Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | Pick the odd one out |

A. | PPM [Correct Answer] |

B. | PDM [Wrong Answer] |

C. | PWM [Wrong Answer] |

D. | PLM [Wrong Answer] |

View Answer
Explanation:-
Answer : ADiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Load cell uses

piezoelectric crystal

capacitor

mutual inductance

strain gauge

⇒ When the light falling on a photodiode increases, the reverse minority current

increases

increases or decreases

decreases

remains the same

⇒ For the K map of the given figure the simplified Boolean expressio

AC + A B

A BC + A B C + A B C + AB C

AC + A B + AC

A C + A B + AB

⇒ Consider the following statements

- In 8085 address and data buses are multiplexed.
- In Z 80 address and data buses are multiplexed
- In Z 80 address and data buses are not multiplexed.
- Z 80 has 16 bit address bus and 8 bit data bus.

1 and 2 only

1, 3 and 4 only

1, 2 and 4 only

2 and 4 only

⇒ A full subtractor has a total of

2 inputs

3 inputs

4 inputs

5 inputs

⇒ A noiseless 3 kHz channel can't transmit binary bit at the rate

12000 bps

1000 bps

6000 bps

3000 bps

⇒ An XOR gate with 6 variables is as follows A ⊕ B ⊕ C ⊕ D ⊕ E ⊕ F. The number of minterms in the Boolean expression is

6

12

64

32

⇒ K maps can be drawn

only for 2 variables

only for 3 variables

only for 4 variables

for any number of variables

⇒ The open loop gain of an amplifier is 200. If negative feedback with β = 0.2 is used, the closed loop gain will be

200

40

4.878

1.212

⇒ A meter has a resistance of 1 Ω and full scale deflection current of 1 mA. To convert into an ammeter of 1 A range, the shunt resistance should be

1000 Ω

1 Ω

0.01 Ω

0.001 Ω

⇒ The op amp is used in

A/D converters

D/A converters

both (a) and (b)

shift registers

⇒ A receiver having poor IF selectivity will also have poor

sensitivity

double spotting

blocking

all of the above

⇒ Which of them contains an organic fluid?

LED

LCD

Both LED and LCD

Neither LED nor LCD

⇒ If the energy is supplied from a source, whose resistance is 1 ohm, to a load of 100 ohms the source will be

a voltage source

a current source

both of the above

none of the above

⇒ In a three phase series inverter, the firing frequency is

three times output frequency

six times output frequency

twice the output frequency

equal to output frequency

⇒ A DAC has full scale output of 5 V. If accuracy is ± 0.2% the maximum error for an output of 1 V is

5 mV

10 mV

2 mV

20 mV

⇒ The output

*y*(

*t*) of a continuous-time system

*S*for the input

*x*(

*t*) is given

S is linear and time-invariant

S is linear and time-varying

S is non-linear and time-invariant

S is non-linear and time-varying

⇒ A heavily doped semiconductor exhibits a __________ such a device is called sensistors.

negative temperature coefficient of resistance

positive temperature coefficient of resistance till a particular value of temperature and then it shown negative temperature coefficient of resistance

positive temperature coefficient of resistance

none of the above

⇒

**Assertion (A):** When *p*-*n* junction is forward biased, steady current flows.

**Reason (R):** When a *p*-*n* junction is forward biased, free electrons cross the junction from *n* to *p* and holes from *p* to *n*.

Both A and R are true and R is correct explanation of A

Both A and R are true but R is not a correct explanation of A

A is true but R is false

A is false but R is true

⇒ In an home T.V. receiver, the leed in from the antenna is

coaxial cable of 75 Ω

ordinary twisted wire

bar copper wire

twin wire

⇒ The filter circuit for feeding tweeter has

an inductance in series and a capacitance in parallel

a capacitance in series and an inductance in parallel

a resistance in series and a capacitance in parallel

a capacitance in series and a resistance in parallel

⇒ Quantization noise occurs in

PAM

DM

PWM

PPM

⇒ The number of inputs and outputs of a full adder are

3 and 2 respectively

2 and 3 respectively

4 and 2 respectively

2 and 4 respectively

⇒ For a transfer function the coefficients of the numerator and denominator polynomials in s must be real.

TRUE

FALSE

⇒ The time constant of the capacitance circuit is defined as the time during which voltage

falls to 36.8% of its final steady value

rises to 38.6% of its final steady value

rises to 63.2% of its final steady value.

none of the above.

⇒ In the given figure R

_{C}= R

_{L}= 1 kΩ, then V

_{05 V2.5 V1 V0 V}

⇒ If the sign bit of mantissa is 0 and the exponent is increased from a positive to a more negative number the result is

a larger floating point number

a smaller floating point number

either (a) or (b) depending on the actual number

a negative floating point number

⇒ Which of the following conditions must be satisfied for a transistor to remain under saturation?

- Its collector to base junction should be under forward bias.
- Its collector to base junction should be under reverse bias.
- Its emitter to base junction should be under reverse bias.
- Its emitter to base junction should be under forward bias.

1 and 2

1 and 3

2 and 3

1 and 4

⇒ A(A + B) =

A

A B

AB

AB

⇒ A (0.75 -

*j*50) ohm load is connected to a coaxial transmission line of Z

_{0}= 75 ohms at a frequency of 10 GHz Which of the following will be the best method of matching?

Connecting an inductance at the end

Connecting a short circuited stub at the load

Connecting a capacitance at some distance from the load

Connecting a short circuited stub at some specified distance from the load