Question is ⇒ Assertion (A): The response of a network to an impluse is determined only by the parameters of the network.Reason (R): If f(t) is a unit parabolic function, its Laplace transform is 1/s3, Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): The response of a network to an impluse is determined only by the parameters of the network.Reason (R): If f(t) is a unit parabolic function, its Laplace transform is 1/s3, Options are ⇒ (A) Both A and R are correct and R is correct explanation of A, (B) Both A and R are correct but R is not correct explanation of A, (C) A is true, R is false, (D) A is false, R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): The response of a network to an impluse is determined only by the parameters of the network. Reason (R): If f(t) is a unit parabolic function, its Laplace transform is 1/s³
A.	Both A and R are correct and R is correct explanation of A [Wrong Answer]
B.	Both A and R are correct but R is not correct explanation of A [Correct Answer]
C.	A is true, R is false [Wrong Answer]
D.	A is false, R is true [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which amplifier will be preferred for highest gain?
Darlington's pair
Single stage amplifier
Cascade amplifier
Depends on the circuitry

⇒ A unit step function is used to represent the closing a switch in a constant voltage system.
TRUE
FALSE

⇒ In a single phase full wave ac regulator feeding R-L load, the gate pulses
are always of short duration
may be of short duration
should be rectangular with width (p - a)
cannot be rectangular with width (p - a)

⇒ A lead compensator is basically a
high pass filter
low pass filter
band stop filter
none of the above

⇒ MICR stands for
Magnetic Ink Chart Receipt
Magnetic Ink Character Recognition
Magnetic Ink Chart Recognition
Magnetic Ink Character Receipt

⇒ In all base driver amplifiers
ac collector voltage is 180° out of phase with ac base voltage
ac emitter voltage is 180° out of phase with ac base voltage
ac collector voltage is in phase with ac base voltage
none of the above

⇒ In figure the total inductance of the circui
L₁ + L₂
L₁ + L₂ + M
L₁ + L₂ + 2M
L₁ + L₂ + M

⇒ For most static RAM the maximum access time is about
1 ns
10 ns
100 ns
1 μs

⇒ Which of the following statements regarding two transistor model of p-n-n-p device is correct?
It explain only the turn on portion of the device characteristics
It explain only the turn off portion of the device characteristics
It explain only the negative region portion of the device characteristics
It explain all the regions of the device characteristics

⇒ Laplace transform of unit doublet is
1/s
s²
s
none

⇒ In a linear op-amp circuit
the product of gain and bandwidth is constant
input can be dc only
input can be ac only
saturation may occur

⇒ For a bit rate of 8 kbps, the best possible values of the transmitted frequencies in a coherent binary FSK system are
16 kHz and 20 kHz
20 kHz and 32 kHz
20 kHz and 40 kHz
32 kHz and 40 kHz

⇒ In a loss-free R-L-C circuit the transient current is
oscillating
square wave
sinusoidal
non-oscillating

⇒ Microwaves are used for
telephony
radio broadcast
TV systems
all of the above

⇒ An 8-bit microprocessor has 16 bit address bus A₀ - A₁₅. The processor addresses a 1-K byte memory chip as shown. The address range for the chi
(F00F)_H TO (F40E)_H
(F000)_H TO (F3FF)_H
(F100)_H TO (F4FF)_H
(F700)_H TO (FAFF)_H

⇒ In which mode of BJT operation are both junctions reverse biased?
Active
Saturation
Cut off
Reverse active

⇒ For representing two sinusoidal voltages on a phasor diagram
Both voltages must be of the same frequency
Both voltages must be sinusoidal but may be of different frequencies
One of the voltages must be of 50 Hz
The frequency of one must be integral of that of other

⇒ Accumulator is an 8 bit register and is also known as register B.
TRUE
FALSE

⇒ Which mode is called dominant mode in rectangular wave guide?
TE₀₁
TE₁₁
TE₁₀
TE₂₀

⇒ Which of the following has the highest input impedance?
CE
CB
CC
Push pull

⇒ For input and later stages, BI-FET op-amp use
JFETs and MOSFETs respectively
MOSFETs and JFETs respectively
JFETs and BJTs respectively
BJTs and JFETs respectively

⇒ A moving iron voltmeter reads 250 V when connected to 250 V dc. If connected to 250 V 50 Hz, the voltmeter reading is likely to be
250 V
252 V
248 V
210 V

⇒ The gain of an antenna with a circular aperture of diameter 3 metres at a frequency of 5 GHz, will be
2.4674
24.674
246.74
24674

⇒ In the circuit shown below, the op-amp is ideal, the transistor has V_BE = 0.6 V and β = 150. Decide whether the feedback in the circuit is positive or negative and determine the voltage V at the output of the op
Positive feedback, V = 10 V
Positive feedback, V = 0 V
Negative feedback, V = 5 V
Negative feedback, V = 2 V

⇒ The characteristic impedance of a twin wire feeder used for TV signals is about
1000 ohm
500 ohm
300 ohm
100 ohm

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒ In each of circuits below, indicate which diode is conduct
Figure A
Figure B
Figure C
All the three

⇒ MS outlook is a software for DTP.
TRUE
FALSE

⇒

Assertion (A): In Hall effect the O.C. transverse voltage developed by a current carrying semiconductor with a steady magnetic field perpendicular to the current direction has opposite signs for n and p semiconductors.

Reason (R): The magnetic field pushes both holes and electrons in the same direction.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Identification of highest priority interrupt can be achieved in a minimum time by which of the following schemes?
Hardwired polling
Priority encode circuit
Software polling
Subdivision of interrupt register into a number of sub registers which are checked parallely