Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Types of transmission structure) </th> <th width="5%"></th><th>List II (Modes of propagation)</th></tr><tr><td>A.</td><td>Strip line</td><td>1.</td><td>Quasi TEM</td></tr><tr><td>B.</td><td>Hollow rectangular waveguide</td><td>2.</td><td>Pure TEM</td></tr><tr><td>C.</td><td>Microstrip</td><td>3.</td><td>TE/TM</td></tr><tr><td>D.</td><td>Corrugated waveguide</td><td>4.</td><td>Hybrid</td></tr></tbody></table>, Options are ⇒ (A) A-2, B-1, C-3, D-4, (B) A-4, B-1, C-3, D-2, (C) A-2, B-3, C-1, D-4, (D) A-4, B-3, C-1, D-2, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Types of transmission structure) </th> <th width="5%"></th><th>List II (Modes of propagation)</th></tr><tr><td>A.</td><td>Strip line</td><td>1.</td><td>Quasi TEM</td></tr><tr><td>B.</td><td>Hollow rectangular waveguide</td><td>2.</td><td>Pure TEM</td></tr><tr><td>C.</td><td>Microstrip</td><td>3.</td><td>TE/TM</td></tr><tr><td>D.</td><td>Corrugated waveguide</td><td>4.</td><td>Hybrid</td></tr></tbody></table>, Options are ⇒ (A) A-2, B-1, C-3, D-4, (B) A-4, B-1, C-3, D-2, (C) A-2, B-3, C-1, D-4, (D) A-4, B-3, C-1, D-2, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I (Types of transmission structure)		List II (Modes of propagation)
A.	Strip line	1.	Quasi TEM
B.	Hollow rectangular waveguide	2.	Pure TEM
C.	Microstrip	3.	TE/TM
D.	Corrugated waveguide	4.	Hybrid

A-2, B-1, C-3, D-4

A-4, B-1, C-3, D-2

A-2, B-3, C-1, D-4

A-4, B-3, C-1, D-2

View Answer 1 -1

Explanation:-
Answer : C
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the system of the given figure, the closed loop poles ar
0 and -4
-2 ± j6
2 ± j6
-3 ± j8

⇒ In active filters inductances are divided because they
are always associated with same resistance
are bulky and unsuitable for miniaturization
are non linear
saturate quickly

⇒ Which of the following is used as switch?
J-K flip-flop
Master slave J-K flip-flop
T-flip-flop
D-flip-flop

⇒ In figure, V_{0zero
5.7 V
6.9 V
12.6 V}

⇒ T-flip-flop is commonly used as
a delay switch
a digital counter only
a digital counter and frequency divider
any of the above

⇒ For circuit in figure, which combination of V_TH and R_TH represents the circuit as seen from ab<
1 V, 10 Ω
1 V, 1000 Ω
1 mV, 1000 Ω
1 mV, 10 Ω

⇒ In a specimen of ferromagnetic material, as the flux density is increased from zero to 2.5 T, µ_r will
increase
decrease
first decrease then increase
first increase then decrease

⇒ Which of the following conditions must be satisfied for a transistor to remain under saturation?
Its collector to base junction should be under forward bias.
Its collector to base junction should be under reverse bias.
Its emitter to base junction should be under reverse bias.
Its emitter to base junction should be under forward bias.
Select the correct answer from the codes given below:
1 and 2
1 and 3
2 and 3
1 and 4

⇒ The highest modulating frequency typically used in AM systems is
1 kHz
5 kHz
20 kHz
50 kHz

⇒
Match the following:
List I (Microwave device) List II (Application)
A. Reflex Klystron 1. Wideband amplification
B. TWT 2. Very low power amplification
C. Cavity Klystron 3. Low power FM generation
D. Maser 4. Frequency multiplication

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-3, B-4, C-1, D-2
A-3, B-1, C-4, D-2

⇒ The measure of mismatch between the load and the transmission line is known as
directivity
Gain
standing wave ratio
reflection coefficient

⇒ Which of the following microphones works on the piezoelectric effect?
Carbon
Condenser
Moving coil
Crystal

⇒ Which of the following statement regarding the advantages of the phase discriminator over the slope detector is false?
Better linearity
Fewer tuned circuits
Much easier alignment
Greater limiting

⇒ If the voltage across the last resistor is V, and all the resistor is unity. Then V_s is give
8 V
4 V
13 V
0

⇒ A P-channel MOSFET operating in the enhancement mode is characterized by V_t = - 4 V and I_DQ = - 10 mA, when V_GSQ = - 5.5 V, what will be V_GSQ if I_DQ = -15 mA and I_{D, on} = - 16 mA
- 2 V
3 V
0.13 V
1.3 V

⇒ If E_b, the energy per bit of a binary digital signal is 10^-6 watt sec. and the one sided power spectral density of the white noise N₀ = 10^-5 W/Hz, then the output SNR of the matched filter is
26 dB
10 dB
20 dB
13 dB

⇒ 2's complement representation of a 16 bit number (one sign bit and 15 magnitude bits) is FFFF. Its magnitude in decimal representation is
0
1
32, 767
65, 535

⇒ In one time constant, the current in a circuit reaches __________ percent of its final value.
10
37
63
85

⇒ The number of registers and flags in 8086 are
13 and 5 respectively
9 and 5 respectively
13 and 9 respectively
9 and 9 respectively

⇒ Flash ADC is
serial ADC
parallel ADC
series-parallel ADC
successive approximation ADC

⇒ Which of the following is error correcting code?
EBCDIC
Gray
Hamming
ASCII

⇒ It is required to study transients during switching process. Which CRO should be preferred?
Ordinary CRO
Dual beam CRO
Dual trace CRO
Storage oscilloscope

⇒ The units for electric dipole moment are
coulombs
colomb-metre
coulomb/metre
coulomb/m²

⇒ The amplifier used in bootstrap voltage sweep should have a gain of
1
+∞
-1
-∞

⇒ The permanent magnet field system of brushless dc servo- motor is generally on
stator
rotor
partly on stator and partly on rotor
either (a) or (b)

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒
Assertion (A): If frequency is high, the distance between transmitter and antenna may be an appreciable fraction of wavelength
Reason (R): Wavelength is inversely proportional to frequency.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a single phase full wave regulator feeding R-L load, the minimum firing angle can be zero.
TRUE
FALSE

⇒ The language PL / I has
one character set having 60 characters
one character set having 48 characters
one character set having 60 characters and another character set having 48 character
none of the above

⇒ The relation between the apparent power, actual power and reactive power is given by
Apparent power = actual power + reactive power
Apparent power = actual power - reactive power
Apparent power = (actual power)² - (reactive power)²
Apparent power = (actual power)² + (reactive power)²

	List I (Microwave device)		List II (Application)
A.	Reflex Klystron	1.	Wideband amplification
B.	TWT	2.	Very low power amplification
C.	Cavity Klystron	3.	Low power FM generation
D.	Maser	4.	Frequency multiplication

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math