Question is ⇒ Radiation pyrometer is used to measure temperature in the range of, Options are ⇒ (A) -200 to 500° C, (B) 0 to 500° C, (C) 500 to 1200° C, (D) 1200 to 2500° C, (E) , Leave your comments or Download question paper.

Question is ⇒ Radiation pyrometer is used to measure temperature in the range of, Options are ⇒ (A) -200 to 500° C, (B) 0 to 500° C, (C) 500 to 1200° C, (D) 1200 to 2500° C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Radiation pyrometer is used to measure temperature in the range of
A.	-200 to 500° C [Wrong Answer]
B.	0 to 500° C [Wrong Answer]
C.	500 to 1200° C [Wrong Answer]
D.	1200 to 2500° C [Correct Answer]
View Answer 7 -7 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following pulse modulation is analog?
PCM
Differential PCM
PWM
Delta

⇒ The 2 out of 5 code has
two 0s and three 0s in each code group
one 1s and four 0s in each code group
four 1s and one 0s in each code group
three 1s and two 0s in each code group

⇒ The following circuit diagram resembl
logic 0
logic 1
f(A, B, C) = Σm(0, 1, 4, 6, 7)
none

⇒ In what range should Re(s) remains so that Laplace transform of the function e^{(a + 2)t + 5} exists?
Re(s) > a + 2
Re(s) > a + 7
Re(s) < a
Re(s) > a + 5

⇒

Assertion (A): Diamond and carborudum are both very hard materials.

Reason (R): Valence band can be extremely strong.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In figure, the power dissipated in 4 resistance is P₁ and power associated with 3 A source is P₂.
P₁ = P₂
P₁ < P₂
P₁ > P₂
P₁ may be equal or less than P₂

⇒ In most electric irons, the thermister used for controlling temperature is
vapour-filled bulb
high-expansion steel rod
bimetallic strip
thermopile

⇒ The number FF in hexadecimal system is equivalent to number __________ in decimal system.
256
255
240
239

⇒ A dynamometer wattmeter is connected in ac circuit. The measured power is
rms power
average power
peak power
instantaneous power

⇒ In elemental dielectrics, the orientation and ionic polarization are absent.
TRUE
FALSE

⇒ Overall efficiency of class B amplifier is
0.72
0.75
0.785
0.7

⇒ A klystron amplifier generally uses Pierce gun
TRUE
FALSE

⇒ The gate lead, in a thyristor is welded to :
p layer to which anode is connected
n layer nearest to the anode terminal
p layer nearest to the cathode terminal
outside n layer

⇒ The chemical properties of atoms are determined by all the electrons and their configuration.
TRUE
FALSE

⇒ Full adder circuit can be implemented by
Multiplexers
Half adders
AND or OR gates
Decoders

⇒ Consider the following statements as regards noise

If Gaussian noise is applied at input of a rectifier, the output is not gaussian
The noise encountered on a telephone line consists of short, pulse type disturbances whose amplitude distribution is not Gaussian
Shot noise results from random emission of electrons from a cathode
Shot noise results from phenomenon associated with the flow of current across semi conductor junctions

Which of the above are correct?
1, 2, 3, only
1, 2, 4 only
1, 2, 3, 4
2, 3 only

⇒ A lossless transmission line is connected to two identical voltage source as shown in figu
∞
100
50
25

⇒ If the bandwidth is increased by 2, the γ_FM γ_AM (where γ is the ratio of SNR of output to SNR at input, FM is frequency modulation and AM is amplitude modulation) is increased by a factor of
2
3
4
6

⇒ The IF stage of a receiver employs
capacitive coupling
impedance coupling
double-tuned transformer coupling
single-tuned transformer coupling

⇒ A piece of iron is placed in a magnetic field
the magnetic field will not be affected
the magnetic lines of force will bend to pass through the piece
the magnetic lines of force will bend away from the piece
any of the above depending on type of iron

⇒ Schmitt trigger can be used as a
comparator
square-wave generator
flip-flop
all of these

⇒ The minority carrier life time and diffusion constant in a semiconducting material are 100 μs and 100 cm²/s respectively. The diffusion length of carriers is
0.1 cm
0.01 cm
0.0141 cm
1 cm

⇒ Almost all resistors are made in a monolithic integrated circuit
during the entire diffusion
while growing the epitaxial layer
during the base diffusion
during the collector diffusion

⇒

Match the following:

	List I (Instrument)		List II (Measured quantity)
A.	Hot wire	1.	only voltage
B.	PMMC	2.	phase
C.	Electrostatic	3.	true RMS value
D.	Lock in Amplifier	4.	dc value

A-3, B-2, C-1, D-4
A-1, B-4, C-2, D-3
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1

⇒ With respect to the differential amplifier configuration shown below, the differential gain A_d will
273.63
213.63
113.63
233.63

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ In a conductor the conduction and valence bands overlap
TRUE
FALSE

⇒ In a superheterodyne receiver, having no RF amplifier, the IF is 455 kHz. The image frequency at 1000 kHz is
1455 kHz
545 kHz
1910 kHz
90 kHz

⇒ If noise margin is high, there is lesser chance of false operation.
TRUE
FALSE

⇒ Read the following rules for scanning Boolean expressions in Pascal

The expressions are scanned from left to right.
The operations are scanned in the order NOT, AND, OR.
All operators (i.e., NOT, AND and OR) are scanned together.
In one scanning all the operators of only one type are scanned.

Which of the above are correct?
All
1, 2 and 3 only
1, 2 and 4 only
2, 3 and 4 only