Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>TTL</td><td>1.</td><td>Low propagation delay</td></tr><tr><td>B.</td><td>ECL</td><td>2.</td><td>Low power consumption</td></tr><tr><td>C.</td><td>MOS</td><td>3.</td><td>High packing density</td></tr><tr><td>D.</td><td>CMOS</td><td>4.</td><td>Saturated bipolar logic</td></tr></tbody></table>, Options are ⇒ (A) A-4, B-1, C-3, D-2, (B) A-4, B-3, C-1, D-2, (C) A-4, B-3, C-2, D-1, (D) A-3, B-1, C-4, D-2, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>TTL</td><td>1.</td><td>Low propagation delay</td></tr><tr><td>B.</td><td>ECL</td><td>2.</td><td>Low power consumption</td></tr><tr><td>C.</td><td>MOS</td><td>3.</td><td>High packing density</td></tr><tr><td>D.</td><td>CMOS</td><td>4.</td><td>Saturated bipolar logic</td></tr></tbody></table>, Options are ⇒ (A) A-4, B-1, C-3, D-2, (B) A-4, B-3, C-1, D-2, (C) A-4, B-3, C-2, D-1, (D) A-3, B-1, C-4, D-2, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I		List II
A.	TTL	1.	Low propagation delay
B.	ECL	2.	Low power consumption
C.	MOS	3.	High packing density
D.	CMOS	4.	Saturated bipolar logic

A-4, B-1, C-3, D-2

A-4, B-3, C-1, D-2

A-4, B-3, C-2, D-1

A-3, B-1, C-4, D-2

View Answer 1 -1

Explanation:-
Answer : A
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Very low response at very high frequencies	1.	Low-pass system
B.	Over shoot	2.	Velocity damping
C.	Synchro-control transformer output	3.	Natural frequency
		4.	Phase-sensitive modulation
		5.	Damping ratio

A-1, B-5, C-4
A-3, B-2, C-4
A-2, B-5, C-4
A-4, B-1, C-3

⇒ A loss less line of characteristic impedance Z₀ is terminated in pure reactance of -jZ₀ value. VSWR is
10
2
1
infinity

⇒ A modem is
a form of commutator
a device for digitizing speech
a circuit used for suppressing microwave mterference
an electronic circuit which carries out modulation and demodulation of a carrier frequency

⇒ The total area under the probability distribution curve is
1
0
depend upon curve equation
∞

⇒ In a high frequency coaxial line and the length of line characteristic impedance is a function of
properties of insulating material only
inner and outer conductor radius only
both (a) and (b)
neither (a) nor (b)

⇒ Impedance inversion may be obtained with
half wave line
a short circuited stub
complex impedance Z connected in series with line
quarter wave line

⇒ In a class C operation V_CC = 40 V, R_L = 50 Ω. The maximum load power can be
64 W
32 W
16 W
8 W

⇒ In an intrinsic semiconductor, at a given temperature T
the number of electrons-hole pairs generated per second due to thermal motion are equal to the number of electron-hole pairs lost per second due to recombination
the number of electron-hole pairs generated per second due to thermal motion is always less than the number of electron-hole pairs lost per second due to recombination
the number of electron hole pairs generated per second due to thermal motion is always more than the number of electron-hole pairs lost per second due to recombination
any of the above

⇒ Let JCOKE = 98 and LPEPSI = 42 Consider the statement 103
106
109
none of the above

⇒ A full wave rectifier supplies a load of 1 kΩ. The a.c. Voltage applied to the diodes is 220 - 0 - 220 Volts rms. If diode resistance is neglected, then Average d.c. Voltage
220 V
200 V
198 V
0 volts

⇒ If the transmission parameters of the given networks are A = C = 1, B = 2 and D = 3, then the value of Z_{m12/13 Ω
13/12 Ω
3 Ω
4 Ω}

⇒ The ac bridge in figure is balanced. Z₁ = 100∠30°, Z₂ = 150∠0°, Z₃ = 250∠ - 40° Then Z_{4375∠70° Ω
375∠ - 70° Ω
150∠0° Ω
150∠20° Ω}

⇒ In a 4 bit full adder how many half adders and OR gates are required
8 and 4
7 and 4
7 and 3
8 and 3

⇒ In the circuit shown below, the outputs Y₁ and Y₂ for the given initial condition Y₁ = Y₂ = 1 and after four input pulses wil
Y₁ = 1, Y₂ = 0
Y₁ = 0, Y₂ = 0
Y₁ = 0, Y₂ = 1
Y₁ = 1, Y₂ = 1

⇒ Which of the following quantities have same dimension in emu and esu?

Current
Electrical power
Electrical energy

Select the answer as per following codes
1 only
1 and 2
2 and 3
1 and 3

⇒ The double energy transients occur in the
pure inductive coil
R-L circuit
R-C circuit
R-L-C circuit

⇒ Circular polarization
is useful in reducing depolarization effect on received wave
involves critical alignment of transmitting and receiving antenna
is useful in discrimination between reception of adjacent beams
none of the above

⇒ Which of them has 10 inputs and 4 outputs?
Decimal to BCD encoder
BCD to decimal decoder
Octal to binary encoder
All encoders

⇒ Mobility is directly proportional to Hall coefficient.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	Title bar	1.	Window menu
B.	Control menu box	2.	First row of window
C.	start-button	3.	box in title bar
D.	Control	4.	Button on mouse

A-3, B-2, C-4, D-1
A-2, B-3, C-4, D-1
A-3, B-2, C-1, D-4
A-2, B-3, C-1, D-4

⇒ An LED has a rating of 2 V and 10 mA. It is used along with 6V battery. The range of series resistance is
0 to 200 Ω
200 - 400 Ω
200 Ω and above
400 Ω and above

⇒

Assertion (A): The forward resistance of a p-n diode is not constant.

Reason (R): The v-i characteristics of p-n diode is non-linear.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of accumulators in 6800 are
2
3
1
4

⇒

Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The voltage gain of which transistor configuration is less than unity?
CB
CE
CC
None

⇒ A voltage doubler circuit uses
two diodes
two capacitors
two diodes and two capacitors
none of the above

⇒ The internal structure of PL A is similar to
RAM
ROM
both RAM and ROM
neither RAM nor ROM

⇒ The boundary conditions at the interface between two dielectrics in an electric field are given by
D_normal = 0, E_tangential = 0
D_normal = 0, E_normal = 0
D_tangential = 0, E_tangential = 0
D_tangential = 0, E_normal = 0

⇒ In push button type telephone set, pressing a button generates
one frequency
two high frequencies
two low frequencies
one low frequency and one high frequency

⇒ Which of the following amplifier circuit using junction transistor has the best gain?
Common base
Common emitter
Common collector
All have the same gain