Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Types of memory)</th> <th width="5%"></th><th>List II (Used As)</th></tr><tr><td>A.</td><td>DRAM</td><td>1.</td><td>Cache memory</td></tr><tr><td>B.</td><td>SRAM</td><td>2.</td><td>Main memory</td></tr><tr><td>C.</td><td>Parallel Access Registers</td><td>3.</td><td>BIOS memory</td></tr><tr><td>D.</td><td>ROM</td><td>4.</td><td>CPU registers</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-4, C-2, D-3, (B) A-3, B-4, C-2, D-1, (C) A-1, B-2, C-4, D-3, (D) A-3, B-2, C-4, D-1, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Types of memory)</th> <th width="5%"></th><th>List II (Used As)</th></tr><tr><td>A.</td><td>DRAM</td><td>1.</td><td>Cache memory</td></tr><tr><td>B.</td><td>SRAM</td><td>2.</td><td>Main memory</td></tr><tr><td>C.</td><td>Parallel Access Registers</td><td>3.</td><td>BIOS memory</td></tr><tr><td>D.</td><td>ROM</td><td>4.</td><td>CPU registers</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-4, C-2, D-3, (B) A-3, B-4, C-2, D-1, (C) A-1, B-2, C-4, D-3, (D) A-3, B-2, C-4, D-1, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I (Types of memory)		List II (Used As)
A.	DRAM	1.	Cache memory
B.	SRAM	2.	Main memory
C.	Parallel Access Registers	3.	BIOS memory
D.	ROM	4.	CPU registers

A-1, B-4, C-2, D-3

A-3, B-4, C-2, D-1

A-1, B-2, C-4, D-3

A-3, B-2, C-4, D-1

View Answer 1 -1

Explanation:-
Answer : C
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A trigonometric series has
single sided spectra
zero
sync function
undefined

⇒ Which of the following meters cannot measure a.c. quantities?
Thermocouple
Hot wire
P.M.M.C.
Electrodynamometer.

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ How can the bandwidth of a control system be increased?
By the use of phase lead network
By the use of phase lag network
By the use of both phase-lag and phase-lead network
By the use of cascaded amplifiers in the system

⇒ In a 3 phase full converter, the firing angle is less than 60°. The instantaneous output voltage
will have positive part only
will have both positive and negative parts
may have both positive and negative parts
will have negative part if load is inductive

⇒ Consider the following statements as regards noise

If Gaussian noise is applied at input of a rectifier, the output is not gaussian
The noise encountered on a telephone line consists of short, pulse type disturbances whose amplitude distribution is not Gaussian
Shot noise results from random emission of electrons from a cathode
Shot noise results from phenomenon associated with the flow of current across semi conductor junctions

Which of the above are correct?
1, 2, 3, only
1, 2, 4 only
1, 2, 3, 4
2, 3 only

⇒ For a base current of 10 μA, what is the value of collector current in common emitter if β_dc = 100
10 μA
100 μA
1 mA
10 mA

⇒ The characteristics of H and V sync pulses in a colour TV receiver are

H sync, pulses are narrow and have frequency of 15625 Hz
V sync, pulses are much wider and have frequency of 50 Hz
H and V pulses have almost the same size but frequencies of 15625 and 50 Hz respectively
V sync, pulses are very narrow but H sync, pulses are wide and their frequencies are 15625 Hz and 50 Hz respectively

Which of the above are correct?
1 and 2 only
1 only
3 only
4 only

⇒ Which quantity controls the effectiveness of LED in emitting light?
Applied voltage
Current
Extent of doping
Temperature

⇒ An increase in junction temperature of a semiconductor diode
causes a small increase in reverse saturation current
causes a large increase in reverse saturation current
does not affect reverse saturation current
may cause an increase or decrease in reverse saturation current depending on rating of diode

⇒ In a low level amplitude modulated system, the amplifier modulated stage must be
class C
linear
non linear
harmonic

⇒ A matched generator (Z_g = Z₀) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are
0.5 W, 0.5 W, 0 W
0 W, 0 W, 1 W
0.33 W each
0 W, 0.25 W, 0.25 W

⇒ Which of the following statements in FORTRAN 77 is non executable?
GO TO
RETURN
STOP
PARAMETER

⇒ When a complex signals is used to frequency modulate a carrier, the resulting sideband distribution is
symmetrical about the carrier
not necessarily symmetrical about the carrier
decided by the predominant sidebands
none of the above

⇒ A thyristor has its gate current zero. To start conduction the forward voltage must exceed
about 0.5 V
forward breakover voltage
on state voltage
peak working off state forward voltage

⇒ Which of the following modes cannot exist in rectangular resonant cavity?
TE₁₁₀
TE₀₁₁
TM₁₁₀
TM₁₁₁

⇒ A 7477 decoder drives
seven-segment display
nickel tape
relays
diode matrix

⇒ The addition of impurity in extrinsic semiconductor is about 1 part in 10⁸ parts.
TRUE
FALSE

⇒ Limiter is not essential in the following detector
foster-Seeley
ratio detector
balanced
none of the above

⇒ Two similar coils have self inductance of 1 mH each. Coefficient of coupling is 0.5. The mutual inductance M is
0.25 mH
0.5 mH
0.707 mH
1 mH

⇒ For type 0 system the starting point (i.e. ω = 0) of polar plot is finite and is on positive real axis.
TRUE
FALSE

⇒ The charge per proton is
1.6 x 10^-19 C
2.6 x 10^-19 C
0.6 x 10^-19 C
1.6 x 10^-13 C

⇒ Burden of an instrument transformer is expressed in
A
V-A
Ω
watt

⇒ In Gunn diode electrons are transferred from
Ridge guide is essentially a form of capacitively loaded guide
low to high mobility energy bands
valley to domain formation
domain to valley formation

⇒ Resonant circuits are used in
audio amplifiers
RF amplifiers
both audio and RF amplifiers
none of the above

⇒ VF glows with __________ colour when activated.
Red
Orange
Bluish green
none of these

⇒ Minimum number of 2-input NAND gates required to implement the function F = (x + y) (Z + W) is
3
4
5
6

⇒ The characteristic equation of flip-flop gives the next state Q_{N + 1} in terms of present state Q_N and the inputs. Which one of the following is the characteristic equation of J - K flip-flop?
Q_N+1 = JQ_N + KQ_N
Q_N+1 = J + KQ_N
Q_N+1 = KQ_N + JQ_N
Q_N+1 = K + JQ_N

⇒ The SCR would be turned OFF by voltage reversal of applied anode-cathode ac supply of frequency of
30 kHz
15 kHz
5 kHz
20 kHz

⇒ A 5000 W signal is attenuated by - 196 dB. The resultant signal strength is
1.26 x 10⁶ W
1.26 x 10^-2 W
1.26 x 10^-8 W
1.26 x 10^-16 W