Question is ⇒ Photoconductive devices uses, Options are ⇒ (A) metallic conductors, (B) good quality insulators, (C) semiconductors, (D) either (a) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ Photoconductive devices uses, Options are ⇒ (A) metallic conductors, (B) good quality insulators, (C) semiconductors, (D) either (a) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Photoconductive devices uses
A.	metallic conductors [Wrong Answer]
B.	good quality insulators [Wrong Answer]
C.	semiconductors [Correct Answer]
D.	either (a) or (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following configuration has low thermal stability?
CB
CC
CE
All have identical thermal stability

⇒ The bandwidth required for amplitude modulation is
half the frequency of modulating signal
equal to the frequency of modulating signal
twice the frequency of modulating signal
four times the frequency of modulating signal

⇒ A signal m(t) is multiplied by a sinusoidal waveform of frequency f_c such
0.5 M(f + f_c)
0.5 M(f - f_c)
0.5 M(f + f_c) + 0.5 M(f - f_c)
0.5 M(f - f_c) + 0.5 M(f - f_c)

⇒ A blank EPROM has
all bits set to logical 0
all bits set to logical 1
half the total number of bits set to 0 and remaining half to logical 1
either (a) or (b)

⇒ Without any addition circuitry, an 8:1 MUX can be used to obtain.
some but not all Boolean functions of 3 variables
all functions of 3 variables but none of 4 variables
all functions of 3 variables and some but not all of 4 variables
all functions of 4 variables

⇒ Which of these instruments has highest power consumption?
Dynamometer
Electrostatic
Moving coil
Hot wire

⇒ The P-type substrate in a conventional pn Junction isolated integrated circuits should be connected to
any where
a dc ground potential
the most positive potential available in the circuit
the most negative potential available in the circuit

⇒ A source of angular frequency 1 rad sec has a source impedance consisting of 1 Ω resistance in series with 1 H inductance. The load that will obtained the maximum power transfer is
1 Ω resistance
1 Ω resistance in parallel with 1 H inductance
1 Ω resistance in series with 1 F capacitor
1 Ω resistance in parallel with 1 F capacitor

⇒ In a JFET
the source gate junction is forward biased and gate drain junction is reverse biased
both the junctions are forward biased
both the junctions are reverse biased
the source gate junction is reverse biased and gate drain junction is forward biased

⇒ A JK flip flop can be converted to D flip flop by
Connecting both J and K terminals to D
Connecting J terminal to D and leaving K open
Connecting K terminal to D and leaving J open
Connecting J terminal to D and K terminal to D through an inverter

⇒ 9's complement of 56₁₀ is
43₁₀
84₁₀
65₁₀
53₁₀

⇒ In each of circuits below, indicate which diode is conduct
Figure A
Figure B
Figure C
All the three

⇒ h parameters are used in transistor analysis.
TRUE
FALSE

⇒ Assume that x = 7, the Java operation x = x - means that final value of x is
7
-1
6
-6

⇒ For Disk partitioning th DOS command is
F DISK
H DISK
A DISK
D DISK

⇒ The Z transform of a particular signal is given
non causal and stable
causal and stable
unstable and noncausal
can't say

⇒

Assertion (A): In the interaction region of magnetron an electron is subjected to three forces: force due to electric field, force due to magnetic field and centrifugal force.

Reason (R): The mechanism of generation of microwaves, in a magnetron, involves interaction of electromagnetic fields with electrons moving in static electric and magnetic fields oriented at right angles to each other.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The effect of earth's magnetic field on radiowaves is minimum when
the electric field lines of radio waves and flux line of earth's magnetic field are in the same direction
the electric field lines of radio waves and flux lines of earth's magnetic field are at right angles
the electric field lines of radiowaves and flux lines of earth's magnetic field oppose each other
both (b) and (c)

⇒ The number of spectral component when two sine wave of same frequency multiplied is
2
3
∞
4

⇒

Match the following:

	List I (type of controller)		List II (Operation)
A.	Pneumatic controller	1.	Flexible operation
B.	Hydraulic controller	2.	High torque high speed operation
C.	Electronic controller	3.	Fire and explosion proof operation

A-1, B-3, C-2
A-1, B-2, C-3
A-3, B-1, C-2
A-3, B-2, C-1

⇒ Which of the following devices is used in the microprocessors?
JFET
BJT
MOSFET
CMOS

⇒ For AB + A C + BC = AB + A C the dual form is
(A + B) (A + C)(B + C) = (A + B)(A + C)
(A + B ) (A + C)(B + C) = (A + B)(A + C)
(A + B) (A + C) (B + C) = (A + B) (A + C)
none of the above

⇒ For a depletion type NMOS, V_p = - 4 volts. For V_GS = 0, 1_D = 16 mA in the pinch off region of V_DS. For V_GS = - 2, the value of I_D in the pinch off region of V_DS is given by
64 mA
32 mA
16 mA
4 mA

⇒ An end fire array consisting of several half-wave lengths of directive gain 40, then Find width of major lobe for broadside
6°
5.73
51.25
0°

⇒ The gradient of any scalar field always yields __________ .
a solenoidal field
a conservative field
an irrotational field
none of these

⇒ In a reactance function
all poles are simple
all poles and zeros are simple
all poles and zeros are simple and lie on jω axis only
all poles and zeros lie on negative real axis

⇒ In a three variable K map four adjacent cells give
single variable term
two variable term
three variable term
either (a) or (b)

⇒ In a single phase full wave controlled rectifier using centre tap transformer, the voltage across each half of secondary is V_m sin ωt. The peak inverse voltage is
2 V_m
V_m
0.5 V_m
0.25 V_m

⇒ In a CE amplifier the dc load line is the same as ac load line when
ac collector resistance and dc collector resistance are equal
ac collector resistance and dc emitter resistance are equal
ac collector resistance is very high
ac collector resistance is one half of dc collector resistance

⇒ In a 4 input OR gate, the total number of High outputs for the 16 input states are
16
15
14
13