Question is ⇒ Assertion (A): The trigger circuit of a CRO is excited by the same signal as Y plates.Reason (R): The time base generator develops a saw tooth voltage., Options are ⇒ (A) Both A and R are true and R is correct explanation of A, (B) Both A and R are true but R is not correct explanation of A, (C) A is true R is false, (D) A is false R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): The trigger circuit of a CRO is excited by the same signal as Y plates.Reason (R): The time base generator develops a saw tooth voltage., Options are ⇒ (A) Both A and R are true and R is correct explanation of A, (B) Both A and R are true but R is not correct explanation of A, (C) A is true R is false, (D) A is false R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): The trigger circuit of a CRO is excited by the same signal as Y plates. Reason (R): The time base generator develops a saw tooth voltage.
A.	Both A and R are true and R is correct explanation of A [Wrong Answer]
B.	Both A and R are true but R is not correct explanation of A [Correct Answer]
C.	A is true R is false [Wrong Answer]
D.	A is false R is true [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The given figure shows dB magnitude plots for type 0, type 1 and type 2 systems. Out of t
curves 1, 2, 3 are for type 0, 1, 2 systems respectively
curves 1, 2, 3 are for type 2, 1, 0 systems respectively
curves 1, 2, 3 are for type 1, 0, 2 systems respectively
curves 1, 2, 3 are for type 1, 2, 0 systems respectively

⇒ Which of the following is best suited for parity checking and parity generation?
AND, OR, NOT gates
XOR, Exclusive NOR gate
NAND gates
NOR gates

⇒ Two ammeters A and B both 0-10 A have internal resistance of 1 Ω and 0.5 Ω respectively. They are connected in parallel. If total current is 15 A, then
I_A = I_B = 7.5 A
I_A = 5 A, I_B = 10 A
I_A = 10 A, I_B = 5 A
I_A = 9 A, I_B = 6 A

⇒ Calculate the conductivity of pure silicon at room temperature when the concentration of carriers is 1.6 x 10¹⁰ per cm³. Take μ_e = 1500 cm²/V-sec, μ_h = 500 cm²/V-sec at room temperature,
5.12 x 10^-16
5 x 10⁺¹⁶
10¹⁶
5 x 10²⁰

⇒ The boundary conditions at the interface between two dielectrics in an electric field are given by
D_normal = 0, E_tangential = 0
D_normal = 0, E_normal = 0
D_tangential = 0, E_tangential = 0
D_tangential = 0, E_normal = 0

⇒ In a transistor which of the following region is very lightly doped and is very thin?
Emitter
Base
Collector
None of the above

⇒

Match the following:

	List I		List II
A.	shift Register	1.	Frequency division
B.	Counter	2.	Addressing in memory chips
C.	Decoder	3.	Serial to parallel Data conversion

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-1, C-3
A-1, B-2, C-2

⇒ The transistor of following figure in Si diode with a base current of 40 μA and I_CBO = 0, if V_BB = 6V, R_E = 2 kΩ and β = 90, I_BQ = 20 μA then I_{EQ1800 μA
180 μA
2000 μA
3000 μA}

⇒ Consider the following statements

In a pulsed radar, the transmitted pulses are of high frequency
In a pulsed radar, the transmitted pulses are of high power
In a pulsed radar, the transmitted pulses are of brief duration
In a pulsed radar, the transmitted pulses are of square wave shape.

Of the above statements the correct statements are
1 only
1, 2 and 3 only
1, 2, 3, 4
1 and 3 only

⇒ If the secondary burden of a CT 15 VA and secondary current is 5 A, the load impedance of CT is
0.6 Ω
5 Ω
6 Ω
10 Ω

⇒ In the circuit of figure both diodes are ideal. If v₁ = 10 V and v₂ = 10 V which diode will cond
D₁ only
D₂ only
Both D₁ and D₂
Neither D₁ nor D₂

⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The voltage multiplication is
25
50
125
250

⇒ The fourier transform of a voltage signal x(t) is X(f). The unit of X(f) is __________ .
volts
volt²
volt/sec
volt-sec

⇒ The radiation pattern of a parabola antenna is
omnidirectional
a figure of directional
highly directional
none of the above

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒

Assertion (A): PIN diode is commonly used for microwave control.

Reason (R): A PIN diode uses heavily doped p and n materials.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ If f(t) = 1, F(jω) = 2p δ(ω).
TRUE
FALSE

⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
7.07 mA and 70.7 V
70.7 mA and 70.7 V
0.707 mA and 70.7 V
7.07 mA and 70.7 x 10³ V

⇒

Assertion (A): Power transistor has lower switching time than SCR

Reason (R): Power transistor has greater switching time than SCR

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ For TE or TM modes of propagation in bounded media, the phase velocity is
independent of frequency
is a linear function of frequency
is a non-linear function of frequency
can be frequency dependent or frequency independent on the source

⇒ A function f(t) = k e^at is __________ for (a > 0).
stable
unstable
marginal
none

⇒ The directive gain of λ/2 resonant wire is 1.64.
TRUE
FALSE

⇒ Schmitt trigger can be used as a
comparator
square-wave generator
flip-flop
all of these

⇒ In figure, the current
0.0416666666666667
0.0833333333333333
0.166666666666667
0.333333333333333

⇒ The content of which of the following determines the state of the CPU at the end of the execute cycle (when the interrupt is recognized)?

Program counter
Processor register
Certain status conditions

Select the correct answer using the codes given below :
1 and 2
2 and 3
1 and 3
1, 2 and 3

⇒ With increase in temperature, the electrical conductivity would
increase in metals as well as in intrinsic semiconductor
increase in metals but decrease in intrinsic semiconductor
decrease in metals but increase in intrinsic semiconductor
decrease in metals as well as in intrinsic semiconductor

⇒ A digital voltmeter has a 4 1/2 digit display. The 1 V range can measure voltage up to
0.9999 V
1.9999 V
0.199 V
9.999 V

⇒ A cascade amplifier stage is equivalent to
a common emitter stage followed by a common stage
a common base stage followed by an emitter follower
an emitter follower stage followed by a common base stage
a common base stage followed by a common emitter stage

⇒ In a square law modulator, the carrier frequency should be __________ times than the highest modulating frequency.
1
2
4
3

⇒ The circuit in figure is
resonant commutation
self commutation
load commutation
auxiliary commutation