Question is ⇒ PIL tube means, Options are ⇒ (A) Picture in Line Tube, (B) Precision in Line Tube, (C) Pairing in Line Tube, (D) Pattern in Line Tube, (E) , Leave your comments or Download question paper.

Question is ⇒ PIL tube means, Options are ⇒ (A) Picture in Line Tube, (B) Precision in Line Tube, (C) Pairing in Line Tube, (D) Pattern in Line Tube, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	PIL tube means
A.	Picture in Line Tube [Wrong Answer]
B.	Precision in Line Tube [Correct Answer]
C.	Pairing in Line Tube [Wrong Answer]
D.	Pattern in Line Tube [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An arbitrary signal m (t) has zero average value and it is bandlimited to 3.2 kHz. It is sampled at the rate of 8 K samples/S. The samples are passed through an ideal bandpass filter with centre frequency of 32 kHz and bandwidth of 6.4 kHz. The output of band pass filter is
AM-DSB signal with suppressed carrier
AM-DSB signal with carrier
AM-SSB signal with carrier
a sequence of exponentially decaying sine waves

⇒ In a two terminals network the O.C. voltage measured at the given terminals is 100 V and s.c., currents at the same terminals 5 A. If a load of 80 Ω resistance is connected at the terminals, load current is
0.0416666666666667
1.25 A
0.25
6.25 A

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then find the width of major lobe
60
50
51.25
None of the above

⇒ Leak type bias is used in a plate-modulated class C amplifier to
prevent tuned circuit damping
prevent over modulation
increase the bandwidth
prevent excessive grid current

⇒ __________ will have the least value of relative permeability.
Palladium
Silver
Cobalt
Iron

⇒ On load tap changer using thyristors can have a maximum of two taps.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	FM	1.	slope-overload
B.	DM	2.	μ law
C.	PSK	3.	Envelope detector
D.	PCM	4.	Capture effect
		5.	Hilbert transform
		6.	Matched filter.

A-5, B-1, C-6, D-4
A-4, B-6, C-1, D-5
A-4, B-1, C-6, D-2
A-6, B-3, C-4, D-2

⇒ The block diagram of the given figure
On-off controller
On-off controller with differential gap
On-off controller with integral gap
Three position controller

⇒ When we use RRC instruction once in 8085, the number is
multiplied by 2
divided by 2
multiplied by 4
divided by 4

⇒ The mean life time of carrier may range from 10^-9 seconds to hundreds of μ-seconds.
TRUE
FALSE

⇒ In an ac single phase energy meter, the potential coil is put on
both side limbs, of upper magnet
central limb of upper magnet
one side limb of upper magnet
either (a) or (b)

⇒ In measuring resistance using voltmeter and ammeter, the resistances of voltmeter and ammeter also affect the accuracy of measurement.
TRUE
FALSE

⇒ If the drift velocity of holes under a field gradient of 100 V/m is 5m/sec. Their mobility is
0.05
0.5
50
500

⇒ A memory system of size 16 K bytes is required to be designed using memory chips having 12 address lines and 4 data lines-each. The number of such chips required to design and the memory system is :
2
4
8
16

⇒ In case of frequency modulation, modulating voltage remains constant if the modulating frequency is lowered, then
amplitude of distant sidebands decreases
amplitude of distant sidebands increases
amplitude of distant sidebands remains constant
amplitude of distant sidebands first increases, then decreases

⇒ In an amplifier circuit the emitter is at ac ground potential in a
CB circuit
CC circuit
CE circuit
both CB and CE circuit

⇒ In cellphone communication base antennas are connected to other base antennas in
line of sight communication
ionospheric propagation
ground wave propagation
medium wave propagation

⇒ The input impedance for folded dipole antenna (two half dipole) is
73 n²
377 n²
73 n
377 n

⇒ Which one of the following is the correct sequence of the numbers represented in the series given below?
2, 3, 4, 5, 6......
2, 4, 6, 8, 10 .....
2, 4, 6, 10, 12......
2, 4, 6, 10, 16 .....

⇒ Public address systems generally use electret microphones.
TRUE
FALSE

⇒ The typical squelch circuit
cuts off an IF amplifier when the AGC is maximum
cuts off an IF amplifier when the AGC is minimum
cuts off an audio amplifier when the carrier is absent
eliminates the RF interference when the signal is weak

⇒ The resistance of a metallic wire would
increase as the operating frequency increase
decrease as the operating frequency increase
remain unaffected on increasing the operating frequency
first increase then decrease

⇒

Assertion (A): The TTL output acts as a current sink in low state

Reason (R): The TTL input current is largest in low state.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Assertion (A): An electron having charge - e and mass m and lying in an electric field E is subjected to an acceleration - (e/m) E.

Reason (R): If there are n electrons/m³ moving with velocity v_x and each electron has a charge - e, the current density J = - n ev_x.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Negative feedback reduces noise originating at the amplifier input.
TRUE
FALSE

⇒ An 8 bit transistor register has output voltage of low-high-low-high-low-high-low-high. The decimal number stored is
105
95
85
75

⇒ Transformer coil is an insulator.
TRUE
FALSE

⇒ Z_L = 200 Ω and it is desired that Z_i = 50 Ω The quarter wave transformer should have a characteristic impedance of
100 Ω
40 Ω
10000 Ω
4 Ω

⇒ Evaluate the power stored in inductor and capac
25 J, 12.5 J
12.5 J, 25 J
25 J, 50 J
12.5 J, 50 J

⇒ In 8085 microprocessor, how many lines are there in data bus?
6
8
2
16