Question is ⇒ RAM can be expanded to, Options are ⇒ (A) increase word size, (B) increase word number, (C) either increase word size or increase word number, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ RAM can be expanded to, Options are ⇒ (A) increase word size, (B) increase word number, (C) either increase word size or increase word number, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	RAM can be expanded to
A.	increase word size [Wrong Answer]
B.	increase word number [Wrong Answer]
C.	either increase word size or increase word number [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is true for RC impedance?
The lowest critical frequency is a pole
The lowest critical frequency is zero
The lowest critical frequency may be pole or zero
The lowest critical frequency is a pole but cannot be at s = 0

⇒ A bridge rectifier circuit has input of 50 Hz frequency. The load resistance is R_L and filter capacitance is C. For good output wave shape, the time constant R_LC should be at least equal to
10 ms
20 ms
50 ms
100 ms

⇒ When a diode is not conducting, its bias is
forward
zero
reverse
zero or reverse

⇒ Entropies associated with an extremely unlikely message and that with an extremely likely message are respectively
0 and 0
1 and 1
1 and 0
0 and 1

⇒ If the average power of radar transmitters is 2 kW and the peak power of the transmitter is 1000 kW, what will be the duty cycle?
0.002
0.02
0.001
0.01

⇒ For a given magnetic material operating in linear mode B = 0.06 T. Assume permeability = 51, then magnetization is:
44836 A/m
46834 A/m
946 A/m
936 A/m

⇒ In a linear op-amp circuit
the product of gain and bandwidth is constant
input can be dc only
input can be ac only
saturation may occur

⇒ The first and second subscripts in models of circular waveguides depict
the number of full sine wave variations in circumference in direction and Bessel function variations in radial direction respectively
the Bessel function variations in radial direction and the number of full sine wave variations in circumference direction respectively
the Bessel function variations in circumference direction and number of full sine wave variations in radial direction respectively
none of the above

⇒ The binary sum of 111010₂ and 11011₂ is
1010101₂
1011001₂
1011101₂
1111111₂

⇒ The pre-emphasis circuit is used
prior to modulation
after demodulation
for low frequency components of the signal
none of the above

⇒ Which of the following contributes to harmonics distortion in amplifiers?
Positive feedback
Presence of noise
Defective active device
Non-linearity in active device

⇒ For maximum output the width of air gap of audio head should be
equal to wavelength
half the wavelength
one quarter the wavelength
very small as compared to wavelength

⇒ Consider the following program for 8085 decimal 20
decimal 40
decimal 10
none of the above

⇒ Which of the following is not an application software?
MS Word
DBMS
Worksheet
Lisp

⇒ The number of channels available in MF band (300 kHz - 3 MHz) for AM modulating signal of 20 kHz is
70
67
100
150

⇒ A current source inverter has simple commutation circuit.
TRUE
FALSE

⇒ A flip-flop circuit is
monostable
bistable
multistable
unstable

⇒ Leakage current approximately doubles for every 10°C increase in the temperature of a transistor has I_CBO = 400 nA at 25°C, then its leakage current at 80°C
10 μA
18 μA
20 μA
15 μA

⇒ A parallel in-parallel out shift register can be used to introduce delay in digital circuits.
TRUE
FALSE

⇒ For graph of figure, one set of fundamental cutsets woul
abc, cde, afe
afde, afe, abdc
cbfe, afe, bdf
cbd, adbe, cde

⇒ In a 3 phase bridge inverter, the gating signals for the three phases have a phase difference of
120°
60°
240°
any of the above

⇒ In an n channel JFET, V_GS = V_GS(off). Then
I_D is zero
I_D may be zero or positive
I_D is positive
I_D may be zero or negative

⇒ A narrow band FM does not have the following feature
it has two sidebands
both sideband equal in magnitude
both sideband have same Phase Difference
it does not show Amplitude variation

⇒ Which of the following parameters is not specified for digital ICs?
Gate dissipation
Propagation delay
Noise margin
Bandwidth

⇒ An RC series circuit is charged by a voltage E. After a long time the battery is removed and a short circuit is placed across R-C. Then
the polarity of voltage across R is same during discharge and during charge
the polarity of voltage across R during discharging is opposite to that during charging
the polarity of voltage across R depends on time constant RC
none of the above

⇒ A linear time-invariant, causal continuous time system has a rational transfer function with simple poles at s = - 2 and s = - 4, and one simple zero at s = - 1. A unit step u(t) is applied at the input of the system. At steady state, the output has constant value of 1. The impulse response of this system is
[exp (- 2t) + exp (-4t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t) - exp (-t)] u(t)
[-4 exp (- 2t) + 12 exp (-4t)] u(t)
[-0.5 exp (- 2t) + 1.5 exp (-4t)] u(t)

⇒ The z transform of sequence x[n] = {2, 4, 3, 2}
2z^-1 + 4z^-2 + 3 + 2z⁺¹
2z^-1 + 3 + 4z⁺¹ + + 2z⁺²
2z⁺¹ + 3z^-1 + 4z^-2 + 2z^-3
3 + 2z^-1 + 4z^-2 + 2z^-1

⇒ A thermal power plant has an efficiency of 0.4. If 0.6 kg of coal is burnt to generate 1 kWh, the calorific value of coal is
about 3500 kcal/kg
about 2500 kcal/kg
about 1500 kcal/kg
about 7500 kcal/kg

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ Consider the following statements:

The positiveness of coefficients of characteristic equation is necessary as well as sufficient condition for stability of first and second order systems.
The positiveness of coefficients of characteristic equation ensures negativeness of real roots but is not sufficient condition for stability of third and higher order systems.

Out of above statements:
only 1 is correct
both 1 and 2 are correct
only 2 is correct
both are wrong