Question is ⇒ Pick out the wrong unit conversion., Options are ⇒ (A) 1 atm. = 760 mm Hg = 29.92 inch Hg = 14.7 psi = 1.013 bar = 1.013 kgf/cm<sup>2</sup>, (B) 1 kPa = 100 bar, (C) 1 mm Hg = 1 torr = 133.3 Pa, (D) -, (E) , Leave your comments or Download question paper.

Question is ⇒ Pick out the wrong unit conversion., Options are ⇒ (A) 1 atm. = 760 mm Hg = 29.92 inch Hg = 14.7 psi = 1.013 bar = 1.013 kgf/cm<sup>2</sup>, (B) 1 kPa = 100 bar, (C) 1 mm Hg = 1 torr = 133.3 Pa, (D) -, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Pick out the wrong unit conversion.
A.	1 atm. = 760 mm Hg = 29.92 inch Hg = 14.7 psi = 1.013 bar = 1.013 kgf/cm² [Wrong Answer]
B.	1 kPa = 100 bar [Correct Answer]
C.	1 mm Hg = 1 torr = 133.3 Pa [Wrong Answer]
D.	- [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ 1 torr is equivalent to
1 mm Hg
1 Pascal
1 ata
1 mm wc

⇒ Refluxing of part of the distillate in a fractionating column is a 'recycling operation', aimed primarily at
heat conservation.
yield enhancement.
product enrichment.
none of these.

⇒ Assume that benzene is insoluble in water. The normal boiling points of benzene and water are 80.1 and 100°C respectively. At a pressure of 1 atm, the boiling point of a mixture of benzene and water is
80.1°C.
less than 80.1°C.
100°C.
greater than 80.1°C but less than 100°C.

⇒ The vapour pressure of water is given by, in P_sat = A - (5000/T), where A is a constant, Psat is the vapour pressure in atm. and T is the temperature in K.The vapor pressure of water in atm. at 50°C is approximately
0.07
0.09
0.11
0.13

⇒ Pure aniline is evaporating through a stagnant air film of 1 mm thickness at 300 K and a total pressure of 100 KPa. The vapor pressure of aniline at 300 K is 0.1 KPa. The total molar concentration under these conditions is 40.1 mole/m³ . The diffusivity of aniline in air is 0.74xl0^-5m²/s.The numerical value of mass transfer co-efficient is 7.4 x 10^-3. The rate of evaporation of aniline is 2.97 x 10^-4. Its units are
mole/s
mole/cm². s
mole/m² . s
kmole/m² . s

⇒ In a neutral solution
H⁺ ions are absent.
OH^- ions are absent.
both H⁺ and OH^- ions are present in very small but equal concentration.
none of these.

⇒ Pick out the wrong unit conversion of heat transfer rate.
1 kcal/hr= 1.163 Watt.
1 Watt = 1.163 kcal/hr.
1 BTU/ft².hr = 2.712 kcal/m².hr.
1 kcal/m².hr = 0.3687 BTU/ft².hr = 1.163 Watt/m².

⇒ One Newton is equal to __________ dynes.
10²
10³
10⁴
10⁵

⇒ At what temperature, given mass of a gas that occupies a volume of 2 litres at N.T.P. will occupy a volume of 4 litres, if the pressure of the gas is kept constant ?
273°C
273°K
100°C
200°C

⇒ Boiling point of a non-homogeneous mixture of immiscible liquids is __________ that of any one of its separate components.
lower than
higher than
equal to
either (a) or (b); depends on the liquids

⇒ Unrestrained expansion of an ideal gas does not result in its cooling due to the reason that the gas molecules
do not lose energy on collision.
are above the inversion temperature.
do not exert attractive force on each other.
do work equal to loss in kinetic energy.

⇒ The increase in the temperature of the aqueous solution will result in decrease of its
weight % of the solute.
mole fraction of the solute.
molarity.
molality.

⇒ An azeotropic solution of two liquids has boiling point lower than either of them, when it
is saturated.
is unsaturated.
shows negative deviation from Raoult's law.
shows positive deviation from Raoult's law.

⇒ Methane is mixed with stoichiometric proportion of oxygen and completely combusted. The number of additional specifications required to determine the product flow rate and composition is
0
1
2
3

⇒ An ideal gas can be liquified, because
its molecular size is very small.
its critical temperature is more than 0°C.
forces operative between its molecules are negligible.
it gets solidified directly without becoming liquid.

⇒ PH value of a solution containing 1 gm of hydrogen ion per litre will be
0
1
7
10

⇒ At 100°C, water and methylcyclohexane both have vapour pressures of 1 atm. Also at 100°C, the latent heats of vaporisation of these compounds are 40.63 kJ/mole for water and 31.55 kJ/mole for methylcyclohexane. The vapour pressure of water at 150°C is 4.69 atm. At 150°C, the vapour pressure of methylcyclohexane would be expected to be
significantly less than 4.69 atm.
nearly equal to 4.69 atm.
significantly more than 4.69 atm.
indeterminate due to lack of data

⇒ For any system, the __________ heat of solution is dependent on the temperature and the adsorbate concentration.
integral
differential
both (a) & (b)
neither (a) nor (b)

⇒ Boiling point of a solution as compared to that of the corresponding solvent is
less
more
same
either more or less; depends upon the solvent

⇒ Disappearance of snow in subzero weather exemplifies the process of
evaporation
sublimation
vaporisation
melting

⇒ Pick out the wrong unit conversion.
1 atm. = 760 mm Hg = 29.92 inch Hg = 14.7 psi = 1.013 bar = 1.013 kgf/cm²
1 kPa = 100 bar
1 mm Hg = 1 torr = 133.3 Pa
-

⇒ At higher temperature, molal heat capacities of most of the gases (at constant pressure) __________ with increase in temperature.
increases
decreases
remains unchanged
increases linearly

⇒ The percentage ratio of the partial pressure of the vapor to the vapor pressure of the liquid at the existing temperature is
termed as relative saturation.
not a function of the composition of gas mixture.
called percentage saturation.
not a function of the nature of vapor.

⇒ 80 kg of Na₂SO₄ (molecular weight = 142) is present in 330 kg of an aqueous solution. The solution is cooled such that. 80 kg of Na₂SO₄ .10H₂O crystals separate out. The weight fraction of Na₂SO₄ in the remaining solution is
0
0.18
0.24
1

⇒ How much O₂ can be obtained from 90 kg of water ?
32 kg
80 kg
64 kg
90 kg

⇒ In case of a solution (not of a solid in a liquid), whose total volume is more than the sum of volumes of its components in their pure states, solubility is
independent of the temperature.
increased with the increase in pressure.
decreased with the increase in pressure.
unchanged by the pressure change.

⇒ The molecules of a liquid which is in equilibrium with its vapor at its boiling point on an average have equal __________ in the two phases.
potential energy
intermolecular forces
kinetic energy
total energy

⇒ Heat of reaction is not influenced by
the route/method through which final products are obtained.
the physical state (e.g., solid, liquid or gaseous) of reactants and products.
whether the reaction is carried out at constant temperature or constant pressure.
none of these.

⇒ Solutions which distil without change in composition are called
ideal
saturated
supersaturated
azeotropic

⇒ The pressure under which liquid and vapor can co-exit at equilibrium is called the __________ vapor pressure.
limiting
real
saturated
normal