Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Double Rectifier) </th> <th width="5%"></th><th>List II (Number of Diodes) </th></tr><tr><td>A.</td><td>Full wave Bridge rectifier</td><td>1.</td><td>1</td></tr><tr><td>B.</td><td>Half wave rectifier</td><td>2.</td><td>2</td></tr><tr><td>C.</td><td>Full wave rectifier using centre tapped transformer</td><td>3.</td><td>4</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-2, C-3, (B) A-3, B-1, C-2, (C) A-2, B-1, C-3, (D) A-3, B-1, C-2, (E) , Leave your comments or Download question paper.

Question is ⇒ <p>Match the following:</p><table cellpadding="0" cellspacing="0" border="0" class="matching"><tbody><tr><th width="5%"> </th><th>List I (Double Rectifier) </th> <th width="5%"></th><th>List II (Number of Diodes) </th></tr><tr><td>A.</td><td>Full wave Bridge rectifier</td><td>1.</td><td>1</td></tr><tr><td>B.</td><td>Half wave rectifier</td><td>2.</td><td>2</td></tr><tr><td>C.</td><td>Full wave rectifier using centre tapped transformer</td><td>3.</td><td>4</td></tr></tbody></table>, Options are ⇒ (A) A-1, B-2, C-3, (B) A-3, B-1, C-2, (C) A-2, B-1, C-3, (D) A-3, B-1, C-2, (E) , Leave your comments or Download question paper. Previous question Next question

Q1.

Match the following:

	List I (Double Rectifier)		List II (Number of Diodes)
A.	Full wave Bridge rectifier	1.	1
B.	Half wave rectifier	2.	2
C.	Full wave rectifier using centre tapped transformer	3.	4

A-1, B-2, C-3

A-3, B-1, C-2

A-2, B-1, C-3

A-3, B-1, C-2

View Answer 1 -1

Explanation:-
Answer : B
Discuss it below :

!! OOPS Login [Click here] is required to post your answer/result
Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In an amplifier if conductor during the cycle is from 0 to 90° and again from 180° to 270°, the amplifier will be termed as
class A
class B
class C
class AB

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the wave impedance for dominant mode.
130 p
1.3 p
120 p
12 p

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ In the circuit, V_s = 10 cos ωt, power drawn by the 4Ω resistor is 8 watt. The power facto
1
0.5
0.85
0

⇒ If all the LEDs in a seven segment display are turned on, the number displayed is
1
3
0
8

⇒ In an SCR, the anode current consists of
only holes
only electrons
both electrons and holes
either electrons or holes

⇒ Consider the following statements relating to synchros

Rotor of control transformer is either disc shaped or umbrella shaped
Rotor of transmitter has low magnetic reluctance
Transmitter and control transformer pair act as error detector

Out of above the correct statements are
1, 2, 3
1 and 2
2 and 3
1 and 3

⇒ A meter having 0-1000 μA range and 1000 Ω resistance is required to be changed to 0-100 mA meter. The value of shunt resistance is about
1 Ω
10 Ω
99 Ω
100 Ω

⇒ Twelve 1 Ω resistance are used as edges to form a cube. The resistance between two diagonally opposite corners of the cube is
5/6 Ω
1 Ω
6/5 Ω
3/2 Ω

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watts
1 watt
0.1 watt
0.01 watt

⇒ A short circuited stub is shunt connected to a transmission line as shown in the figure is, if z₀ = 500 ohms, the admittance y seen at the function of the stub and the transmission line
(0.01 - j 0.02) mho
(0.02 - j 0.01) mho
(0.04 - j 0.02) mho
(0.02 + j 0) mho

⇒ The characteristic impedance of loss less transmission line is
L/R
L/C
1/LC
C/L

⇒

Match the following:

	List I		List II
A.	Reactance theorem	1.	Foster
B.	Driving point impedance	2.	Bartlett
C.	Continued fraction expansion	3.	Cauer
D.	Bisection Theorem	4.	Positive real function

A-1, B-4, C-3, D-2
A-1, B-2, C-3, D-4
A-2, B-3, C-1, D-4
A-3, B-4, C-2, D-1

⇒ An RC series circuit has R = 20 Ω and X_C = 20 Ω. Then Z =
40 Ω
28.28 Ω
20 Ω
1 Ω

⇒

Match the following:

	List I (Operator)		List II (Description)
A.	? :	1.	Modulus
B.	[ ]	2.	Array expression
C.	%	3.	Conditional

A-3, B-2, C-1
A-1, B-2, C-3
A-1, B-3, C-2
A-2, B-3, C-1

⇒ A mod 4 counter will count
from 0 to 4
from 0 to 3
from any number n to n + 4
none of the above

⇒ The purpose of earthing electric appliances is
to provide safety against shock
to ensure that appliance works satisfactorily
to ensure that appliance gets full voltage
all of the above

⇒ Consider the following statements:

Race around condition can occur in JK flip flop when both inputs are 1
A flip flop is used to store one bit of information
A transparent latch is a D type flip flop
Master slave flip flop is used to store two bits of information

Which of the above are correct?
1, 2, 3
1, 3, 4
1, 2, 4
2, 3, 4

⇒ Which of the following characteristics of a silicon p-n junction diode make it suitable for use as ideal diode?

It has low saturation current.
It has high value of cut in voltage.
It can withstand large reverse voltage.
When compared with germanium diode, silicon diode shows a lower degree of temperature dependence under reverse conditions.

Select the answer using the given below
1 and 2
1, 2, 3, 4
2, 3, 4
1, 3

⇒

Assertion (A): The velocity factor of a line is the ratio of wave velocity on the line to speed of light.

Reason (R): If the conductors of a line are immersed in a non magnetic insulating liquid, the wave velocity increases.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is open loop system?
Wind screen wiper
Aqualing
Respiratory system of animal
System for controlling antirocket missiles

⇒ A JFET operates in ohmic region when
V_GS = 0
V_GS is less than pinch off voltage
V_GS = is Positive
V_GS = V_DS

⇒ In an ac coordinate potentiometer, the currents inphase and quadrature potentiometer are adjusted to be
out of phase by 90°
in phase
out of phase by 45°
out of phase 180°

⇒ The presence of some holes in an intrinsic semiconductor at room temperature is due to
valence electrons
doping
free electrons
thermal energy

⇒ Find the radiation resistance of an antenna of length λ/10 meter?
8 Ω
780 Ω
7.8 Ω
78 Ω

⇒ Which of the following uses a capacitor in the feedback path?
Active low pass filter
Active high pass filter
Both (a) or (b)
Neither (a) nor (b)

⇒ Force = Electric intensity x current.
TRUE
FALSE

⇒ In an R-S latch, race condition occurs when
R is low and S is high
R and S are high
R and S are low
R is high and S is low

⇒ A rhombic antenna is a
resonant antenna
non-resonant antenna
coupled antenna
none of the above

⇒ The use of coaxial microwave line should be restricted to frequencies
below cut off frequency of TE₁₁ mode
above cut off frequency of TE₁₁ mode
at frequencies much lower than cut off frequency of TE₁₁ mode
at frequencies much higher than cut off frequency of TE₁₁ mode