Question is ⇒ Match the following:<table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Resistance</td><td>1.</td><td>M-1L-2T2I2</td></tr><tr><td>B.</td><td>Inductance</td><td>2.</td><td>ML2T-2I-2</td></tr><tr><td>C.</td><td>Capacitance</td><td>3.</td><td>M-1L-2T4I2</td></tr><tr><td>D.</td><td>Reluctance</td><td>4.</td><td>ML2T-3I-2</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-2, C-3, D-4, (B) A-2, B-1, C-3, D-4, (C) A-4, B-2, C-3, D-1, (D) A-2, B-4, C-3, D-1, (E) , Leave your comments or Download question paper.

Question is ⇒ Match the following:<table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Resistance</td><td>1.</td><td>M-1L-2T2I2</td></tr><tr><td>B.</td><td>Inductance</td><td>2.</td><td>ML2T-2I-2</td></tr><tr><td>C.</td><td>Capacitance</td><td>3.</td><td>M-1L-2T4I2</td></tr><tr><td>D.</td><td>Reluctance</td><td>4.</td><td>ML2T-3I-2</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-2, C-3, D-4, (B) A-2, B-1, C-3, D-4, (C) A-4, B-2, C-3, D-1, (D) A-2, B-4, C-3, D-1, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I		List II
A.	Resistance	1.	M^-1L^-2T²I²
B.	Inductance	2.	ML²T^-2I^-2
C.	Capacitance	3.	M^-1L^-2T⁴I²
D.	Reluctance	4.	ML²T^-3I^-2

A-1, B-2, C-3, D-4

A-2, B-1, C-3, D-4

A-4, B-2, C-3, D-1

A-2, B-4, C-3, D-1

View Answer 1 -1

Explanation:-
Answer : C
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ How many number of branches the root loci of the equation s(s + 2)(s + 3) + K(s + 2) = 0 have?
Zero
One
Two
Three

⇒ The value of susceptibility in case of vacuum is taken as
zero
0.5
unity
infinity

⇒ Which one of the following is valid integer variable in FORTRAN 77?
BRG
IBRG
VS
PEC

⇒ The spectral range of a band pass signal extends from 10 MHz to 10.4 MHz. What is the minimum sampling frequency required for reconstruction?
20 MHz
20.8 MHz
20.4 MHz
0.8 MHz

⇒ A quarter wave line short circuited at load end behaves as
an inductance
an inductance and capacitance in series
a capacitance
an inductance and capacitance in parallel

⇒

Assertion (A): A resistor is a passive load and a transistor is an active load

Reason (R): Op-amp is mostly used in feedback mode

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In which of the following schemes are several channels interleaved and transmitted together?
TDM
FDM
group
subgroup

⇒ When two coupled coils of equal self inductance are cormected in series in one way the net inductance is 12 mH and when they are connected in the other way the net inductance is 4 mH. The maximum value of inductance when they are connected in parallel is
2 mH
3 mH
4 mH
6 mH

⇒ A Q meter uses the principle of
variation of self inductance
variation of mutual inductance
series resonance
none of the above

⇒

Assertion (A): Hall effect is used to determine whether the semi- conductor is p or n type.

Reason (R): Under the influence of field, holes and electrons move in opposite direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ It is required to measure pressure using LVDT. The additional device needed is
strain gauge
pitot tube
bourden tube
rotameter

⇒ A high pulse repetition frequency in a radar
increases the maximum range
decreases the maximum range
has no effect on the maximum range
either (a) or (b) depending on other factors

⇒ Assuming accumulator contain A 64 and the carry is set (1).What will register A and (CY) contain after RAR?
4 DH, 0
D 3H, 0
4 DH, 1
53 H, 0

⇒ Which of the following is not necessarily the advantages of a push pull amplifier?
It gives more output
It removes odd a well as even harmonics
There is no effect of ripple of the power supply
It consumes least power

⇒ A liquid has N permanent dipoles μ_p per unit volume and has been subjected to dc field for a long time such that orientation polarization is P₀. At t = 0, the field is suddenly removed, then polarization
will remain constant at P₀
will become zero at t = 0
will delay to zero with a time constant
either b or c

⇒ As per Shannon-Hartley theorem, a noise less Gaussian channel has
zero capacity
infinite capacity
small capacity
none of the above

⇒ To measure a resistance of about 8 ohms we should use
Kelvin's double bridge
Wheatstone bridge
Meggar
Either (b) or (c)

⇒ A uniform plane wave travelling in air is incident on the plane boundary between air and another dielectric medium with e_r = 15. The reflection coefficient for normal incidence is
0.6 ∠0°
1 ∠0°
0.6 ∠180°
1.2 ∠180°

⇒ In practical commercial FM system, channel bandwidth is
150 kHz
100 kHz
88 MHz
108 MHz

⇒ Mutual impedance is not depend upon
magnitude of induced current
tuning condition
self impedance
phase relationship between induced and original currents

⇒ Consider the following amplifier with negative feed
-9 x 10^-3
9 x 10^-3
-11 x 10^-3
11 x 10^-3

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ Choose correct option
var (X + Y) = Var (X) + Var (Y)
var (X - Y) = Var (X) + Var (Y)
var (X + Y) = Var (X) x Var (Y)
Both (a) and (b)

⇒ At 0 K, silicon and germanium behave like monoatomic crystals.
TRUE
FALSE

⇒

Assertion (A): The inductance of an iron cored solenoid is not constant.

Reason (R): BH curve of an iron specimen is non-linear.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The number of valence electrons in acceptor impurity are
5
4
3
1

⇒ In a transmission line, losses due to dielectric heating are
proportional to voltage and inversely proportional to Z₀
proportional to voltage and proportional to Z₀
proportional to current and proportional to Z₀
proportional to current and inversely proportional to Z₀

⇒ The units for intrinsic strength of dielectric are
kV
kV/m
A
A/m

⇒ If x = 0.1396 radians, the values of 1 - cos x and 2 sin² (x / 2) using floating point arithmetic with a 4 digit mantissa are respectively
.1000 E - 1 each
.9727 E - 2 each
.1000 E - 1 and .9727 E - 2 respectively
.9727 E - 2 and .1000 E - 1 respectively

⇒ Which of the following frequency is likely to be associated with AM radio broadcast?
1000 kHz
100 MHz
500 MHz
10 GHz