Question is ⇒ Radiation resistance of an antenna is 54 Ω and loss resistance is 6 Ω. If antenna has power gain of 10, then directivity is:, Options are ⇒ (A) 9, (B) 11.11, (C) data not sufficient, (D) 10, (E) , Leave your comments or Download question paper.

Question is ⇒ Radiation resistance of an antenna is 54 Ω and loss resistance is 6 Ω. If antenna has power gain of 10, then directivity is:, Options are ⇒ (A) 9, (B) 11.11, (C) data not sufficient, (D) 10, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Radiation resistance of an antenna is 54 Ω and loss resistance is 6 Ω. If antenna has power gain of 10, then directivity is:
A.	9 [Wrong Answer]
B.	11.11 [Correct Answer]
C.	data not sufficient [Wrong Answer]
D.	10 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The noise temperature of sky is about __________ °K.
100
273
0
30

⇒ The V MOS can handle __________ currents than a conventional MOSFET.
much lower
almost same
almost half
much larger

⇒ Diffraction of EM waves
arises only with spherical wave front
may occur around the edge of an obstacle
occurs when waves pass through a big slot
none of the above

⇒ In Modulation, "carrier" is
resultant wave
speech voltage to be transmitted
voltage with constant frequency, phase or amplitude
voltage for which frequency, phase or amplitude is varied

⇒ In high frequency region, an amplifier behaves like a
band pass filter
low pass filter
high pass filter
any of the above

⇒ If A is 1011, A" is
1011
100
1100
1010

⇒ If the amplitude of the voltage is kept constant, but its frequency is raised to 6 kHz, the new deviation will be for the modulation index is, if f_m = 500 Hz, Δf = 2.25
6 kHz
12 kHz
27 kHz
54 kHz

⇒

Assertion (A): In AM carrier component remains constant in amplitude and frequency.

Reason (R): In AM the two side bands are images of each other.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In 8085, out of interrupts given below, one particular interrupts is quite different from others, This interrupt is
RST 5.5
RST 6.5
RST 7.5
none of these

⇒ Consider the following statem
1 alone
2 alone
3 alone
1 and 3

⇒ The range of RTD using platinum is about
-100° C to 700°C
-200°C to 1000°C
100°C to 1000°C
about 500°C

⇒ If the mantissa of a digital computer is 37 bit long then the accuracy of the digital computer will be of
37 decimal places
23 decimal places
11 decimal places
accuracy is independent of the length to mantissa

⇒ Which of the following parameters is not specified for digital ICs?
Gate dissipation
Propagation delay
Noise margin
Bandwidth

⇒ In an Anderson bridge the unknown inductance is measured in terms of
known inductance and resistance
known inductance
known capacitance and resistance
known capacitance

⇒ The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply of frequency of
30 kHz
15 kHz
5 kHz
20 kHz

⇒ The accuracy of measurement by ohmmeter is very good.
TRUE
FALSE

⇒ A resistance R, inductance L and capacitance C are in series. The source frequency is adjusted to be equal to resonant frequency. The lower half power frequency is ω₁. Another resistance R is added in series with the circuit. The new lower half power frequency will be
ω₁
less than ω₁
more than ω₁
either more than ω₁ or less then ω₁

⇒ In the Taylor series expansion of exp(x) + sin(x) about the point x = p, the coefficient of (x - p)² is
exp (p)
0.5 exp (p)
exp (p) + 1
exp (p) - 1

⇒ Words having 8 bits are to be stored into computer memory. The number of lines required for writing into memory are
1
2
4
8

⇒ In figure, E = 1 V (rms value). The average power is 250 mW. Then phase angle between E and
90°
60°
45°
30°

⇒ Reflex klystron oscillator is essentially a low power device
TRUE
FALSE

⇒ In a transistor with normal bias
the emitter junction has a low resistance
the emitter junction has a very high resistance
the emitter junction supplies majority carries into the base region
none of the above

⇒ In a D latch
a high D sets the latch and low D resets it
a low D sets the latch and high D resets it
race can occur
none of the above

⇒ The energy of constant-amplitude complex valued exponential sequence is __________ (where A is the constant amplitude)
0
1
∞
A²

⇒ The oscillator shown in figure
Clapp oscillator
R-C Phase shift oscillator
Hartley oscillator
Colpitt's oscillator

⇒ In a series R-L-C circuit at the resonant frequency the
current is maximum
current is minimum
impedance is maximum
voltage is maximum

⇒ To prevent overloading in the last IF amplifier one should use
variable sensitivity
squelch
double conversion
variable selectivity

⇒ A 4 bit ripple counter is in 0000 state. The clock pulses are applied and then removed. The counter reads 0011. The number of clock pulses which have occurred are
3
3 or 19
3 or 19 or 35
none of the above

⇒ Which of the following is a valid integer constant?
17
-18.58
101.14
-810

⇒ When a p-n-p transistor is properly biased to operate in active region the holes from emitter.
diffuse through base into collector region
recombine with electrons in base
recombine with electrons in emitter
none of the above