Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Operator in C) </th> <th width="5%"></th><th>List II (Priority of Operation) </th></tr><tr><td>A.</td><td>!</td><td>1.</td><td>1</td></tr><tr><td>B.</td><td>< ></td><td>2.</td><td>2</td></tr><tr><td>C.</td><td>∗</td><td>3.</td><td>3</td></tr><tr><td>D.</td><td>=</td><td>4.</td><td>4</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-2, C-3, D-4, (B) A-1, B-3, C-2, D-4, (C) A-4, B-3, C-2, D-1, (D) A-3, B-2, C-1, D-4, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Operator in C) </th> <th width="5%"></th><th>List II (Priority of Operation) </th></tr><tr><td>A.</td><td>!</td><td>1.</td><td>1</td></tr><tr><td>B.</td><td>< ></td><td>2.</td><td>2</td></tr><tr><td>C.</td><td>∗</td><td>3.</td><td>3</td></tr><tr><td>D.</td><td>=</td><td>4.</td><td>4</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-2, C-3, D-4, (B) A-1, B-3, C-2, D-4, (C) A-4, B-3, C-2, D-1, (D) A-3, B-2, C-1, D-4, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I (Operator in C)		List II (Priority of Operation)
A.	!	1.	1
B.	< >	2.	2
C.	∗	3.	3
D.	=	4.	4

A-1, B-2, C-3, D-4

A-1, B-3, C-2, D-4

A-4, B-3, C-2, D-1

A-3, B-2, C-1, D-4

View Answer 1 -1

Explanation:-
Answer : B
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A 3-digit voltmeter having a resolution of 100 mV can be used to measure a maximum of
100 V
200 V
1000 V
5000 V

⇒ Which of the following is 'synchronous'?
Half adder
Full adder
R-S flip-flop
Clocked R-S flip-flop

⇒ Of the four INSAT-I satellites planned by India so for, only __________ has proved to be successful.
INSAT-IA
INSAT-IB
INSAT-IC
INSAT-ID

⇒ A resistor R of 1 Ω and two inductor L₁ and L₂ of inductances 1 H and 2 H respectively, are connected in parallel. At some time, the current through L₁ and L₂ are 1 A and 2 A, respectively. The current through R at time t = ∞ will be
zero
0.0416666666666667
0.0833333333333333
0.125

⇒ Which of the following microphones has highest output impedance?
Carbon
Ribbon
Crystal
Condenser

⇒ In a Weston synchronoscope the deflecting torque is zero when
currents in fixed and moving coils are in phase
currents in fixed and moving coils are out of phase by 90°
currents in fixed and moving coils are out of phase by 60°
none of the above

⇒ All network theorems of dc are applicable to ac also with different quantities taken as phasors.
TRUE
FALSE

⇒ Consider the following about 'arrays' in C

An array is a collection of similar elements.
An array can not have 10 numbers 5 of which are ints and 5 are floats.
An array can have ints and chars in the same array.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ In figure, A is ideal ammeter having zero resistance. It will read __________ amp
2
2.5
3
4

⇒ The power to the base unit of a cordless telephone is supplied by
battery
AC mains
both battery and AC mains
either battery or AC mains

⇒

Assertion (A): In class C amplifier the efficiency is more than that for other classes of amplifiers

Reason (R): In class C amplifier we can get high efficiency over a wideband

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ When two conductors carry currents in the same direction the force is repulsive.
TRUE
FALSE

⇒ 7483 is a TTL binary adder. It can add
two 4-bit binary numbers
four 6-bit binary numbers
four 8-bit binary numbers
any number of 4-bit numbers

⇒ VSWR can have any value between
0 and 1
- 1 to + 1
0 to ∞
1 to ∞

⇒

Assertion (A): In an intrinsic semiconductor J = (μ_n x μ_p)en_i.

Reason (R): Intrinsic charge concentration n_i at temperature T is given by n_i² = A₀ T³ e^-E_G0/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ The induced magnetic dipole moment has a direction opposite to the applied magnetic field.
TRUE
FALSE

⇒ A super heterodyne receiver has an input circuit tuned to a 570 KHz signal. If the intermediate frequency of the amplifier is tuned to 455 KHz. The quality factor Q for a Image Rejection ratio of 125?
100
56.81
42.74
87

⇒ The amount of dielectric heating is inversely proportional to frequency.
TRUE
FALSE

⇒ Which of the following READ statements is correct in FORTRAN 77?
READ *, HONEY (I), I = 1, 5
READ *, (HONEY (I), I = 1, 5)
READ * HONEY I, I = 1, 5
READ HONEY I, I = 1, 5

⇒ In a two phase servomotor the two stator windings have a phase difference of
30°
45°
90°
135°

⇒ Typical values of current gains for CE, CB and CC amplifiers are
120, 120 and 1 respectively
120, 1 and 120 respectively
1, 120 and 120 respectively
1, 1 and 120 respectively

⇒ The total area under the probability distribution curve is
1
0
depend upon curve equation
∞

⇒ When an SCR is in forward blocking mode, the applied voltage
appears across only one junction
is equally shared by two junctions
is equally shared by three junctions
may appear across one or more junctions

⇒ A λ/4 long high frequency transmission line is terminated into one impedance Z_R. If Z₀ be the characteristic impedance of the line, then input impedance Z_in is
Z_oZ_R
Z²_R/Z_o
Z²₀/Z_R
Infinity

⇒ If all the LEDs in a seven segment display are turned on, the number displayed is
1
3
0
8

⇒ The numerical value of directivity of current element of half-wave dipole is 1.76 and 2.15 dB respectively. The directive gain of half-wave dipole over current element will be
3.91 dB
1.95 dB
0.39 dB
0.195 dB

⇒ A dc power supply has no load voltage of 30 V and full load voltage of 25 V at full load current of 1 A. The output resistance and voltage regulation respectively are
5 Ω and 25%
25 Ω and 20%
5 Ω and 16.7%
25 Ω and 16.7%

⇒ The effect of the inductance of a coil on a constant direct current is that
it does not effect the constant direct current
it decreases the current
it strengthens the current
it causes a higher voltage drop

⇒ The inverse response of a system h(n) = aⁿ∪(n) what is the condition for the system to be BIBO stable?
a is real and +ve
a is real and -ve
|a| > 1
|a| < 1

⇒ A switch tail ring counter is made by using a single D FF. The resulting circuit is a
SR FF
JK FF
D FF
T FF