Question is ⇒ Resistivity of copper is nearly, Options are ⇒ (A) 1.56 μ ohm-cm, (B) 3.95 μ ohm-cm, (C) 14.55 μ ohm-cm, (D) 22.05 μ ohm-cm, (E) , Leave your comments or Download question paper.

Question is ⇒ Resistivity of copper is nearly, Options are ⇒ (A) 1.56 μ ohm-cm, (B) 3.95 μ ohm-cm, (C) 14.55 μ ohm-cm, (D) 22.05 μ ohm-cm, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Resistivity of copper is nearly
A.	1.56 μ ohm-cm [Correct Answer]
B.	3.95 μ ohm-cm [Wrong Answer]
C.	14.55 μ ohm-cm [Wrong Answer]
D.	22.05 μ ohm-cm [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In calculating output impedance of an amplifier the source is replaced by an open circuit.
TRUE
FALSE

⇒ The v-i characteristics of a diode may be linear or non linear.
TRUE
FALSE

⇒ In the forward blocking region of a silicon, controlled rectifier, the SCR is
in the off-state
in the ON state
reverse biased
at the point of breakdown

⇒ CATV stands for
Common Antenna Television
Community Antenna Television
Cable Antenna Television
Channel Antenna Television

⇒

Assertion (A): A demultiplexer can be used as a decoder.

Reason (R): A demultiplexer can be built by using AND gates only.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In Schering bridge, the potential of detector above earth potential is about
a few volts
10 kV
1000 V
either (a) or (b)

⇒ A super heterodyne receiver has an input circuit tuned to a 570 KHz signal. If the intermediate frequency of the amplifier is tuned to 455 KHz. The quality factor Q for a Image Rejection ratio of 125?
100
56.81
42.74
87

⇒ Find R_L for maximum power tran
3 Ω
1.125 Ω
4.17 Ω
none

⇒ Quantization noise occurs in
PAM
DM
PWM
PPM

⇒ Which one of following is correct for broadside array?
Direction of radiation is perpendicular to axis
Also perpendicular to the plane
Current is fed of equal amplitude equal phase
All

⇒ Which of the following are needed both for protection and metering?
Wattmeters
Instrument transformers
Energy meters
Power factor meters

⇒

Match the following:

	List I		List II
A.	T (Reflection coefficient) = 0	1.	(Z_L - Z_o)/(Z_L + Z_o)
B.	T = - 1	2.	Z_L = Z_o
C.	T = + 1	3.	Z_L = 0
D.	- 1 < T < + 1	4.	Z_L = ∞

A-2, B-3, C-4, D-1
A-2, B-4, C-1, D-3
A-1, B-2, C-3, D-4
A-3, B-2, C-4, D-1

⇒ For a superconductor, magnetisation M in a field H is
extremely small
- H
- I
zero

⇒ A directional coupler is used
to transmit microwave signals
to generate microwave signals
to measure amplitude and phase of a travelling wave
both (a) and (b)

⇒

Match the following:

	List I		List II
A.	loop antenna	1.	flat line
B.	folded dipole	2.	300 W
C.	SWR of 1	3.	sharp broadside full
D.	VHF band	4.	30 to 300 MHz

A-1, B-4, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ Nickel is a non-magnetic material.
TRUE
FALSE

⇒ An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ and output resistance of 2.5 kΩ. The input resistance of the current shunt -ve feedback amplifier using the above amplifier with a feedback factor of 0.2 is
1/11 kΩ
1/5 kΩ
5 kW
11 kW

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected ignoring shadows, what are the RAM locations?
(4000)_H - (40FF)_H
(8000)_H - (80FF)_H
(8000)_H - (40FF)_H
Any of the above

⇒ An input voltage V(t) = 10 2 cos (t + 10°) + 10 3 cos (2t + 10°)V is applied to a series combination of resistance R = 1 kΩ inductance L = 1H. The resulting steady-state current i(t) in ampere is
10 cos (t + 55°) + 10 cos (2t + 10° tan^-12)
10 cos (t + 55°) + 103/2 cos (2t + 55°)
10 cos (t - 35) + 10 cos (2t + 10° - tan^-12)
10 cos (t - 35) + 103/2 cos (2t + 35°)

⇒

Assertion (A): Megger is used to check insulation resistance of cables.

Reason (R): Insulation resistance of cables is very high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ Which of the following devices uses a slow wave structure?
Klystron two cavity amplifier
Klystron multicavity amplifier
Reflex klystron oscillator
TWT

⇒ A transmission line has a characteristic impedance of 50 Ω and a resistance of 0.1 Ω/m, if the line is distortion less, the attenuation constant (in Np/m) is
500
5
0.014
0.002

⇒ What will be conversion rate for a counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time
125
125 x 10³
125 x 10⁶
None

⇒ Which of the following is not a special purpose peripheral?
Programmable DMA controller
Programmable Floppy disc controller
Programmable Hard disc controller
Programmable CRT controller

⇒ EEPROM is also known as
UVPROM
EAPROM
both UVPROM and EAPROM
none of the above

⇒ In the basic series inverter circuit, the source supplies load
only in positive half cycle
both in positive and negative half cycles
only in part of positive half cycle
in positive half cycle and part of negative half cycle

⇒ Which of the following is used in automatic control of street lights?
Thermistor
Photoconductor
Transistor
Varistor

⇒ The magnitude of transport lag factor is always zero.
TRUE
FALSE

⇒ If the open-loop transfer function is a ratio of a numerator polynomial of degree 'm' and a denominator polynomial of degree 'n', then the integer (n - m) represents the number of:
breakaway points
unstable poles
separate root loci
asymptotes

⇒ For a 12 pulse operation, the two 6 pulse units are fed by
Y - Y and Y - Y transformers
Δ - Δ and Δ - Δ transformers
Y - Y and Y - Δ transformers
Y - Δ and Y - Δ transformers