Question is ⇒ Programs like compilers, assemblers etc. are stored in a mircocomputer in, Options are ⇒ (A) registers, (B) cache memory, (C) primary memory, (D) mass storage, (E) , Leave your comments or Download question paper.

Question is ⇒ Programs like compilers, assemblers etc. are stored in a mircocomputer in, Options are ⇒ (A) registers, (B) cache memory, (C) primary memory, (D) mass storage, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Programs like compilers, assemblers etc. are stored in a mircocomputer in
A.	registers [Correct Answer]
B.	cache memory [Wrong Answer]
C.	primary memory [Wrong Answer]
D.	mass storage [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Surface leakage current is a part of
reverse current
forward current
reverse breakdown
forward breakdown

⇒ A series R-C circuit with R = 3 Ω and X_C = 4 Ω at 50 Hz is supplied with a voltage V = 50 + 141.4 sin 314 t. What is the RMS value of the current flowing through the circuit?
0.208333333333333
0.416666666666667
20 A
22-36 A

⇒ The current I in the circuit show
- j1 A
j1 A
0
20 A

⇒ In a discharging R-L circuit voltage across the resistor exhibits
a linear rise
a linear decay
an exponential growth function
an exponential decay function

⇒ With respect to transmission parameters, which one of the following is correct?
A and B are dimensionless
B and C are dimensionless
A and D are dimensionless
B and D are dimensionless

⇒ In the circuit shown in the figure, the current supplied by the sinusoidal current source
28 A
0.166666666666667
20 A
not determinable from the data given

⇒ An XOR gate with 6 variables is as follows A ⊕ B ⊕ C ⊕ D ⊕ E ⊕ F. The number of minterms in the Boolean expression is
6
12
64
32

⇒ Lowest resistivity of the following is
constantan
german silver
manganin
nichrome

⇒

Match the following:

	List I (Component)		List II (Dominant TE mode)
A.	Rectangular wave guide	1.	TE₁₀₁
B.	Circular waveguide	2.	TE₁₀
C.	Rectangular cavity	3.	TE₁₁₁
		4.	TE₁₁

A-4, B-2, C-1
A-2, B-1, C-3
A-3, B-4, C-1
A-2, B-3, C-1

⇒ If the atomic number of germanium is 32, the number of electrons in the outer most shell will be
2
3
4
6

⇒ In floating point representation the number of bits in exponent is
8
7
6
5

⇒ Current derating may be necessary when thyristors are operating in
series
parallel
series or parallel
none of the above

⇒ In the circuit of figure the current through L at t = &infin
0
0.416666666666667
6.67 A
5.1 A

⇒ Ground wave propagation is useful for
microwave
medium wave
short wave
long distance

⇒ The internal resistance of a current source used in the model of a BJT while analyzing a circuit using BJT is :
very high
very low
zero
of the order of a few mega ohms

⇒ The D.C. alpha(a) of a transistor is approximately
unity
10 to 50
100 to 500
1000 to 5000

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Satellite communication systems use the frequency band
10 to 20 MHz
50 to 70 MHz
3 to 6 GHz
100 to 120 GHz

⇒ A rectifier circuit has load resistance R. It uses a capacitance filter having capacitance C. For low ripple in the output
RC should be 1
RC should be low
RC should be high
RC should be neither low nor high

⇒ The V-I characteristic of a semi-conductor diode is shown in figure. From this figure it can be concluded
The diode is a silicon diode
The diode is a germanium diode
Break down voltage of the diode is 0.7 V
At 1 V rated current will pass through the diode

⇒ In admittance parameter set, the dependent variables are the currents at the two ports.
TRUE
FALSE

⇒

Match the following:

	List I (Transducer)		List II (Quantity measured)
A.	LVDT	1.	Pressure
B.	Bourden gauge	2.	Temperature
C.	Strain gauge	3.	Displacement
D.	Thermistor	4.	Stress

A-4, B-3, C-2, D-1
A-3, B-2, C-1, D-4
A-4, B-1, C-3, D-2
A-3, B-1, C-4, D-2

⇒ Which of the following are the non-linear application of op-amp?

Current-to-voltage converter
Comparator
Peak detector
Limiter

Select the correct answer from the codes given below:
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4

⇒ Consider the following operation in respect of Wheatstone bridge (K_b, denotes battery key, K_g denotes galvanometer key)

open K_b
close K_g
close K_b
open K_g

The correct sequence of operations is
1, 2, 3, 4
3, 1, 2, 4
4, 3, 2, 1
3, 2, 4, 1

⇒ Which one of the following is also called 'rat race'?
E plane tee
H plane tee
Magic tee
Hybrid ring

⇒ The depletion layer around p-n junction in JFET consists of
hole
electron
immobile charges
none of the above

⇒ To measure moisture in wood, the most suitable method is
electric conduction
electrical-capacitive
absorption of radiation
equilibrium-moisture Vs humidity

⇒

Assertion (A): A power factor meter operates on dynamometer principle.

Reason (R): A power factor meter does not have a control spring.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ A device has two resistances 300 Ω and 200 Ω respectively. The noise voltages due to these two resistance calculated separately are 5.38 μV and 4.38 μV respectively. When both of them are used together, the noise voltage will be
9.76 V
1 μV
23.56 μV
6.94 μV

⇒ The phenomenon of creep occurs in
energy meters
voltmeters
ammeters
wattmeters