Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Match the following:
| ||||||||||||||||||||

A. | A-1, B-3, C-4 [Correct Answer] | ||||||||||||||||||||

B. | A-2, B-3, C-4 [Wrong Answer] | ||||||||||||||||||||

C. | A-3, B-1, C-2 [Wrong Answer] | ||||||||||||||||||||

D. | A-1, B-2, C-3 [Wrong Answer] | ||||||||||||||||||||

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ The rating of a transformer to deliver 100 watts of D.C. power to a load under half wave rectifier will be nearly

1 kVA

350 VA

175 VA

108 VA

⇒ The disadvantage of transformer coupling in amplifier is

cost of transformer at audio frequencies

size of transformer at audio frequencies

size of transformer at radio frequencies

cost and size of transformer at audio frequencies

⇒ The drain characteristics of JFET are drawn between

V

_{GS}and V

_{DS}for different values of drain current

drain current and V

_{GS}for different values of V

_{DS}

drain current and V

_{DS}for different values of V

_{GS}

drain current and V

_{GS }for one value of V

_{DS}

⇒ In a positive edge triggered JK flip flop, J = 1, K = 0 and clock pulse is rising Q will

be 0

be 1

show no change

toggle

⇒ In which of the transformer is the secondary nearly short circuited under normal operating conditions?

CT

PT

Distribution transformer

Power transformer

⇒ In most electric irons, the thermister used for controlling temperature is

vapour-filled bulb

high-expansion steel rod

bimetallic strip

thermopile

⇒ (2)

_{3}+ (3)

_{4}= (?)

_{5}

4

11

none of these

not possible

⇒ For the wave shown in figure, the average and rms values

50 A and 57.73 A

57.73 A and 50 A

25 A and 57.73 A

57.73 A and 70.7 A

⇒ As per time displacement theorem in Laplace transformation, displacement in the time domain by T becomes

division by s in the

*s*domain

division by

*e*

^{-sT}in the

*s*domain

multiplication by

*s*in the

*s*domain

multiplication by

*e*

^{-sT}in the

*s*domain

⇒

**Assertion (A):** Thevenin's theorem and Norton's theorem are dual of each other.

**Reason (R):** Voltage source can be converted into current source and vice versa.

Both A and R are true and R is correct explanation of A

Both A and R are true and R is not the correct explanation of A

A is true but R is false

A is false but R is true

⇒ Transformer coupling in transistor amplifier circuits provides high efficiency, because

d.c. resistance is low

collector voltage is stepped up

flux linkages are incomplete

all of the above

⇒ In a specimen of ferromagnetic material, as the flux density is increased from zero to 2.5 T, µ

_{r}will

increase

decrease

first decrease then increase

first increase then decrease

⇒ Transistor T

_{1}operates at 30 kHz and T

_{2}operates at 300 Hz. The flicker noise is

not depend on frequency

T

_{1}> T

_{2}

T

_{1}= T

_{2}

T

_{1}< T

_{2}

⇒ The three sides of an admittance triangle denote

G, B, Y

R, X, Y

G, B, Z

(R, Y, Z) or (R, X, Z)

⇒ Mark out the WRONG statem

Needs very high-speed burst modems

Faces no problems caused by intermodulation of carriers so that transponder can be used at its full power

Needs high-speed manipulation of bit streams

Is less flexible so that channels of widely different capacities cannot used and intermixed

⇒ Read the following statements about sets

- If A and B are sets then A + B denotes union of sets A and B.
- The union of A and B is that set whose elements are in either A or B or both.
- If A and B are sets, then difference of sets A and B is denoted by A - B.
- A - B in the set obtained by removing elements of A from B.

All

1, 2 and 3 only

2 and 3 only

1 and 4 only

⇒ In a crystal oscillator of the Colpitt's oscillator type, the crystal is put is place of the

resistor R

_{1}

condenser C

_{2}

condenser C

_{1}

inductor L

⇒ (1 2 1)

_{x}= (1 0 0)

_{4}Then

*x*is equal to

2

3

5

does not exist

⇒ A voltage wave having 5% fifth harmonic content is applied to a series RC circuit. The percentage fifth harmonic content in the current wave will be

0.05

more than 5%

less than 5%

equal or more than 5%

⇒ In the circuit shown in given figure, the values of i(0

^{+}) and I(∞), will be respecti

zero and 1.5 A

1.5 A and 3 A

3 A and zero

3 A and 1.5 A

⇒ A two stage amplifier has an upper cutoff frequency of 2 MHz and a lower cutoff frequency of 2 MHz and a lower cut off frequency of 30 Hz. If both stages are similar, their individual upper and lower cut off frequencies respectively are

4 MHz and 60 MHz

3 MHz and 20 Hz

3 MHz and 60 Hz

4 MHz and 20 Hz

⇒ Choose proper substitutes for

*x*and

*y*to make the following statement corr

*x*: Reverse,

*y*: Reverse

*x*: Reverse,

*y*: forward

*x*: Forward,

*y*: Reverse

*x*: forward,

*y*: forward

⇒ In the circuit of figure diode will con

from 90 to 180° in the positive half cycle

from 30° to 180° in the positive half cycle

from 50° to 160° in the positive half cycle

from 30° to 150° in the positive half cycle

⇒ As compared to TTL, CMOS logic has

higher speed of operation

higher power dissipation

smaller physical size

all of the above

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig

1 and 4

1 and 2

3 and 4

2 and 3

⇒ The I/P impedance of a short circuited quarter wave long transmission line is

purely reactive

purely resistive

depend on the characteristic impedance of the line

none of the above

⇒ Noise limiter is provided on AM receivers to

reduce interfering noise due to ignition system

reduce noise due to electrical storms

reduce interference due to electrical machinery

all of the above

⇒ When Z

_{1}<< Z, The circuit of figure work

inverting amplifier

Schmitt trigger

non-inverting amplifier

source follower

⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti

0.02 V/μsec, 1.59 KHz

0.04 V/μsec, 1.59 KHz

0.02 V/μsec, 3.58 KHz

0.02 V/μsec, 1.59 KHz

⇒ A step down cycloconverter has an input frequency

*f*. If it uses natural commutation, the output frequency

must be a sub-multiple of input frequency

can be any frequency

must be an even sub-multiple of input frequency

must be an odd sub-multiple of input frequency