Question is ⇒ Program counter in a digital computer, Options are ⇒ (A) counts the number of program run in the machine, (B) counts the number of times a subroutine is called, (C) counts the number of times the loops are executed, (D) points the memory address of the current or the next instruction to be executed, (E) , Leave your comments or Download question paper.

Question is ⇒ Program counter in a digital computer, Options are ⇒ (A) counts the number of program run in the machine, (B) counts the number of times a subroutine is called, (C) counts the number of times the loops are executed, (D) points the memory address of the current or the next instruction to be executed, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Program counter in a digital computer
A.	counts the number of program run in the machine [Wrong Answer]
B.	counts the number of times a subroutine is called [Wrong Answer]
C.	counts the number of times the loops are executed [Wrong Answer]
D.	points the memory address of the current or the next instruction to be executed [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The useful magnetic flux obtainable from any closed surface is
unity
constant
both (a) and (b)
none of the above

⇒ Analysis of EM wave in waveguide based on
circuit theory
field theory
optical theory
both (a) and (b)

⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then
R = 10 ns, S = 40 ns
R = 40 ns, S = 10 ns
R = 10 ns, S = 30 ns
R = 30 ns, S = 10 ns

⇒ Which of the following is the main advantage of PCM system?
Lower noise
Lower power
Lower bandwidth
All of the above

⇒ T.V. antennas are usually
Yagi-Uda
loops
helical
parabolic

⇒ For TV broadcast, picture signal is modulated in
SSB
VSB
FM
AM

⇒ Schrodinger wave equation is partial differential equation.
TRUE
FALSE

⇒

Match the following:

	List I (Modes)		List II (Characteristic)
A.	Evanescent	1.	Rectangular waveguide does not support
B.	Dominant mode	2.	No wave propagation
C.	TM₁₀ and TM₀₁	3.	Lowest cut-off frequency

A-1, B-2, C-3
A-2, B-3, C-1
A-1, B-3, C-2
A-2, B-1, C-3

⇒ A semiconductor diode is biased in forward direction and carrying current I. The current due to holes in p material is
I
0
less than I
0.5

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after SBI 0B7H?
12 H, 0
12 H, 1
DDH, 0
DDH, 1

⇒ Gray code is used in devices which convert analog quantities to digital signal because it is
more error free
much simpler than binary code
superior to Excess-3 code
absolutely error free

⇒ For a 2 port network, the O/P short circuit current was measured with a 1 volt source at the I/P then value of the current gives
h₁₂
y₁₂
h₂₁
y₂₁

⇒ Which of the following factor does NOT contribute to the drift of a geostationary satellite from its stationary position in space?
Pressure of solar radiations
Gravitational changes due to Sun and Moon
Oblateness of the Earth
Weight of the satellite

⇒

Assertion (A): A transistor has lower voltage drop during conduction as compared to thyristor

Reason (R): Transistors are manufactured in very high voltage and current ratings.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Two phasors having rms values V₁ and V₂ which are added to give a phasor having rms value V₃. V₃ is maximum if phase angle between V₁ and V₂ is
90°
180°
270°
360°

⇒

Assertion (A): The advantages of totem pole output are fast switching and low power consumption.

Reason (R): IC packages available are DIP, surface mount and J lead surface mount.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In the circuit shown in figure, I_s = 4A, V_s = 4, the voltage V is give
6 V
8 V
4 V
2 V

⇒ Broadcasting antennas are generally
omnidirectional type
vertical type
horizontal type
helical

⇒ The scale of a dynamometer is linear when used as
ammeter
voltmeter
wattmeter
both (a) and (c)

⇒ No load d.c. output will be least in case of
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ The analog signal given below is sampled by 600 samples per second for m(t) = 3 sin 500 pt + 2 sin 700 pt then folding frequency is
500 Hz
700 Hz
300 Hz
1400 Hz

⇒ Frequency band used for radar is generally
VLF
VHF
UHF
EHF

⇒ In static RAM 6264 the number of address inputs are
10
12
13
15

⇒ A basic group B
consists of five super groups
has a frequency range of 60 to 108 kHz
consists of erect channels only
is formed at group translating equipment

⇒ A line has standing waves with a voltage maximum of 35 mV and minimum of 17.5 mV VSWR is
2
4
0.5
0.25

⇒ In a loss less line the propagation constant is equal to
jωLC
LC
jωLC
LC

⇒ Barkhausen criterion of oscillation is
Aβ > 1
Aβ = 1
Aβ = < 1
Aβ ≤ 1

⇒ Electrical contact materials used in switches, brushes and relays must possess
high thermal conductivity and high melting point
low thermal conductivity and low melting point
high thermal conductivity and low melting point
low thermal conductivity and high melting point

⇒ In figure the current through resist
is always equal to 130 mA
may vary between 130 mA and 10 mA
may vary between 65 mA and 10 mA
is always equal to 65 mA

⇒ High cut off frequency can be expected in case of
common-base
common-emitter
common-collector
all of the above