Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Point out the wrong statement, Sequential logic circuit is |

A. | one that requires a clock to change states [Wrong Answer] |

B. | one in which past affects the present states [Wrong Answer] |

C. | one whose outputs changes immediately when the inputs change [Correct Answer] |

D. | also called clock logic or synchronous logic [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ For a MOS capacitor fabricated on a P-type semiconductor, strong inversion occurs when

surface potential is equal to Fermi potential

surface Potential is greater than Fermi potential

surface potential is -

*ve*and equal to Fermi potential in magnitude

surface potential is +

*ve*and equal to twice the Fermi potential

⇒ Full adder circuit can be implemented by

Multiplexers

Half adders

AND or OR gates

Decoders

⇒ The forbidden energy gap for germanium is

0.12 eV

0.32 eV

0.72 eV

0.92 eV

⇒ The most commonly used logic family is

ECL

TTL

CMOS

PMOS

⇒ An R-C coupled amplifier has mid-frequency gain of 200 and a frequency response from 100 Hz to 20 kHz. A negative feedback network with β = 0.2 is incorporated into the amplifier circuit, the Bandwidth will be

50 kHz

20 kHz

100 kHz

infinite

⇒ The ac collector current is nearly equal to

ac base current

ac signal current

ac supply current

ac emitter current

⇒ A pole zero plot of a filter is shown in figure. I

low pass filter

high pass filter

band pass filter

all pass filter

⇒ Which of the following best represents the output impedance of an actual op-amp?

10 ohm

100 ohm

10 k ohm

100 k ohm

⇒ Push pull amplifier is

class B

class A

class C

Class A or Class C

⇒ In Pascal an array declaration provides information to the Pascal processor to enable it to

identify the variable as an array name

reserve memory locations to store all the components of array

check the values computed for subscripts expressions during program execution with the specified lower and upper limits of subscripts

all of the above

⇒ Pre-emphasis circuit is used

after modulation

before modulation

before detection

after detection

⇒ Consider the following statements:

- The positiveness of coefficients of characteristic equation is necessary as well as sufficient condition for stability of first and second order systems.
- The positiveness of coefficients of characteristic equation ensures negativeness of real roots but is not sufficient condition for stability of third and higher order systems.

only 1 is correct

both 1 and 2 are correct

only 2 is correct

both are wrong

⇒ In the expression A + BC, the total number of minterms will be

2

3

4

5

⇒ The waveshape of output voltage of half bridge inverter is

sinusoidal

square

triangular

either (a) or (b)

⇒ Which of the following identifiers is valid in Pascal?

`THETA`

`NUM `

`1 ST`

`$ BETA`

⇒ In the forward blocking region of a silicon, controlled rectifier, the SCR is

in the off-state

in the ON state

reverse biased

at the point of breakdown

⇒ For a second order system with 0 < ξ < 1, the angle which poles make with negative real axis is

sin

^{-1}ξ

cos

^{-1}ξ

tan

^{-1}ξ

cot

^{-1}ξ

⇒ The main drawback in the performance of shunt peaked wide band amplifier is

two low gain at low frequency

poor phase response

reduce frequency at middle frequency

that the maximum gain of the stage is small

⇒ For a junction FET in the pinch off region as the drain voltage is increased, the drain current

becomes zero

abruptly decreases

abruptly increases

remains constant

⇒ The distance of a synchronous satellite from Earth's surface is __________ km.

300

10000

35900

5

⇒ The average load current supplied by a thyristor depends on

firing angle

firing frequency

magnitude of gate current

all of the above

⇒ Secondary emission is always decremental.

TRUE

FALSE

⇒ Ultra high frequency oscillators work in the range

20 Hz to 20 kHz

1 kHz to 30 kHz

30 kHz to 30 MHz

above 30 MHz

⇒ An 8156 has A

_{15}connected to its CE input. A

_{14}to A

_{8}are unconnected, and AD

_{7}to AC

_{0}are connected.Ignoring shadows, the port addresses

80 H

85 H

82 H, 83 H

80 H to 85 H

⇒ The JFET in the circuit shown in figure has an I

_{DSS}= 10 mA and V

_{p}= -5V. The value of the resistance R

_{s}for a drain current I

_{DS}= 6.4 m

156 Ω

470 Ω

560 Ω

1 kΩ

⇒ Audio systems use transverse recording.

TRUE

FALSE

⇒ The transfer function G

_{12}(

*s*) for a two port is

V

_{2}/V

_{1}

V

_{2}(

*s*)/V

_{1}(

*s*)

V

_{2}(

*s*)/I

_{1}(

*s*)

I

_{2}(

*s*)/I

_{1}(

*s*)

⇒ Counterpoise is used in coils having

high resistivity

low resistivity

medium resistivity

both (b) and (c)

⇒ In an

*n*type semiconductor the fermi level is 0.35 eV below the conduction band, the concentration of donor atoms is increased to three times. The new position of Fermi level will be

0.35 eV below conduction band

about 0.32 eV below conduction band

about 0.32 eV above conduction band

about 0.1 eV below conduction band

⇒ A mod 4 counter will count

from 0 to 4

from 0 to 3

from any number n to n + 4

none of the above