Question is ⇒ Power spectral density of white noise, Options are ⇒ (A) is constant with frequency, (B) increases with frequency, (C) decreases with frequency, (D) none, (E) , Leave your comments or Download question paper.

Question is ⇒ Power spectral density of white noise, Options are ⇒ (A) is constant with frequency, (B) increases with frequency, (C) decreases with frequency, (D) none, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Power spectral density of white noise
A.	is constant with frequency [Correct Answer]
B.	increases with frequency [Wrong Answer]
C.	decreases with frequency [Wrong Answer]
D.	none [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The voltage of the source in circuit shown __________ if i(t) = - 20e^{-2t46.6 e^-2t
47 e^-2t
50 e^-2t
0}

⇒ The numerical value of directive gain may lie between
1 and + 1
0 and 1
0 and ∞
1 and ∞

⇒ A p-n junction diode has
low forward and high reverse resistance
a non-linear v-i characteristics
zero forward current till the forward voltage reaches cut in value
all of the above

⇒ A low-pass filter frequency responce H (jω) = A (ω) e^jΦ(ω) does not produce any phase distortion, if
A(ω) = Cω², Φ (ω) = kω³
A(ω) = Cω², Φ (ω) = kω
A(ω) = Cω², Φ (ω) = kω²
A(ω) = C, Φ (ω) = kω^-1

⇒ The organisatioion of Intel memory chip 127256 is
32 K x 8
16 K x 8
32 K x 4
16 K x 4

⇒ When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be
3
4
8
16

⇒ For a single phase half wave converter feeding a resistive load, the firing angle a. The waveshape in below figure is
output voltage
input voltage
voltage drop across thyristor
none of the above

⇒ The range of memory location in given memory interfacing scheme
0000H - 07FFH
F800H - FFFFH
0000H - 03FFH
0000H - 3FFFH

⇒ Which control action is also called rate control?
Proportional
Derivative
Integral
Proportional plus integral

⇒ Tape recorders use
cone type loudspeakers
horn type loudspeakers
either cone type or horn type loudspeakers
none of the above

⇒ Operating point signifies that
zero signal I_C and V_BE
zero signal I_C and V_CE
zero signal I_B and V_CE
zero signal I_C, V_CE

⇒ The turn on time of an SCR is 5 micro second. Its trigger pulse should have
short rise time with pulse width = 2.5 μs
long rise time with pulse width = 3 μs
short rise time with pulse width = 4 μs
long rise time with pulse width = 4 μs

⇒ S is closed for a long time and steady state is reached. S is opened at t(0^-). The voltage marked V is V₀ at t = 0⁺ and V_f at t = ∞. Then value of V₀ and V_f are respecti
8, 8
0, 1
4, 0
4, 8

⇒ The circuit in the given figur
low pass filter
high pass filter
band Pass filter
band reject filter

⇒ To convert JK flip flop to D flip flop
connect D to both J and K
connect D to J directly and D to K through inverter
connect D to K directly and D to J through inverter
connect D to K and leave J open

⇒ The most important primary force of attraction in the formation of solids is
electromagnetic
electrostatic
quantum-electrostatic
quantum electromagnetic

⇒ The use of free wheeling diode in controlled rectifier improves the waveshape of load current.
TRUE
FALSE

⇒ If the switch is thrown to the START position, Q and Y will be equal to
Q = 0, Y = 0
Q= 1, Y= 1
Q = 1, Y = CLK
Q = 0, Y = CLK

⇒ In which function is each term known as minterm?
SOP
POS
Hybrid
Both SOP and POS

⇒ The resistance of the circuit shown is figur
5 Ω
More than 6 Ω
More than 4 Ω
Between 6 and 7 Ω

⇒ The gauge factor of a semiconductor strain gauge is about
2
10
100
1000

⇒

Assertion (A): In control system velocity error is not an error in velocity but is an error in position due to a ramp input.

Reason (R): For a type of system velocity error is zero.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒

Assertion (A): Boolean expressions can be easily simplified using Karnaugh map.

Reason (R): Karnaugh map can be drawn for minterms as well as max terms.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about
15 μV
30 μV
7.5 μV
10.6 μV

⇒

Assertion (A): A rectifier with inductor filter is more efficient for high load current.

Reason (R): In rectifier with inductor filter we can use a larger choke to reduce ripple, larger choke will have higher dc resistance which will result in lower dc output voltage for higher load current.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Curl of gradient A is
∇ x (∇A) = 1
∇ x (∇A) = ∞
∇ x (∇A) = 0
∇ x (∇A) = - ∞

⇒ The number of spectral component when two cosine waves are multiplied of different frequency
1
2
8
4

⇒ Microwave resonators are used in
microwave oscillators
microwave narrow band amplifier
microwave frequency metres
all of the above

⇒ The advantage of LVDT over inductive bridge type transducer is that
it gives high output for small changes in core position
it can be used over a temperature range of - 265°C to 600°C
it can measure displacement of moving object
the error due to stray magnetic field is less

⇒ An I/O processor controls the flow of information between
cache memory and I/O devices
main memory and I/O devices
two I/O devices
cache and main memory