 100∠30°, Z₂ = 150∠0°, Z₃ = 250∠ - 40° Then Z_{4375∠70° Ω
375∠ - 70° Ω
150∠0° Ω
150∠20° Ω}

⇒ Which of the following is not a semiconductor?
Silicon
Calcium arsenide
Germanium
Zinc sulphide

⇒ A diode peak reading VTVM and thermocouple meter are connected across output of an amplitude modulated circuit. In the absence of modulation both meters read 10 V. When sinusoidal AM is applied, VTVM reads 15V The reading of thermocouple meter will be
10 V
12.5 V
14.1 V
15 V

⇒ The colour code on a carbon resistor is red-red-black-silver. The value of resistor is
22000 Ω
2200 Ω
22 ± 5% Ω
22 ± 10% Ω

⇒ In a coupled coil the primary has 100 turns and secondary has 200 turns. The primary produces, a flux Φ = e^-t. The coefficient of coupling is 1. The voltages induced in secondary is
200 e^-t V
200 e^t V
200 V
none of the above

⇒ A single phase electric heater uses phase controlled thyristors. The firing angle is 90°. The degree of heating is
25% of maximum
50% of maximum
75% of maximum
none of the above