Question is ⇒ Resistivity of copper is lower than that of nickel. When a small percentage of copper is added to nickel, the resistivity, Options are ⇒ (A) increases, (B) decreases, (C) may increase or decrease, (D) remains the same, (E) , Leave your comments or Download question paper.

Question is ⇒ Resistivity of copper is lower than that of nickel. When a small percentage of copper is added to nickel, the resistivity, Options are ⇒ (A) increases, (B) decreases, (C) may increase or decrease, (D) remains the same, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Resistivity of copper is lower than that of nickel. When a small percentage of copper is added to nickel, the resistivity
A.	increases [Correct Answer]
B.	decreases [Wrong Answer]
C.	may increase or decrease [Wrong Answer]
D.	remains the same [Wrong Answer]
View Answer 6 -4 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The clock shown in figure has a frequency of 6 MHz. The frequency of the Q output wil
12 MHz
24 MHz
3 MHz
1.5 MHz

⇒ The main drawback in the performance of shunt peaked wide band amplifier is
two low gain at low frequency
poor phase response
reduce frequency at middle frequency
that the maximum gain of the stage is small

⇒ In intrinsic semiconductors, the number of free electrons is equal to the number of mobile holes.
TRUE
FALSE

⇒ A dc machine has 6 poles all connected in series. Each pole has 9 H inductance and field current is 2 A. Total inductance and total energy stored are
9 H and 18 J
18 H and 36 J
54 H and 108 J
108 H and 216 J

⇒

Assertion (A): The function ke^st with both σ and ω positive and s > 0 depicts a sinusoid whose amplitude increases with time.

Reason (R): If σ = 0, ke^st becomes a sinusoid.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The power dissipated in 4 Ω resistance in figur
64 W
32 W
16 W
8 W

⇒ A radio wave is incident on a layer of ionosphere at an angle of 30° with the vertical. If the critical frequency is, 1.2 MHz, the maximum usable frequency is
1.2 MHz
2.4 MHz
0.6 MHz
1.386 MHz

⇒ The word 'LORAN' means
long range navigation
long range TV transmission
long range cable transmission
either (b) or (c)

⇒ In a series inverter
the commutating elements carry full load current
the commutating elements carry upto 50% of load current
the commutating elements do not carry load current
any of the above

⇒ The frequency response of an ideal tuned amplifier should be as represented in figur
A
B
C
D

⇒ A transmission line terminates in two branches, each of length λ/4, as shown. The branches are terminated by 50Ω loads. The lines are lossless and have the characteristics impedances shown. Determine the impedance Z₁ as seen by the so
200Ω
100Ω
50Ω
25Ω

⇒ For an amplifier, the coupling method which gives the highest gain in
impedance coupling
transformer coupling
capacitance coupling
resistance coupling

⇒

Assertion (A): In the circuit shown figure the diode is used to protect the active devices. Transistor T goes into saturation when a positive pulse is applied at base and non conducting

Reason (R): When the current in an inductor is suddenly stopped, a high voltage is induced across
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ What is the direction of address
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into up and some others out of μp

⇒

Assertion (A): An ac amplifier uses coupling capacitors at input and output

Reason (R): The capacitive reactance varies inversely with frequency. It is infinite for dc

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Surface impedance at high frequencies is a consideration for
ferrites
semiconductors
good conductors
dielectrics

⇒ In a phase shifting transformer the currents in the two stator winding are in phase.
TRUE
FALSE

⇒ Consider the following program for 8085 Adds decimal number 5 to contents of memory
Subtracts decimal number 5 from contents of memory
Subtracts decimal number 15 from contents of memory
Adds decimal number 15 to contents of memory

⇒ A typical signal strength received from a geosynchronous communication satellite is of the order of a few
milliwatts
kilowatts
picowatts
watts

⇒ Following figure is a signal conditioning Amplifier, changes gain depending upon the polarity of V_s. What will be circuit voltage gain for + V_s and for - V_s if D₂ is id
A_V = -R₃/R₁
R₃/R₁
R₁/R₃
1 + R₃/R₁

⇒ Silicon and germanium are elements in the
second column of periodic table
third column of periodic table
fourth column of periodic table
fifth column of periodic table

⇒ In a cable with ∈_r = 4, the wave velocity is
3 x 10⁸ m/s
0.75 x 10⁸ m/s
1.5 x 10⁸ m/s
10⁸ m/s

⇒ A square corner reflector is used in which of the following?
TV broadcast
Point-to-point communication
Radio astronomy
All of the above

⇒ In a JFET, the drain current is maximum when
V_GS = 0
V_GS is not zero but is slightly negative
V_GS is negative
V_GS is negative and equal to V_DS

⇒ If operator 'a' = 1 ∠120° then (1 - a) =
3
3 ∠ - 30°
3 ∠ + 30°
3 ∠60°

⇒ For TM waves in a parallel plate waveguide, the minimum attenuation arising from imperfect conductors would occur at a freq. of (f_c is the cut off frequency)
3 f_c
3 f_c
2 f_c
2 f_c

⇒ Current derating may be necessary when thyristors are operating in
series
parallel
series or parallel
none of the above

⇒ The relation between thermionic emission current and temperature is known as
Richardson Dushman equation
Langmuir child law
Ohm's law
Boltzmann's law

⇒ In a material, the Fermi level is located between the centre of the forbidden band and the conduction band. Then what is that material?
A p-type semiconductor
An n-type semiconductor
An intrinsic semiconductor
An insulator

⇒ If 1 kVA transformer is used for all of the following rectifiers, the d.c. power availability will be least in case of
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier