Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Detection of a periodic signal in noise</td><td>1.</td><td>Increase in band-width</td></tr><tr><td>B.</td><td>Recovery of a band limited signal from its uniformly sampled values</td><td>2.</td><td>Slope over load error</td></tr><tr><td>C.</td><td>Finer quantization</td><td>3.</td><td>Nyquist rate of signals</td></tr><tr><td>D.</td><td>Delta modulation</td><td>4.</td><td>Cross correlation</td></tr></tbody></table>, Options are ⇒ (A) A-4, B-3, C-1, D-2, (B) A-3, B-2, C-1, D-4, (C) A-4, B-3, C-2, D-1, (D) A-3, B-2, C-4, D-1, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>Detection of a periodic signal in noise</td><td>1.</td><td>Increase in band-width</td></tr><tr><td>B.</td><td>Recovery of a band limited signal from its uniformly sampled values</td><td>2.</td><td>Slope over load error</td></tr><tr><td>C.</td><td>Finer quantization</td><td>3.</td><td>Nyquist rate of signals</td></tr><tr><td>D.</td><td>Delta modulation</td><td>4.</td><td>Cross correlation</td></tr></tbody></table>, Options are ⇒ (A) A-4, B-3, C-1, D-2, (B) A-3, B-2, C-1, D-4, (C) A-4, B-3, C-2, D-1, (D) A-3, B-2, C-4, D-1, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I		List II
A.	Detection of a periodic signal in noise	1.	Increase in band-width
B.	Recovery of a band limited signal from its uniformly sampled values	2.	Slope over load error
C.	Finer quantization	3.	Nyquist rate of signals
D.	Delta modulation	4.	Cross correlation

A-4, B-3, C-1, D-2

A-3, B-2, C-1, D-4

A-4, B-3, C-2, D-1

A-3, B-2, C-4, D-1

View Answer 1 -1

Explanation:-
Answer : A
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of these has a magnetic brake?
Thermocouple ammeter
Energy meter
Dynamometer wattmeter
Frequency meter

⇒ Which of the following statements is incorrect?
A mesh with two resistors has two mesh currents
The algebraic sum of all voltages around any mesh or any loop must be zero
The principle node is a function where branch current can divide or combine
A Norton is a series circuit

⇒ Which is correct with respect to computer memory?
Only a particular address can have a particular memory
Any address can have any memory
To read a word from computer memory, it is not necessary to specify a location
None of the above

⇒ An RLC series circuit has R = 8 Ω, X_L = 8 Ω and X_C = 8 Ω Its impedance is
8 + j 16 Ω
8 + j 8 Ω
8 Ω
24 Ω

⇒ Thermal noise is independent of
temperature
bandwidth
centre frequency
Boltzmann constant

⇒ When a source is delivering maximum power to a load through a network, the ratio of power delivered to the source power
may be 50% or less than 50%
is 50%
may be 50% or more than 50%
may be 50% or more less than 50%

⇒ In the case of the circuit shown in the figure V_io = 10 mV dc maximum, the maximum possible output offset voltage V_oo caused by the input offset voltage V_io with respect to groun
60 mV dc
110 mV dc
130 mV dc
150 mV dc

⇒ The drain characteristics of JFET in operating region, are
inclined upwards
almost flat
inclined downwards
inclined upwards or downwards

⇒ A rare gas having N atoms/m³ is subjected to an electric field E. The electric dipole moment per unit volume is proportional to N and E.
TRUE
FALSE

⇒ If the frequency is less than the damped frequency in a series- inverter
the distortion of output voltage waveform is low
the distortion of output voltage waveform is high
the distortion of output voltage may be high or low depending on the load impedance
none of the above

⇒ In the given figure the input frequency f = 0.1 (1/2 p
0 dB
3 dB
-3 dB
20 dB

⇒ In the circuit, S was initially open. At time t = 0, S is closed. When the current through the inductor is 6 A, the rate of change of current through the resistor is 6 A/s. The value of the inductor woul
1 H
2 H
3 H
4 H

⇒ To obtain very high I/P and O/P impedances in a feedback amplifier, the topology used is
voltage series
current series
voltage shunt
current shunt

⇒ As B is increased from zero to about 2T, μ_r, of a ferromagnetic material
increase
decrease
first increases then decreases
remains the same

⇒ Impedance Z as shown in the given figur
j29 Ω
j9 Ω
j19 Ω
j35 Ω

⇒ Which of the following is the least important consideration while selecting a logic technology?
Power dissipation
Noise immunity
Number of pins
Cost

⇒ A 60 W, 23 V bulb is used for 45 minutes. The electrical energy consumed in commercial units is
2700 units
0.45 units
4.5 units
0.045 units

⇒ The function δ'(t - b) is a unit doublet.
TRUE
FALSE

⇒

Assertion (A): For a given system only one of the static error constants is finite and significant.

Reason (R): If finite static error constant is large, the loop gain becomes smaller as ω approaches zero.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A TRIAC is a semiconductor device which acts as a
2 terminal unidirectional switch
2 terminal bidirectional switch
3 terminal bidirectional switch
4 terminal multidirectional switch

⇒ In a half bridge inverter the gate pulses of the two thyristors have a phase displacement of
60°
90°
120°
180°

⇒

JCOKE
8
11
16
20



⇒ A negative-feedback closed-loop system is supplied to an input 5 V. The system has a forward gain of 1 and a feedback gain of 1 and a feedback gain of 1. What is the output voltage?
1.0 V
1.5 V
2.0 V
2.5 V

⇒ Inductors used at V.H.F. are made using
air core
cast iron cored
sheet steel cored
thin film technique

⇒ Assertion (A): If minimum phase system has a gain margin of 8 dB and phase margin of 21°, the system is stable.
Reason (R): For a minimum phase system both GM and PM must be positive for the system to be stable.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ An RLC series circuit has R = 1 Ω, L = 1 H, C = 1 F. The damping ratio is
More than 1
1
0.5
Zero

⇒ Pick the Odd one out
MOSFET
FET
Planer transistor
Unijunction transistor

⇒ Match the following:
 List I  List II 
A. Resistance 1. Current noise
B. Diode 2. Partition noise
C. Triode 3. Shot noise
D. p-n junction 4. Atmospheric noise
  5. Johnson noise

A-5, B-3, C-2, D-1
A-1, B-2, C-3, D-5
A-3, B-5, C-1, D-2
A-3, B-5, C-2, D-1

⇒ In a feedback series regular circuit, the output voltage is regulated by controlling the
magnitude of the I/P voltage
gain of the feed back BJT
reference Voltage
voltage drop across the series pass transistor

⇒ In a single sideband suppressed carrier AM system, the modulation index is changed from 0 to 1, the power content of the signal
will be quarter
will be doubled
will increase by 50 percent
will increase by 25 percent

	List I		List II
A.	Resistance	1.	Current noise
B.	Diode	2.	Partition noise
C.	Triode	3.	Shot noise
D.	p-n junction	4.	Atmospheric noise
		5.	Johnson noise









Users Also Read
Previous Papers
Aptitude
Reasoning
Gen.Knowledge
Speak English
English / Verbal
Online / Mock Test
Vedic Math







    
	
	




    
	StudySite.org is world's best free online study content provider, Copyright © 2024 by 
StudySite.org All Rights Reserved