Question is ⇒ Poynting theorem relates the electric intensity E, magnetic intensity H to the rate of energy flow per unit area at a point P as, Options are ⇒ (A) P = E/H, (B) P = H/E, (C) E = 1/E x H, (D) P = E x H, (E) , Leave your comments or Download question paper.

Question is ⇒ Poynting theorem relates the electric intensity E, magnetic intensity H to the rate of energy flow per unit area at a point P as, Options are ⇒ (A) P = E/H, (B) P = H/E, (C) E = 1/E x H, (D) P = E x H, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Poynting theorem relates the electric intensity E, magnetic intensity H to the rate of energy flow per unit area at a point P as
A.	P = E/H [Wrong Answer]
B.	P = H/E [Wrong Answer]
C.	E = 1/E x H [Wrong Answer]
D.	P = E x H [Correct Answer]
View Answer 3 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The radiation resistance of a rod tubing antenna is
55 Ω to 60 Ω
60 to 100 Ω
0 to 377 Ω
60 to 200 Ω

⇒

Assertion (A): When frequencies of signals fed to X and Y plates of CRO are multiples of each other, Lissajous pattern is displayed on screen.

Reason (R): In a CRO, the vertical deflection is proportional to voltage applied to Y plates.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ For an n-channel enhancement type MOSFET, if the source is connected at a higher potential than that of the bulk (V_SB > 0), the threshold voltage V_T of the MOSFET will
remain unchanged
decrease
change Polarity
increase

⇒ While drawing vector diagram for a series circuit, the reference vector is
voltage
current
power
phase angle

⇒ In a current transformers
the number of turns in primary and secondary windings are nearly equal
the number of primary turns is very small as compared to number of secondary turns.
the number of secondary turns is very small as compared to the number of primary turns
either (a) or (c).

⇒ Which of the following is true?
During addition if the carry into and carry out of the sign bit do not match then an overflow has occurred
During addition if the carry into and carry out of the sign bit don't match then an overflow or underflow has occurred
During addition if the carry into and carry out of the sign bit match then an overflow or underflow has occurred
During addition if the carry into and carry out of the sign bit match then an overflow has occurred

⇒ A coil of resistance R and inductance L is connected in series with 10 mF capacitor. The resonant frequency is 1000 Hz. Another 10 F capacitor is connected in parallel with the above capacitor. The new resonance frequency will be
1000 Hz
more than 1000 Hz
less than 1000 Hz
may be more or less than 10000 Hz

⇒

Assertion (A): In series R-L-C circuit, the current may lead or lag the voltage depending on the value of R.

Reason (R): Phase angle of an R-L series circuit is tan^-1 (ωL/R).

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Reflectors and lens antennas are commonly used
in LF communication systems
not beyond 100 kHz
in the range 10 MHz to 100 MHz
above 100 MHz

⇒ The dc load current in a bridge rectifier circuit is 10 mA. The dc load current through each diode is
40 mA
20 mA
10 mA
5 mA

⇒ Which device changes serial data to parallel data?
Counter
Multiplexer
Demultiplexer
Flip flop

⇒ The dual of a link is
twig
node
loop
tree branch

⇒ To prevent a DC return between source and load, it is necessary to use
resistor between source and load
inductor between source and load
capacitor between source and load
either (a) or (b)

⇒ If D is mouth diameter of a paraboloid reflector, its directivity is proportional to
D
D²
D
D³

⇒ The characteristic equation of an SR flip-flop in given by
Q_n+1 = S + RQ_n
Q_n+1 = RQ_n + SQ_n
Q_n+1 = S + RQ_n
Q_n+1 = S + RQ_n

⇒

Assertion (A): The ac load line is different from dc load line

Reason (R): The ac load resistance seen by collector and emitter is different from dc load resistance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A low-pass filter frequency responce H (jω) = A (ω) e^jΦ(ω) does not produce any phase distortion, if
A(ω) = Cω², Φ (ω) = kω³
A(ω) = Cω², Φ (ω) = kω
A(ω) = Cω², Φ (ω) = kω²
A(ω) = C, Φ (ω) = kω^-1

⇒ Which of the following is an oscillator with best frequency stability?
Crystal oscillator
Clapp oscillator
Phase shift circuit
Multivibrator

⇒ In an RC-coupled amplifier for improving the low frequency response
lower R_L is provided
more bias is used
less gain is provided
higher C_C is used

⇒ If each branch of a Delta circuit has impedance 3 Z then each branch of the equivalent Y circuit has impedance.
Z/3
3 Z
3/3 Z
Z/3

⇒ The dual of quantity charge is
current
Voltage
flux
dΦ/dt

⇒ Which of the following are included in the architecture of a computer?

Addressing modes, CPU
Instruction set, data formats
Secondary memory, operating system

Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
3 only

⇒ For radiating ultraviolet rays, LEDs use
zinc sulphide
gallium arsenide
gallium phosphide
none of the above

⇒ AM amplifier having noise figure of 20 dB and available power gain of 15 dB is followed by a mixer circuit having noise figure of 9 dB. The overall noise figure as referred to input in dB is
10.44
11.07
21.52
0.63

⇒ As frequency increases, the transmission efficiency
decreases
increases
is not affected
either (a) or (c)

⇒ Transformer coupling in transistor amplifier circuits provides high efficiency, because
d.c. resistance is low
collector voltage is stepped up
flux linkages are incomplete
all of the above

⇒ Two sinusoidal voltage sources v₁ = 50 sin (100t) and v₁ = 50 sin (100t + p) are connected in parallel and fed an inductance X_L = 2Ω. The cuirent through X_L is
25 A
about 17.5 A
zero
50 A

⇒ In a line with finite attenuation
power transmission is least efficient when there are no standing waves on the line
power transmission is most efficient when there are no standing waves on line
Load power depends on phase constant
standing waves will always exist on the line

⇒ For matrix A, A^-1 A = 1
TRUE
FALSE

⇒ The waveform shown in the given Figure can be written
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) - u(t - 5)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) - 4u(t - 5)
v(t) = u(t - 1) + u(t - 2) + u(t - 3) + u(t -4) + 4u(t - 5)