Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>45</td><td>1.</td><td>10110100</td></tr><tr><td>B.</td><td>90</td><td>2.</td><td>11010010</td></tr><tr><td>C.</td><td>180</td><td>3.</td><td>01011010</td></tr><tr><td>D.</td><td>210</td><td>4.</td><td>00101101</td></tr><tr><td> </td><td> </td><td>5.</td><td>10101000</td></tr></tbody></table>, Options are ⇒ (A) A-3, B-4, C-5, D-2, (B) A-4, B-3, C-5, D-2, (C) A-4, B-3, C-1, D-2, (D) A-3, B-4, C-2, D-1, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I </th> <th width="5%"></th><th>List II </th></tr><tr><td>A.</td><td>45</td><td>1.</td><td>10110100</td></tr><tr><td>B.</td><td>90</td><td>2.</td><td>11010010</td></tr><tr><td>C.</td><td>180</td><td>3.</td><td>01011010</td></tr><tr><td>D.</td><td>210</td><td>4.</td><td>00101101</td></tr><tr><td> </td><td> </td><td>5.</td><td>10101000</td></tr></tbody></table>, Options are ⇒ (A) A-3, B-4, C-5, D-2, (B) A-4, B-3, C-5, D-2, (C) A-4, B-3, C-1, D-2, (D) A-3, B-4, C-2, D-1, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I		List II
A.	45	1.	10110100
B.	90	2.	11010010
C.	180	3.	01011010
D.	210	4.	00101101
		5.	10101000

A-3, B-4, C-5, D-2

A-4, B-3, C-5, D-2

A-4, B-3, C-1, D-2

A-3, B-4, C-2, D-1

View Answer 1 -1

Explanation:-
Answer : B
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following is the main advantage of PCM system?
Lower noise
Lower power
Lower bandwidth
All of the above

⇒ The number of spectral component when two sine wave of same frequency multiplied is
2
3
∞
4

⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies

⇒ (2)₃ + (3)₄ = (?)₅
4
11
none of these
not possible

⇒ In a linear op-amp circuit
the product of gain and bandwidth is constant
input can be dc only
input can be ac only
saturation may occur

⇒ The merger of hole and free electron is called
covalent bonding
recombination
thermal energy
free electrons

⇒ Which statement is true for an ac circuit?
Active power is always less than apparent power
Active power cannot be more than apparent power
Active power is always more than reactive power
Active power cannot be more than reactive power

⇒ Bus bars are always meant for very heavy currents.
TRUE
FALSE

⇒ In figure, A is ideal ammeter having zero resistance. It will read __________ amp
2
2.5
3
4

⇒ For measurement of surface temperature of solids the elements of RTD is usually in the shape of
bar
coil
flat grid
either (a) or (b)

⇒ For the time domain response shown in figure the
lies in left half plane
lies in right half plane
lies at origin
may be complex or imaginary

⇒ In the op-amp circuit of figure, V_{0V_i
3 V_i
5 V_i
0.5 V_i}

⇒ Multiphase choppers are used in
low power circuits
high power circuit
both low and high power circuits
medium power circuits

⇒ In which of the following device electrons will be the majority carriers?
P-type semiconductor
N-type semiconductor
N-P-N transistor
P-N-P transistor

⇒ In a series RLC circuit the dB level of currents at half power frequencies as compared to current at resonance is
3
-3
0.5
-0.5

⇒ In a CD the sampling frequency is nearly
half the highest frequency in audio signal
equal to highest frequency in audio signal
double the highest frequency in audio signal
four times the highest frequency in audio signal

⇒ A PIN diode can be used
as a shunt mounted switch
as a series mounted switch
both as series or shunt mounted switch
non of the above

⇒ A two branch parallel tuned circuit has a coil of resistance 100 Ω and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency, the dynamic resistance is
1 Ω
10 Ω
100 Ω
more than 100 Ω

⇒ On which bands, do the optical fibers operate?

Ultra violet band
Ultra high frequency band
Visible light band
Infrared band

Select the correct answer from the codes given below:
1 only
1 and 2 only
1, 2 and only
1, 3 and 4

⇒ Each of two cascaded stages has a voltage gain of 30. The overall gain is
3
9
30
900

⇒ Consider the following statements as regards IF in radio receivers

If IF is too high, poor selectivity and poor adjacent channel rejection could result
If IF is high, tracking difficulties increase
A very low IF makes selectivity too sharp
As IF is decreased, image frequency rejection becomes better

Which of the above are correct?
1, 2, 3, 4
1, 2, 3
2, 3, 4
1, 3, 4

⇒ The horizontal intercept of dc load line is the same as ideal
cut off point
saturation point
operating point
quasi saturation point

⇒ What is the purpose of a start in RS232 serial communication protocol?
To synchronise receiver for receiving every byte
To synchronise receiver for receiving a sequence of byte
Acts as a parity bit
To synchronise receiver for receiving the last byte

⇒ A single phase semiconverter is feeding a highly inductive load. The circuit has a freewheeling diode across the load and firing angle is a. During one cycle of input voltage, the total duration of conduction of freewheeling diode is
a
2 a
4 a
0.5 a

⇒ The skip distance does not depends upon
the power transmitted
type of wave propagation
angle of beaming of the wave
frequency of the signal transmitted

⇒ Three analog signals, having bandwidths 1200 Hz, 600 Hz, 600 Hz are sampled at their Nyquist rates, encoded with 12 bit words, and time division multiplexed. The bit rate for the multiplexed signal is
115.2 kbps
28.8 kbps
57.6 kbps
38.4 kbps

⇒ Frequency frogging is used in a carrier system to
conserve frequencies
reduce distortion
reduce cross talk
none of the above

⇒ Nyquist stability criterion uses open loop frequency response characteristics.
TRUE
FALSE

⇒ A two branch parallel circuit has a 20 Ω resistance and 1 H inductance in one branch and a 100 μF capacitor in the second branch. It is fed from 100 V ac supply, at resonance, the input impedance of the circuit is
500 Ω
50 Ω
20 Ω
5 Ω

⇒ 24 telephone channels, each band limited to 3.4 kHz are to be time division multiplexed using PCM. If sampling frequency is 10 kHz and number of quantization levels is 128, the required bandwidth of PCM is
1.68 MHz
240 kHz
81.6 kHz
3.072 MHz