Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Digital counter</td><td>1.</td><td>Measurement of harmonics</td></tr><tr><td>B.</td><td>Schering Bridge</td><td>2.</td><td>Measurement of frequency</td></tr><tr><td>C.</td><td>Meggar</td><td>3.</td><td>Measurement of loss angle of dielectric</td></tr><tr><td>D.</td><td>Spectrum analyser</td><td>4.</td><td>Measurement of insulation resistance</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-2, C-3, D-4, (B) A-4, B-3, C-2, D-1, (C) A-2, B-3, C-4, D-1, (D) A-4, B-1, C-3, D-2, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Digital counter</td><td>1.</td><td>Measurement of harmonics</td></tr><tr><td>B.</td><td>Schering Bridge</td><td>2.</td><td>Measurement of frequency</td></tr><tr><td>C.</td><td>Meggar</td><td>3.</td><td>Measurement of loss angle of dielectric</td></tr><tr><td>D.</td><td>Spectrum analyser</td><td>4.</td><td>Measurement of insulation resistance</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-2, C-3, D-4, (B) A-4, B-3, C-2, D-1, (C) A-2, B-3, C-4, D-1, (D) A-4, B-1, C-3, D-2, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I		List II
A.	Digital counter	1.	Measurement of harmonics
B.	Schering Bridge	2.	Measurement of frequency
C.	Meggar	3.	Measurement of loss angle of dielectric
D.	Spectrum analyser	4.	Measurement of insulation resistance

A-1, B-2, C-3, D-4

A-4, B-3, C-2, D-1

A-2, B-3, C-4, D-1

A-4, B-1, C-3, D-2

View Answer 1 -1

Explanation:-
Answer : C
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The oscillator shown in figure
Clapp oscillator
R-C Phase shift oscillator
Hartley oscillator
Colpitt's oscillator

⇒ The energy stored in a coil is 108 J. It is opened suddenly in 10 ms. The power dissipated instantaneously across the blades of switch is
108 W
1080 W
10800 W
108000 W

⇒ Three analog signals, having bandwidths 1200 Hz, 600 Hz, 600 Hz are sampled at their Nyquist rates, encoded with 12 bit words, and time division multiplexed. The bit rate for the multiplexed signal is
115.2 kbps
28.8 kbps
57.6 kbps
38.4 kbps

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register D are stored
054 CH
054 DH
054 EH
054 FH

⇒ In the circuit of figure, the waveshape of load current when thyristor conducting
constant
increasing exponentially
decreasing exponentially
either (b) or (c)

⇒ The capacitance of a parallel plate capacitor varies as per the equation C(t) = C₀ (1 - cos ωt). It is connected to a battery of V volts. The equation for current is
ωC₀V (1 - cos ωt)
ωC₀V(1 - sin ωt)
ωC₀V (1 - sin 2ωt)
ωC₀V sin ωt

⇒ For oscillations to starts, the loop gain A β of the oscillator must be initially
less than unity
0.5
1
more than unity

⇒ Which capacitor-store higher amount of energy?
Air capacitor
Paper capacitor
Mica capacitor
Plastic film capacitor

⇒

Assertion (A): If a carrier is modulated by three sine waves and m₁, m₂, m₃ are the modulation indices, the total modulation index m_t
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In a class C operation V_CC = 30 V and V_CE(sat) = 2 V. The efficiency is
0.9375
0.88
0.0666
0.0333

⇒ The minimum sampling frequency in sample/sec. required to reconstruct the following signal from its samples wuthout distor
2 x 10³
4 x 10³
6 x 10³
8 x 10³

⇒ What is typical bandwidths of a 2-wire telephone line?
300 Hz to 3.4 kHz
20 Hz to 4 kHz
dc to 4 kHz
20 Hz to 20 kHz

⇒ Fourier transform F(jω) of an arbitrary signal has the property
F(jω) = F(- jω)
F(jω) = - F(- jω)
F(jω) = F*(- jω)
F(jω) = - F*(jω)

⇒ Consider the following rules about integer constant in C

Which of the above are correct?
All
1, 2, 3, 4 only
1, 2, 3, 5
2, 3, 4, 5 only

⇒ In a full wave voltage doubler circuit, the input frequency is 560 Hz. The ripple frequency is
25 Hz
50 Hz
100 Hz
200 Hz

⇒

Assertion (A): The circuit in figure produces repetitive narrow pulses when input is fed with sine or triangular waveform having peak value more than + V

Reason (R): The high gain op-amp produces voltages at two levels. If input is more than + V, the output is + 15 V otherwise the output is - 1
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ For measurement of surface temperature of solids the elements of RTD is usually in the shape of
bar
coil
flat grid
either (a) or (b)

⇒ The model of a system
is unique
depends on desired degree of accuracy
depends on the type of analysis
both (b) and (c)

⇒ In a Hurwitz polynomial
all coefficients are non-negative
the coefficients may be positive or negative
all coefficients are negative
all coefficients are non-negative and all zeros should be either in left half plane or simple on the imaginary axis

⇒ Consider the following:

The correct statements are
1 and 2 only
1, 2 and 3 only
1, 2, 3, 4
2, 3 only

⇒ In a ring counter for N clock pulses the scale for the counter is
N : 1
N : 2
N : 10
N : 100

⇒ A P-N junction diode dynamic conductance is directly proportional to
the applied voltage
the temperature
its current
thermal voltage

⇒ A circular waveguide carries TE₁₁ mode whole radial electric field is give
10 cm
3 p cm
2 p cm
8 cm

⇒ In figure V_CE (sat) = 0.1 V. Then I_C (sa
10 mA
20 mA
30 mA
40 mA

⇒ In a microprocessor, the service routine for a certain interrupt starts from a fixed location of memory which cannot be externally set, but the interrupt can be delayed or rejected. Such an interrupt is
non-maskable and non-vectored
maskable and non-vectored
non-maskable and non-vectored
maskable and vectored

⇒ A transmission line has characteristics impedance of (75 + j 0.01) Ω and is terminated in a load impedance of (70 + j 50) Ω. The transmission coefficient will be
1.70 - j 2.97
0.08 + j 0.32
1.32 + j 1.38
1.08 + j 0.32

⇒ If f(t) = - f(- t) and f(t) satisfies Dirichlet conditions, then f(t) can be expanded in Fourier series having
sine terms only
cosine terms only
cosine and constant terms
sine and constant term

⇒ Consider the following symbols for arithmetic operators for integers

Which of the above are used in Pascal?
1, 2 and 4 only
All
1, 2, 3 only
1 and 4 only

⇒ As compared to a BJT amplifier circuit, a JFET amplifier circuit
has low input impedance
has high input impedance
has very low input impedance
may have either low or high input impedance

⇒ The rms value of wave in figur
about 95 V
about 80 V
about 50 V
about 25 V