Question is ⇒ Radiation resistance for wire antenna is, Options are ⇒ (A) 55 Ω, (B) 65 Ω, (C) 100 Ω, (D) 377 Ω, (E) , Leave your comments or Download question paper.

Question is ⇒ Radiation resistance for wire antenna is, Options are ⇒ (A) 55 Ω, (B) 65 Ω, (C) 100 Ω, (D) 377 Ω, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Radiation resistance for wire antenna is
A.	55 Ω [Wrong Answer]
B.	65 Ω [Correct Answer]
C.	100 Ω [Wrong Answer]
D.	377 Ω [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following measurements can be done using a counter?

Pulse duration
Interval between two pulses
Amplitude of the pulse
Rise time of a pulse

Select the correct answer from the codes given below:
1 and 2
2 and 3
1 and 4
2 and 4

⇒ In the op-amp circuit of figure, V_{03 V₁ - 4 V₂
-3 V₁ + 4 V₂
3(V₁ - V₂)
-3(V₁ - V₂)}

⇒ A Darlington emitter follower circuit is some times used in the output stage of a TTL gate in order to
increase its I_QL
reduce its I_0H
increase its speed of operation
reduce power dissipation

⇒ Which instrument is based on induction principle?
Dynamometer wattmeter
Induction wattmeter
Energy meter
Both (b) and (c)

⇒ If V_a0, V_a1, V_a2 are sequence components of V_a and I_a0, I_a1, I_a2 are sequence components of I_a, then total 3 phase power P is given by
P = V_a0I_a0 + V_a1I_a1 + V_a2I_a2
P = V_a0I_a0 + V_a1I_a1 + V_a2I_a2^*
P = 3(V_a0I_a0 + V_a1I_a1 + V_a2I_a2)
P = 3(V_a0I_a0 + V_a1I_a1 + V_a2I_a2^*)

⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be
out of phase by 90°
in phase
out of phase by 45°
out of phase 180°

⇒ Which of the following is a valid real variable in FORTRAN 77?
KPR
LINE
JOB
RATE

⇒ The numerical value of directivity of current element of half-wave dipole is 1.76 and 2.15 dB respectively. The directive gain of half-wave dipole over current element will be
3.91 dB
1.95 dB
0.39 dB
0.195 dB

⇒ In a tape recorder
both record and erase heads have high permeability core
the record head has high permeability core but the erase head has low permeability core
the record head has low permeability core but the erase head has high permeability core
both record and erase heads have low permeability core

⇒ For a second order system delay time t_d is the time required to reach
half the final value for the very first time
the final value for the very first time
90% of the final value for the very first time
none of the above

⇒ To couple a coaxial line to a parallel wire line it is best to use
slotted line
balun
directional coupler
λ/4 transformer

⇒ Which of the following is present in both TRF receiver and superheterodyne receiver?
Detector
Mixer
IF amplifier
Local oscillator

⇒ Consider the following statements: In a differential amplifier using JFET, the differential output offset is due to

mismatch between FET parameters
difference in values of resistances used in circuit
variation in supply voltage.

Of the statements, the correct statements are
1 and 2
1, 2, 3
2, 3
1, 3

⇒ A single phase fully controlled bridge rectifier is fed by a source having inductance. The output voltage during overlap period is
V_m
0.5 V_m
zero
0.5 V_m - voltage drop across inductance

⇒ Which of the following instruments is used almost exclusively to measure radio frequency currents?
Moving coil
Rectifier
Moving iron
Thermocouple

⇒ Typical values of current gains for CE, CB and CC amplifiers are
120, 120 and 1 respectively
120, 1 and 120 respectively
1, 120 and 120 respectively
1, 1 and 120 respectively

⇒ Consider the following stateme
2 and 4
1 and 2
1 only
3 and 4

⇒ A photoconductor is a
conductor
semiconductor
insulator
superconductor

⇒

Assertion (A): For large signal variations an amplifier circuit has to be analysed graphically

Reason (R): The output characteristics of a transistor is nonlinear.

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a full wave rectifier circuit using centre tapped transformer, the peak voltage across half of the secondary winding is 30 V. Then PIV is
30 V
60 V
15 V
10 V

⇒ Pick the correct statement with respect to following fig
both the circuit are not identical filter Ckts
identical filter circuit at all frequencies
identical filter circuit at low frequency
identical filter circuit at high frequency

⇒ All poles and zeros of a driving point immittance function of an L-C network
should lie on the jω axis
should lie on the +ve real axis
should lie on the - ve real axis
can lie anywhere in s-plane

⇒ A certain network has two ideal voltages sources and a large number of ideal resistances. The power consumed in one of the resistances is 4 W when either of two sources is active and the other source is active and the other source is short circuited. When both sources is short circuited.When both sources are active, the power consumed in the same resistor would be
zero or 16 W
4 W or 8 W
zero or 8 W
8 W or 16 W

⇒ Which of the following circuit would be preferred for a 355 KHz IF amplifier?
Resistance loaded
Double tuned transformer
Video amplifier
Class C

⇒ Consider the following statements as regards advantages of CCD sensors as camera pick up tube

High sensitivity
Good spectral response
Image lag absent

Out of the above which are correct
1, 2, 3
1, and 2 only
1 and 3 only
2 and 3 only

⇒ As compared to LED, LASER has

higher emission efficiency
no tuning arrangement
narrow spectral width
provision for confinement

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1 and 3 are correct
1, 3, 4 are correct

⇒ The magnitude plot of a composite signal x(t) = e^3jt + e^4jt is __________ .
Half wave rectified sinusoid
Full wave rectified sinusoid
Exponentially increasing sinusoid
Exponentially decreasing sinusoid

⇒ A NOR gate has 3 inputs A, B, C. For which combination of inputs is output HIGH
A = B = C = 0
A = B = C = 1
A = B = 1 and C = 0
A = C = 1 and B = 0

⇒ The circuit consisting of two transistor connected in series with the d.c. supply voltage is called
push pull
differential pair
stacked V⁺
complementary symmetry

⇒ A dc circuit breaker must use
natural commutation
forced commutation
both natural and forced commutation
either natural or forced commutation