Question is ⇒ Principle of superposition is applicable to, Options are ⇒ (A) linear systems only, (B) nonlinear systems only, (C) both linear and non linear system, (D) linear systems and some nonlinear systems, (E) , Leave your comments or Download question paper.

Question is ⇒ Principle of superposition is applicable to, Options are ⇒ (A) linear systems only, (B) nonlinear systems only, (C) both linear and non linear system, (D) linear systems and some nonlinear systems, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Principle of superposition is applicable to
A.	linear systems only [Correct Answer]
B.	nonlinear systems only [Wrong Answer]
C.	both linear and non linear system [Wrong Answer]
D.	linear systems and some nonlinear systems [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following measurements can be done using a counter?

Pulse duration
Interval between two pulses
Amplitude of the pulse
Rise time of a pulse

Select the correct answer from the codes given below:
1 and 2
2 and 3
1 and 4
2 and 4

⇒ DVD uses
Laser beam for both recording and playback
Laser beam for recording and video head for playback
Video head for recording and laser beam for playback
None of the above

⇒ If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
800 to 1000
200, 800, 1000, 1800
only 200
only 1800

⇒ The primary reason for the widespread use of Si in semiconductor device technology is
abundance of Si on the surface of earth
larger band gap of Si in comparison to Ge
favourable properties of Silicon-dioxide (SiO₂)
lower melting point

⇒ The depletion layer consists of immobile ions.
TRUE
FALSE

⇒ Four MSI TTL 4-bit ripple counters are cascaded to form a 16-bit binary counter. Its propagation delay is about __________ nanoseconds.
70
140
210
280

⇒ In figure, A is ideal ammeter having zero resistance. It will read __________ amp
2
2.5
3
4

⇒ For broadcasting purpose, full AM signal is preferred to SSB signal because
it requires large bandwidth
generation of full AM is easier
detection of full AM is simpler
none of the above

⇒ As wavelength decrease the size of high directivity antenna
decreases
increases
is not affected
either (b) or (c)

⇒ Consider the following statem
1 alone
2 alone
3 alone
1 and 3

⇒ A broadcast radio transmitter radiates 5 kW when the modulation percentage is 60. How much of this is carrier power?
6.66 kW
5 kW
4.9 kW
4.23 kW

⇒ In a bipolar transistor
the base is thick and highly doped
the base is thin and highly doped
the base is thick and lightly doped
the base is thin and lightly doped

⇒ The storage capacity of DSDD disk and DSHD disk are
1.2 MB each
360 KB each
1.2 MB and 360 KB respectively
360 KB and 1.2 MB respectively

⇒ A noise can be represented as superposition of spectral components. When this noise is passed through a narrow band filter, the output of filter should look like
sinusoidal
rectangular
triangular
none of the above

⇒ If a sound wave has a frequency of 50 Hz, the wavelength is
66 m
6.6 m
0.66 m
0.066 m

⇒ Bode magnitude plot is drawn between
magnitude of network function and ω
dB magnitude and log ω
dB magnitude and ω
log_e (magnitude) and log ω

⇒ If the inputs to a 2 input XOR gate are high then, the output is high.
TRUE
FALSE

⇒ If t_p is the pulse width, Δ_t is the propagation delay, T is period of pulse train then the following condition can avoid the race around condition
t_p = Δt = T
2t_p > Δt > T
t_p < Δt < T
t_p < Δt < T

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	& &	1.	Bitwise inclusive OR
B.	&	2.	Bitwise AND
C.	\| \|	3.	Logical AND
D.	\|	4.	Logical OR

A-1, B-2, C-3, D-4
A-3, B-2, C-4, D-1
A-2, B-3, C-1, D-4
A-1, B-4, C-2, D-3

⇒ The poles and zeros of a positive real functions are real or occur in conjugate pair.
TRUE
FALSE

⇒ Negative feedback is used in audio amplifiers to
operate class C
reduce distortion
increase distortion
increase gain

⇒ In a specimen of n type semiconductor, the initial concentration of holes and electrons is p_no and n_no. When the specimen is subjected to radiation, the hole and electron concentration increase to p_n and n_n. Then
p_n - p_no = n_n - n_no
p_n + p_no = n_n + n_no
p_n - p_no = n_no + n_no
p_n + p_no = n_n - p_no

⇒ If X(z) = (1 - az^-1), and |a| < |z|, the initial value x₀ is
1
0
2
∞

⇒ To couple a coaxial line to a parallel wire line it is best to use
slotted line
balun
directional coupler
λ/4 transformer

⇒ Which of the following statements is not true in regard to storage time of a diode?
During this time, the diode is reverse-biased
The diode conducts during this time
It is due to the time taken by carriers to depart from the function when the diode is reverse-biased
During this time the diode current is zero

⇒ Which of the following addressing modes is used in the instruction PUSH B?
Direct
Register
Register Indirect
Immediate

⇒ The A.C. resistance of the emitter diode will be
5.05 Ω
50.5 Ω
505 Ω
5050 Ω

⇒ Which of following antenna does not depend upon the frequency?
Log-periodic
Parabolic
Conical
All of the above

⇒ The current through a 10 Ω resistance in a dc circuit having two emf sources is 3A. If this resistance is changed to 20 Ω, the new value of current will be
less than 3 A
equal or less than 3 A
equal to or less or more than 3 A
1.5 A

⇒ In communication satellites, the up-link normally operates at a higher frequency than the down-link because it
gives a narrow beam shining into space
results in lesser signal attenuation
gives better beam-shaping
is easier to polarize a high frequency beam