Question is ⇒ Probability density function of thermal noise is, Options are ⇒ (A) Poisson, (B) Binomial, (C) Gaussian, (D) None of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Probability density function of thermal noise is, Options are ⇒ (A) Poisson, (B) Binomial, (C) Gaussian, (D) None of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Probability density function of thermal noise is
A.	Poisson [Correct Answer]
B.	Binomial [Wrong Answer]
C.	Gaussian [Wrong Answer]
D.	None of the above [Wrong Answer]
View Answer 2 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ What will be conversion rate for a counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time
125
125 x 10³
125 x 10⁶
None

⇒ The circuit realizes the func
(A + B) E + CD
(A + B) (E + CD)
(A + B) (E + C + D)
(AB + E). CD

⇒ A material which is lightly repelled by a magnetic field is known as
diamagnetic material
non-magnetic material
ferromagnetic material
paramagnetic material

⇒

Assertion (A): Power transistor has lower switching time than SCR

Reason (R): Power transistor has greater switching time than SCR

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ 11011 in gray code = __________ .
10010₂
11111₂
11100₂
10001₂

⇒ Assume that op-amp in figure is ideal. If input V_i is triangular, the output V₀ wil
square wave
sine wave
triangular wave
parabolic wave

⇒ Figure shows an RC circuit. The magnitude plot V₂/V_{1will rise exponentially to R₂/(R₁ + R₂) as ω → ∞
will rise linearly to R₂/(R₁ + R₂) as ω → ∞
will decrease to zero as ω → ∞
will rise 1 at ω = 0 and then decrease as ω → ∞}

⇒ Which of these is used in seven segment display?
PIN diode
LED
Photo diode
Tunnel diode

⇒ The resistance of a metallic wire would
increase as the operating frequency increase
decrease as the operating frequency increase
remain unaffected on increasing the operating frequency
first increase then decrease

⇒ In the given figure the ratio T/d is the duty fac
TRUE
FALSE

⇒ To couple a coaxial line to a parallel to wire line it is best to use a
slotted line
balun
directional coupler
quarter wave transformer

⇒ In decimal system the base of radix is
0
1
10
e

⇒ Decimal 8 in excess-3 code =
1000
1001
1011
1111

⇒ TTL circuit with active pull up is preferred because of its suitability for
wired AND operation
bus operated system
wired logic operation
reasonable dissipation and speed of operation

⇒ Which of the following instructions in 8085 does not belong to data transfer group?
LDA addr
STA addr
XCHG
SUB r

⇒ The semiconductor diode which can be used in switching circuit in microwave range is
PIN diode
Varactor diode
Tunnel diode
Gunn diode

⇒ What do the contents of instruction register specify?
Operand for the instruction being executed
Op code for the instruction being executed
Op code for the instruction to be executed next
Operand for the instruction to be executed next

⇒ In a lead acid cell, the positive plate has spongy lead.
TRUE
FALSE

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Assignment
B.	\| \|	2.	Logical AND
C.	=	3.	Logical OR

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-2, C-1
A-1, B-3, C-2

⇒ In the stabilized reactance modulator AFC system
phase modulation is converted into amplitude modulation by the equalizer circuit
the discriminator frequency must not be too low or the system will fail
the discriminator must have a fast time constant to prevent demodulation
the higher discriminator frequency, better the oscillator frequency stability

⇒ In phase modulation, the phase deviation is
proportional to the amplitude of the signal and varies with frequency
remains constant while amplitude and frequency of signal varies
proportional to the amplitude of the signal and independent of the frequency
none of the above

⇒ Hall effect can be used to find the type of semiconductor.
TRUE
FALSE

⇒ With an ac input from 50 Hz power line, the ripple frequency is
50 Hz in the dc output of half wave as well as full wave rectifier
100 Hz in the dc output of half wave as well as full wave rectifier
50 Hz in the dc output of half wave and 100 Hz in the dc output of full wave
100 Hz in the dc output of half wave and 50 Hz in the dc output of full wave

⇒ When a series RL circuit is switched on to a dc voltage, the rate of change of current is maximum at t = 0.
TRUE
FALSE

⇒ Germanium and Si phosphorus have their maximum spectral response in the
infrared region
ultraviolet region
visible region
X-ray region

⇒ The network of the given figure
lag network
lead network
lag-lead network
any of the above

⇒ Nichrome is used for
overload line wires
heater coils
lamp filaments
all of the above

⇒ The input and output signals for CE amplifier are always
equal
in phase
out of phase
complementary to each other

⇒ Which of the following is not a legal subscript?
J + 2
JA - 4
-3
3^* IA - 2

⇒ In a microprocessor system the stack is used for
starting the program return address whenever a subroutine jump instruction is execute
transmitting and receiving input and output data
starting all important CPU register contents whenever an interrupt is to be serviced
storing program instructions for interrupt service routine